service indicator Peugeot 607 Dag 2002 Owner's Manual

Page 14 of 167

PEUGEOT SERVICING
The maintenance cycle of your 607 is based on level A(including the replacement of the engine oil, the oil fi lter and a
set of checks) and level Cservices [service level A+ workshop operations carried out every 40,000 miles (60 000 km)] in
accordance with the tables on the following pages.
So that the driving conditions and your style of driving may be taken into account, your 607 is fitted with a service indica
tor which programmes the intervals for the level A servic e:
• every 20,000 miles (30 000 km) maximum or 2 years for petrol engines,
• every 12,000 miles (20 000 km) maximum or 2 years for direct injection diesel engines,
The frequency of level Aservices specific to your vehicle will be determined by three elemen ts:
• the number of engine revolutions,
• the engine oil temperature,
• prolonged periods of the vehicle not being used.
Depending on these elements, the service indicator will suggest a time which is more or less the same as the initia l plan.
Depending on the conditions of use, one or more level Aservices can be carried out between two level C services.
Depending on the mileage recorded, your dealer may offer to ca rry out the level Cservice to avoid the visits being too close
together.
PEUGEOT SERVICING
18

Page 15 of 167

The extension of the service intervals means that the engine oil level must be checked regularly: topping up of the
oil between two oil changes is normal.
It is for this reason that your Peugeot dealer will invite you to an intermediate visit between services. The date o f
this visit is not shown by the service indicator.
It is to be carried out between two services.
A Peugeot professional will carry out a quick check and will top up the levels if necessary (oil, coolant, screen wash up to
2 litres).
If the oil level is too low, there is a risk of significa nt damage to the engine: check the engine oil level at le ast every
3,000 miles (5 000 km).
This maintenance frequency is the result of developments to our vehicles and to the lubricants:
THUS IT IS ESSENTIAL THAT YOU ONLY USE ENGINE LUBRICANTS THAT ARE APPROVED AND RECOMMENDED
BY THE MANUFACTURER (see pages on 'Lubricants').
PEUGEOT SERVICING 19

Page 16 of 167

PEUGEOT SERVICING
20
A few seconds after the ignition is
switched on, the total distance
recorder resumes normal operation
and the display shows the total and
trip distances.
The distance remaining before the
next service is less than 1,000
miles
A few seconds after the ignition is
switched on, the distance recorder
resumes normal operation and the
spanner remains lit. This indicates
that a service should be carried out
shortly.SERVICE INDICATOR
Located on the instrument panel with
the total distance recorder (total and
trip distances), this programmes
drain/refill intervals depending on the
use of the vehicle.
Operation
A few moments after the ignition has
been switched on, the spanner sym
bolising services lights up; the dis
play for the total distance recorder
tells you (in round figures) the dis
tance remaining before your next
service.
Example:
4,800 miles remain before
the next service is due. When the
ignition is switched on and for a few
seconds, the display shows: The service is overdue
Each time the ignition is switched on
and for a few seconds, the symbol
and the excess distance flash.
Note:
with the engine running the
symbol flashes until the service has
been carried out.

