display PEUGEOT 607 2007 Owners Manual

Page 14 of 187

FAMILIARISATION
This enables the vehicle to maintain
a constant speed programmed by the
driver.

1. Selection/Switching off of the
function.

2. Storing of a speed/Decreasing of
the stored speed.

3. Storing of a speed/Increasing of the
stored speed.

4. Deactivation/Recalling of the stored
speed.

In order for it to be stored, the vehicle
speed must be above 25 mph (40 km/h),
with at least fourth gear engaged on the
manual gearbox (second gear on the
automatic gearbox).
This prevents the vehicle from exceeding
the speed programmed by the driver
(minimum speed 20 mph (30 km/h)).

1. Selection/Switching off of the
function.

2. Decreasing of the speed.

3. Increasing of the speed.

4. Activation/Deactivation of the
system.
Adjustments must be made with the
engine running.

 92
 93
Cruise control
Instrument panel display
The cruise control or speed limiter mode
appears on the instrument panel when
it is selected.
Speed limiter
Cruise control Speed limiter

Page 15 of 187

FAMILIARISATION
"Porsche Tiptronic System"
automatic gearbox Indication on the instrument
panel display

 95
Visual and audible rear and/or
front parking assistance
Switching the engine on
With the handbrake applied, select
position P or N .
Switch on the ignition.
Moving off
With the engine running, from position

P or N , with your foot on the brake,
release the handbrake .
Select position R , D or M .
Release the brake pedal gradually; the
vehicle moves off immediately.

 89
A. Activation of the rear assistance.

B. Detection.

C. Deactivation/Reactivation.
During parking manoeuvres, you are
guided by an audible signal and a
graphic on the multifunction display.

1. Gear lever.

2. "SPORT" button.

P: Park.

R: Reverse.

N: Neutral.

D: Drive.

M: Manual mode.

S: Sport programme.

1 2 3 4 5 6: gears engaged.
Move the lever in the gate to select one
of the positions.
Once the position has been selected,
the corresponding indicator light is
displayed on the instrument panel
display.

Page 19 of 187

1
22
Seat belt not fastened/
unfastened warning light
With the vehicle stationary,
when the ignition is switched
on, the warning light comes
on if the driver and/or the front
passenger has not fastened his seat belt.
From approximately 12 mph (20 km/h)
and for two minutes, the warning light
l ashes accompanied by an increas-
ingly loud audible signal. Once these
two minutes have elapsed, the warn-
ing light remains on until the driver or
front passenger fastens his seat belt.
When the vehicle is moving, the warn-
ing light comes on if the driver or one
of the front or rear passengers unfas-
tens his seat belt.
Diesel engine pre-heating
warning light
If the temperature is sufi -
cient, the warning light does
not come on and you can
start without waiting.
If the warning light comes on, wait
until it goes out before operating the
starter.
If no malfunction has been
detected: the CHECK OK
indicator light comes on af-
ter two seconds (following a
black screen), in the absence
of indicator lights showing the status
of vehicle functions. If these indicator
lights are present, the CHECK OK in-
dicator light will come on after these.

You may start your vehicle.

If a "minor" malfunction has been
detected: the warning light for the
faulty function comes on. Certain in-
dicator lights showing the status of
vehicle functions may also come on,
followed by the CHECK OK indicator
light.

You can start your vehicle; however,
contact a PEUGEOT dealer as soon
as possible.

If a "major" malfunction has been
detected: the corresponding warning
light comes on. Certain indicator lights
showing the status of vehicle functions
may also come on. The CHECK OK
indicator light does not come on.

