seat adjustment PEUGEOT 607 2007 Owners Manual

Page 7 of 187

FAMILIARISATION

A. Forwards-backwards adjustment.
Electric front seat adjustment

D. Seat back angle adjustment.

E. Head restraint height adjustment.

B. Seat cushion angle adjustment.
F. Heated seats adjustment.

C. Height adjustment.

M. Adjustments memorisation.

1. Recall of the i rst position.

2. Recall of the second position.

 50

Page 8 of 187

FAMILIARISATION
Electric mirror adjustment
Steering wheel adjustment

 48

 49

A. Steering wheel height and depth
adjustment locking and release
control.

1. Released position.

2. Locked position.
B. Exterior mirrors selection, adjustment
and folding control.

1. Selection of the driver's mirror.

2. Central position "  ".

3. Selection of the passenger mirror.

Also...

4. Folding of the mirrors.
Rear bench seat
The bench seat back can be folded in
two 1/3 - 2/3 sections.
The release controls are located in the
boot.
Before folding the seat back:

 check that the seat belt strap is
positioned correctly on the side of
the seat back (1/3 or 2/3),

 release the centre seat belt strap
by pressing the black button on the
buckle (2/3).
When returning the seat back to the
upright position, take care not to trap
the seat belt.

 53

Page 51 of 187

3COMFORT
FRONT SEATS
B - Seat cushion angle adjustment C - Seat height adjustment
A - Forwards-backwards
adjustment
Push the control forwards or back-
wards to slide the seat. Tilt the front of the control upwards
or downwards to obtain the required
angle. Tilt the rear part of the control upwards
or downwards to obtain the required
height.
Electric front seats
The electric functions of the
driver’s seat are deactivated
one minute after the ignition is
switched off.
The operation of the electric
seats will be deactivated tem-
porarily if the energy economy
mode is activated.

Page 52 of 187

3COMFORT
51
E - Head restraint height and angle adjustment F - Lumbar adjustment
(manual adjustment)
D - Seat back angle adjustment
Never drive with the head
restraints removed; they must
be in place and adjusted
correctly.
Tilt the control to the front or the rear to
obtain the correct angle.

Tilt the control upwards or push it down-
wards to obtain the correct height.
Raise or lower the lever to obtain the
required position.

The setting is correct when
the upper edge of the head
restraint is level with the top
of the head.
The head restraint angle can also be
adjusted manually.
To remove the head restraint, tilt the
seat back to 45° and place the head
restraint in the high position, then pull
with both hands.

Page 53 of 187

3COMFORT
52
Memorising driving and mirror
positions
Memorising using the controls on
the driver’s door
To memorise:

 Place the key in the ignition on po-
sition,

 Adjust your seat and mirrors,

 Press button M , then button 1 "i rst
driving position" or button 2 "sec-
ond driving position" within four
seconds.
An audible signal coni rms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Ignition on, vehicle stationary

 Briel y press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0:
Off.
1: Low.

2: Medium.
3: High. The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving

 Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.

Page 54 of 187

3COMFORT
52
Memorising driving and mirror
positions
Memorising using the controls on
the driver’s door
To memorise:

 Place the key in the ignition on po-
sition,

 Adjust your seat and mirrors,

 Press button M , then button 1 "i rst
driving position" or button 2 "sec-
ond driving position" within four
seconds.
An audible signal coni rms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Ignition on, vehicle stationary

 Briel y press button 1 or 2 to recall
the corresponding memorised
position. The end of the setting is
indicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
G - Heated seats adjustment
With the engine running, use the cor-
responding adjustment dial to select
the required degree of heating:
0:
Off.
1: Low.

2: Medium.
3: High. The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons
M/1 and M/2 . Vehicle moving

 Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.

Page 96 of 187

7
83
SEAT BELTS
The rear seats are all i tted with a
three-point inertia reel seat belt with
force limiter.
Safety in the event of a frontal
impact has been improved by
the introduction of seat belts
with pre-tensioner and force
limiter connected to the front air bags.
Depending on the seriousness of the
impact, the pre-tensioning system in-
stantly tightens the seat belts i rmly
against the bodies of the occupants.
The pre-tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pressure
of the seat belt on the body of the oc-
cupant in the event of an accident.
With the vehicle station-
ary, when the ignition is
switched on, the warn-
ing light comes on if the
driver and/or the front
passenger has not fas-
tened his seat belt.
Front seat belts with pre-tensioner
and force limiter Front seat belt not fastened/
unfastened warning
Front seat belt height adjustment

 To lower the attachment point,
squeeze control 1 and slide it
downwards.

 To raise the attachment point, slide
control 1 upwards. Rear seat belts
To lock the seat belts

 Pull the strap, then insert the end
into the buckle.

 Check that it is fastened correctly
by pulling the strap.
To unlock the seat belts

 Press the red button on the buckle,
then remove the end. Seat belt warning light
Before moving off, the driver
must ensure that all passen-
gers have fastened their seat
belts.
When the vehicle is stationary, igni-
tion on, if the driver and/or the front
passenger has not fastened his
seat belt, the warning light on the
instrument panel comes on, then
from approximately 12 mph (20 km/h) and for
two minutes, this warning light l ashes accom-
panied by an audible signal which increases
in volume. Once these two minutes have
elapsed, the warning light remains on until the
driver or front passenger fastens his seat belt.
This warning light is always accompanied by a
message on the multifunction display.
When the vehicle is moving, the warning light
comes on if the driver or front passenger un-
fastens his seat belt.

Note: a bag or a pet placed on the front pas-
senger seat may trigger the lighting of this
warning light.

Page 187 of 187

6
3
14
9
2
42
77
35
5
6
167
JBL EQUIPMENT
The JBL Hi-Fi system guarantees full respect
of the musical nuances to provide high idelity
sound reproduction in your vehicle.
At the heart of the system, a 240 watt
multifunction ampliier (1) independently controls
12 high-deinition acoustic speakers. These
speakers make it possible to obtain optimum
reproduction and distribution of the sound in the
vehicle, both in the front and in the rear.
The basic functions remain those of the audio
equipment.
No further adjustment is required.
However, to beneit fully from your JBL audio
system, we recommend that you set the AUDIO
functions (BASS, TREB, FAD, BAL) to the
central position and the Loudness to the "ON"
position. PRESENTATION
ADJUSTMENT IN CD MODE
EQUIPMENT
If your 607 is itted with a JBL Hi-Fi
audio system, this is designed speciically
for the passenger compartment
of your vehicle.
The speakers are located:
- in the fascia panel: two Tweeters (4) incorporate d in two
Mid Range Speakers (5) for clear front reproduction of the
sound image.
- in the front doors: two Woofers (6) for reproduct ion of the
bass tones (low frequencies).
- in the rear doors: two Tweeters (2) and two Woofe rs (3)
permitting a balance of the frequencies (from bass to treble)
in the rear seats. - on the rear shelf: two Subwoofers (7) designed sp
eciically for
reproduction of the extreme bass tones (very low fr equencies)
for true listening pleasure; you will appreciate th e impact and
the depth without noticing that the sound is coming from the
rear of the vehicle.
607: the concert hall