Page 18 of 167

PEUGEOT SERVICING
22
THE SERVICE LEVELS
Each vehicle has its own servicing cycle, defined by th
e manufacturer in terms of its technical specification.
This cycle consists of alternating 2 types of service A and C, inte rmediate visits and a few additional operations specific to
your vehicle; these correspond to key stages in the life of your 6 07.
At your first and each subsequent service, your dealer will advise you of the type and content of the next service
due.
Intermediate topup
visit.
MAINTENANCE CYCLE FOR YOUR PETROL ENGINE 607
2 litre 16 V and 2.2 litre 16V petrol engines : service e very 2 years or 20,000 miles (30 000 km) maximum (unless the
service indicator shows it is required before this)
1st service at 6,000 miles
(10 000 km) or 6 months*.
This is necessary in order to benefit from the warranty.
MILES (KM) 40,000 (60 000) 80,000 (120 000) 120,000 (180 000)
injection engine: service every 2 years or 20,000 mil es (30 000 km) maximum (unless the service indicator shows it is
required before this)
1st service at 6,000 miles
(10 000 km) or 6 months*.
This is necessary in order to benefit from the warranty.
MILES (KM) 40,000 (60 000) 80,000 (120 000) 120,000 (180 000)
Automatic gearbox oil level every 40,000 miles (60 000 km).
Replacement of brake fluidevery 2 years or 40,000 miles (60 000 km)
These fixed operations are carried out with synthetically based oil. Fuel economy oil
or synthetic oil may also be used (except for the 2.2 litre 16 V petrol engine).
+ replacement of air filter
+ replacement of
24V V6 petrol
+ replacement of air filter + replacement of fuel filterfuel filter
* Whichever comes first.

Page 19 of 167

PEUGEOT SERVICING 23
Intermediate topup
visit.
MAINTENANCE CYCLE FOR YOUR 607 TURBO DIESEL HDI
Turbo diesel HDI: service every 2 years or 12,000 mi les (20 000 km) (unless the service indicator shows it is required
before this).
1st service
at 6,000 miles (10 000 km) or 6 months*.
This is necessary in
order to benefit from the warranty.
MILES (KM) 36,000 (60 000)
72,000 (120 000) 108,000 (180 000)
+ maintenance of particu
late emission filter at
48,000 miles (80 000 km)
+ maintenance of
particulate emission filter at 96,000 miles
(160 000 km)
Automatic gearbox oil every 36,000 miles (60 000 km).
Replacement of brake fluidevery 2 years or 36,000 miles (60 000 km).
These fixed operations are carried out:
– with synthetically based oil, Fuel Economy oil or synthetic oil ;
– with 5W 40 oil for Turbo Diesel HDI engines fitted with a particulate emi ssion filter.
* Whichever comes first.

Page 21 of 167

PEUGEOT SERVICING 25
Level
Operations Description of operation 1st service
A C Intermediate
DRAIN/REFILL Engine oil Bleed fuel filter (diesel) Oil filter Fuel filter
*(petrol)REPLACE Fuel filter element (diesel) Air filter element Spark plugs (petrol) Engine oil (check + topup) Manual gearbox oil (check + topup) Battery (check + topup) if cap is removableLEVEL Screen wash (check + topup) Coolant (check + topup) Brake fluid (check + topup) Power steering fluid (check + top up according to specification ) Operation of lights and indicators Condition of glass, headlamp and light lenses and mirrors Horn Windscreen washer jets Condition of wiper blades Condition and tension of the ancillary drive belts Handbrake Condition of hydraulic circuits (hoses and covers)CHECK Condition of rubber boots and gaiters Brake pads o Play in hubs, link rods, ball joints, flexible mountings Shock absorbers Rear drum brake lining wear Condition and pressure of tyres (including spare wheel) Emission control check as per current legislation (petrol) Smoke opacity (diesel) Pollen filter (according to specification)o
Visual check of the whole vehicle


: All driving conditions o: Arduous conditions * According to destination
SERVICE
ROAD TEST
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Courtesy vehicle

Page 24 of 167

INSTRUMENTS AND CONTROLS
28
1 Handbrake indicator light.
2 Main beam headlamps indicator
light.
3 Dipped beam headlamps
indicator light.
4 Rev counter.
5 Lefthand direction indicator.
6 Fuel gauge.
7 Righthand direction indicator.
8 Speedometer. 9
Front fog lamps indicator light.
10 ABS antilock braking system
warning light.
11 Rear fog lamps indicator light.
12 Engine diagnostics warning
light.
13 Coolant temperature indicator.
14 CHECK button.
15 Trip recorder zero reset.
16 Service indicator and total
distance recorder. 17
Warning/status screen.
18 Illumination button +.
19 Illumination button .
20 Engine oil level indicator.
Engine oil temperature
indicator.
INSTRUMENT PANEL DIALS: PETROL