Do not start your vehicle.
Contact a PEUGEOT dealer. Following this, the following
information appears on the
instrument panel display:
The engine oil level appears for ap-
proximately 7 seconds; at the same
time, the service indicator appears on
the display located in the speedometer
dial for approximately 7 seconds.
Then, the status of the tyre pressures is
indicated for approximately 5 seconds.
With the ignition on, the vehicle
carries out an automatic
test which appears on the
instrument panel display:

Page 20 of 187

1
23
Manual test of the vehicle Entering CHECK mode
indicator light
This comes on following
pressing of the
"CHECK"
button.
Exiting CHECK mode
indicator light
This comes on at the end of
the CHECK mode. With the engine running
and the vehicle moving, the
instrument panel display
temporarily shows:
- warning lights, when a fault occurs,
- vehicle function status indicator
lights, when a change occurs.

The display of certain warning lights
may be accompanied by an audible
signal and a message on the multi-
function display.

 Press the "CHECK" button on the
instrument panel.
You can start a test of the vehicle man-
ually, at any time, with the ignition on,
engine running or vehicle moving.
This enables you to know:
- the warnings present,
- the status of the functions which can be activated or deactivated (au-
tomatic wipers, automatic switching
on of the lights, ESP, ...).
The associated warning lights are
displayed in succession on the instru-
ment panel display.
If a warning or a change of status oc-
curs during the CHECK mode, the
corresponding warning light(s) are
displayed during this mode and the

CHECK will cease .

Page 30 of 187

1
32
INSTRUMENT PANEL DISPLAY SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero re-
set. It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last service.

Note: the distance remaining before
the next service is due may be weight-
ed by the time factor.
The service information appears on
the display, located in the speedo-me-
ter dial, at the same time as the en-
gine oil level on the instrument panel
display. Operation
As soon as the ignition is switched on
and for 7 seconds, the spanner sym-
bolising the servicing operations is lit.
The trip recorder display shows the
distance remaining (in round i gures)
before the next service.

Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 7 seconds
the display indicates:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total and trip distances.
After switching on the ignition, two
functions are shown in succession:
- service indicator,
- total distance recorder (total and
trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening the
driver’s door, as well as on locking and
unlocking the vehicle.

Page 31 of 187

1
32
INSTRUMENT PANEL DISPLAY SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the manu-
facturer's servicing schedule.
The point at which the service is due is
calculated from the last indicator zero re-
set. It is determined by two parameters:
- the distance travelled,
- the time elapsed since the last service.

Note: the distance remaining before
the next service is due may be weight-
ed by the time factor.
The service information appears on
the display, located in the speedo-me-
ter dial, at the same time as the en-
gine oil level on the instrument panel
display. Operation
As soon as the ignition is switched on
and for 7 seconds, the spanner sym-
bolising the servicing operations is lit.
The trip recorder display shows the
distance remaining (in round i gures)
before the next service.

Example: 4,800 miles/km remain be-
fore the next service is due. When the
ignition comes on and for 7 seconds
the display indicates:
7 seconds after the ignition is switched
on, the total distance recorder resumes
normal operation and the display
shows the total and trip distances.
After switching on the ignition, two
functions are shown in succession:
- service indicator,
- total distance recorder (total and
trip distances).

Note: the total and trip distances are
displayed for 30 seconds when the
ignition is switched off, on opening the
driver’s door, as well as on locking and
unlocking the vehicle.

Page 37 of 187

1
37
Warnings log
This summarises the active warning
messages, displaying them on the
multifunction display in succession.
Status of the functions
This summarises the active or inactive
status of the functions present on the
vehicle.
Inputting the distance remaining to
be travelled
When guidance is not activated, this
enables you to enter an approximate
distance to the i nal destination.
Access via the general menu
C screen
DT screen
"TRIP" menu
Press the "MENU" or "TRIP" button
to gain access to the general menu.
Select the "Trip computer" applica-
tion using the navigator, then coni rm.
The "Trip computer" menu offers
various options:
- Inputting of the distance to be travelled,
- Warnings log,
- Status of the functions. The different trip computer data also
appears on the instrument panel dis-
play at the same time.
Indication on the instrument
panel display

Page 38 of 187

2
38
COLOUR SCREEN C
This displays the following information,
via the RD4 audio equipment control
pad:
- the time,
- the date,
- the exterior temperature (the value displayed l ashes if there is a risk
of ice),
- the accesses check,
- the vehicle functions warning or status messages, displayed tem-
porarily,
- the audio sources displays,
- the trip computer displays,
- the personalisation and coni gura- tion displays,
- the hands-free kit displays. Management of the displays
General menu
Press the
"MENU" button to gain
access to the general menu and
select one of the following functions:
- "Audio functions",
- "Trip computer",
- "Personalisation-Coni guration",
- "Telephone".