Page 25 of 167

INSTRUMENTS AND CONTROLS29
1
Handbrake indicator light.
2 Main beam headlamps
indicator light.
3 Dipped beam headlamps
indicator light.
4 Rev counter.
5 Lefthand direction indicator.
6 Fuel gauge.
7 Righthand direction indicator.
8 Speedometer. 9 Front fog lamps indicator light.
10
ABS antilock braking system
warning light.
11 Rear fog lamps indicator light.
12 Engine diagnostics warning
light.
13 Coolant temperature indicator.
14 CHECK button.
15 Trip recorder zero reset.
16 Service indicator and total
distance recorder. 17
Warning/status screen.
18 Illumination button +.
19 Illumination button .
20 Engine oil level indicator.
20Engine oil temperature
indicator.
INSTRUMENT PANEL DIALS: DIESEL

Page 35 of 167

INSTRUMENTS AND CONTROLS
40
Coolant temperature indicator
When the needle is in
zone A, the
temperature is correct.
When the needle is in zone B, the
temperature is too high.
In cases where the coolant tem
perature warning light comes on
(linked to the STOPwarning light),
you must stop immediately.
Warning: wait for the engine to cool
down.
If necessary, top up the level.
Because the cooling system is pres
surised, to prevent the risk of scald
ing, turn the cap two turns to allow
the pressure to drop.
When the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.Engine oil level and
temperature
When the ignition is switched on, this
gauge indicates the engine oil level
for approximately 20 seconds, then it
indicates the engine oil temperature.
Engine oil level
The reading is valid only if the vehi
cle is on level ground, and the
engine has been switched off for 10
minutes.
With the ignition on, wait for the
graduated sector to light up and the
indicator needle to move.
When the needle is in zone C, the oil
level is correct.
When the needle is in zone D, the oil
level is incorrect.
There is a risk of damage to the
engine.
 Check the level with the dipstick.
You must top up the level without
exceeding the maximum level on
the gauge.
Engine oil temperature
When the needle is in zone E, the
temperature is correct.
When the needle is in zone F, the
temperature is too high.
Reduce your speed to lower the
temperature.
Service indicator and total
distance recorder
When the ignition is switched on, this
indicates servicing information for a
few seconds, then the total and trip
distances.
Service function
See the 'Service indicator' section.
Total distance recorder function
The total distance is displayed on the
left side of the screen and the trip
distance on the right side.

Page 61 of 167

TELEPHONE: Audio/Telephone RT2
This function is a GSM 900 MHZ telephone incorporated in the audio system.
It possesses a 'hands free'function, provided by a microphone located in the front courte sy light and a steering column
remote control which allows access to most of the functions.
It also possesses a 'confidential' function, provided by the instrument panel located in the u pper casing of the centre front
armrest.
Note: An echo may be heard for a few seconds at the beginning of t he call.
The principal "mobile"type functions are shown on the display incorporated in the a udio system; the menu lists can be
referrred to on the multifunction display.
This function is active when the ignition key is in the accessories position (1st notch), the ignition is switched on (2nd notch),
the engine is running or the vehicle is being driven.
Note: when the ignition key is in the accessories position (1st notch) or the ignition is switched on (2nd notch), this function
will be interrupted after thirty minutes, when the message 'Economy mode active'appears on the multifunction display. If
you are using the telephone at that time, you will be ab le to finish your call.
General information about the display (Audio/Telephone R T2 display)
In telephone mode, the display shows the following informa tion, where applicable.
1. Network signal indicator (3 levels).
2. Service indicator not available.
3. Indicates a communication in progress.
4. Indicator showing connection to an outside network.
5. Indicates:
– when continuously lit: presence of an unread message or message s.
– when flashing: the message tape is full.
6. Display zone (10 symbols x 2 lines).
YOUR 607 IN DETAIL
62