Example: "Audio functions" "Personalisation-Coni guration"
menu
This provides access to successive
coni rmation windows .
Dei ning the vehicle parameters
This enables you to activate or
deactivate certain driving and comfort
elements:
- "Automatic switching on of the
lights",
- "Follow-me-home lighting" and "Duration",
- "Remote control action",
- "Permanent locking of the boot".
The
"AUDIO" , "TRIP" and "TEL"
buttons on the RD4 audio equipment
control pad permit displaying in the
main window.

Example: "TRIP"

Example: "Automatic switching on of
the lights"

Page 40 of 187

2
40
DT COLOUR AND MAP
SCREEN
This displays the following informa-
tion, via the RT3 GPS audio/telephone
control pad:
- the time,
- the date,
- the exterior temperature (the value displayed l ashes if there is a risk
of ice),
- the accesses check,
- the vehicle functions warning or status messages, displayed tem-
porarily,
- the audio sources displays,
- the telematic systems displays (telephone, services, ...),
- the trip computer displays,
- the coni guration displays,
- the satellite navigation system displays. Management of the displays
The
"AUDIO" , "NAV" , "TRIP" and

"TEL" buttons on the RT3 audio/
telephone control pad permit displaying
in the main window.
Example: "Coni guration"
"Coni guration" menu
The brightness of the display
and of the instrument panel
may change when the lights
are switched on automatically.
General menu
Press the
"MENU" button to gain access
to the general menu and select one of
the following functions:

- "Navigation-Guidance",
- "Audio functions",
- "Trip computer",
- "Coni guration",
- "Directory",
- "Telematics",
- "Map",
- "Video". This provides access to successive
coni rmation windows.

Example: "TRIP"

Page 144 of 187

1
8
32
12
6457
9
101514
16 13
20191711
18
01
124
1.
On/Off and Volume adjustment.
2. Selection of the wavebands FM1, FM2, FMast, AM.
3. Audio option adjustments: front/rear, left/right b alance,
loudness, sound ambiences.
4. Automatic search for a lower/higher frequency.
Selection of the previous/next CD, MP3 or Jukebox t rack.
5. Displaying of the list of local radio stations, of the tracks on
the CD or of the MP3/Jukebox folders.
Long press: updating of the local radio stations.
6. TA (Trafic Announcement) function on/off.
Long press: access to the PTY (radio Programme TYpe s)
mode. 7.
Ejection of the CD.
8. SIM card slot.
9. Keypad for entering descriptions by successive pre sses.
10. Access to the "PEUGEOT" services menu.
11. Selection of a lower/higher frequency.
12. Selection and conirmation.
13. Selection of the previous/next CD.
Selection of the previous/next MP3/Jukebox folder.
14. Cancellation of the current operation.
Long press: return to the current application. 15.
Displaying of the general menu.
16. Deletion of the last character entered or of the e ntire line.
17. Modiication of the screen display.
Long press: reinitialisation of the RT4 GPS audio/t elephone.
18. Selection of the source: radio, Jukebox, CD, CD ch anger
and auxiliary (AUX, if activated on the Coniguratio n menu).
Long press: CD copy to hard disc.
19. Selection of the display on the screen from the mo des:
TRIP, TEL, NAV and AUDIO.
20. Long press on the SOS button: emergency call.
FIRST STEPS

Page:   1-10 11-20 21-30 31-40 40 next >