ignition PONTIAC GRAND PRIX 2007 Owners Manual

Heated Seats
If the vehicle has this
feature, the buttons are
located on the climate
control panel. See
Climate Control System
on page 157for
more information.
Press the button once to activate the high heat
setting. Both indicator lights next to the button will
come on.
Press the button again to select the lower
temperature setting. Only the bottom indicator light
will come on.
Press the button a third time to turn the heat off.
This feature only works when the ignition is on.
Reclining Seatbacks
{CAUTION:
You can lose control of the vehicle if you
try to adjust a manual driver’s seat while
the vehicle is moving. The sudden
movement could startle and confuse you,
or make you push a pedal when you do
not want to. Adjust the driver’s seat only
when the vehicle is not moving.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on the
seatback to be sure it is locked.
10

You will be using the lap-shoulder belt to secure
the child restraint in this position. Be sure to follow
the instructions that came with the child restraint.
Secure the child in the child restraint when and as
the instructions say.
1. Your vehicle has a right front passenger’s
frontal airbag. SeePassenger Sensing System
on page 74. We recommend that rear-facing
child restraints be secured in a rear seat, even
if the airbag is off. If your child restraint is
forward-facing, move the seat as far back as it
will go before securing the child restraint in this
seat. SeeManual Passenger Seat on page 8.
When the passenger sensing system has
turned off the right front passenger’s frontal
airbag, the off indicator in the passenger airbag
status indicator should light and stay lit
when you turn the ignition to RUN or START.
SeePassenger Airbag Status Indicator
on page 173.
2. Put the child restraint on the seat.
3. Pick up the latch plate, and run the lap and
shoulder portions of the vehicle’s safety belt
through or around the restraint. The child
restraint instructions will show you how.4. Buckle the belt. Make sure the release button
is positioned so you would be able to unbuckle
the safety belt quickly if you ever had to.
62

Passenger Sensing System
Your vehicle has a passenger sensing system.
The passenger airbag status indicator on the
instrument panel will be visible when you turn
your ignition key to RUN or START.
The words ON and OFF, or the symbol for on and
off, will be visible during the system check. If
you use remote start to start your vehicle from a
distance, if your vehicle has this feature, you
may not see the system check. When the system
check is complete, either the word ON or the
word OFF, or the symbol for on or the symbol for
off, will be visible. SeePassenger Airbag Status
Indicator on page 173.The passenger sensing system will turn off the
right front passenger’s frontal airbag under certain
conditions. The driver’s airbags are not part of
the passenger sensing system.
The passenger sensing system works with
sensors that are part of the right front passenger’s
seat. The sensors are designed to detect the
presence of a properly-seated occupant and
determine if the passenger’s frontal airbag should
be enabled (may inate) or not.
Accident statistics show that children are safer if
they are restrained in the rear rather than the front
seat. We recommend that child restraints be
secured in a rear seat, including an infant riding
in a rear-facing infant seat, a child riding in a
forward-facing child seat, and an older child riding
in a booster seat.
Your vehicle has a rear seat that will accommodate
a rear-facing child restraint. A label on your sun
visor says, “Never put a rear-facing child seat
in the front.” This is because the risk to the
rear-facing child is so great, if the airbag deploys.
United StatesCanada
74

{CAUTION:
For up to 10 seconds, after the ignition is
turned off and the battery is disconnected,
an airbag can still inate during improper
service. You can be injured if you are
close to an airbag when it inates. Avoid
yellow connectors. They are probably part
of the airbag system. Be sure to follow
proper service procedures, and make sure
the person performing work for you is
qualied to do so.
The airbag system does not need regular
maintenance.
Adding Equipment to Your
Airbag-Equipped Vehicle
Q:Is there anything I might add to the front
or sides of the vehicle that could keep the
airbags from working properly?
A:Yes. If you add things that change your
vehicle’s frame, bumper system, height,
front end or side sheet metal, they may keep
the airbag system from working properly.
Also, the airbag system may not work properly
if you relocate any of the airbag sensors. If
you have any questions about this, you should
contact Customer Assistance before you
modify your vehicle. The phone numbers and
addresses for Customer Assistance are in
Step Two of the Customer Satisfaction
Procedure in this manual. SeeCustomer
Satisfaction Procedure on page 492.
79

Keys.............................................................. 84
Remote Keyless Entry (RKE) System.......... 86
Remote Keyless Entry (RKE) System
Operation................................................. 87
Doors and Locks.......................................... 92
Door Locks................................................. 92
Power Door Locks....................................... 94
Delayed Locking.......................................... 94
Programmable Automatic Door Locks.......... 95
Rear Door Security Locks........................... 95
Lockout Protection....................................... 96
Trunk.......................................................... 96
Windows....................................................... 98
Power Windows.......................................... 99
Sun Visors................................................ 100
Theft-Deterrent Systems............................. 100
Content Theft-Deterrent............................. 100
PASS-Key
®III ........................................... 102
PASS-Key®III Operation........................... 103
Starting and Operating Your Vehicle......... 105
New Vehicle Break-In................................ 105
Ignition Positions....................................... 105
Retained Accessory Power (RAP)............. 106
Starting the Engine.................................... 107Engine Coolant Heater.............................. 108
Active Fuel Management™........................ 109
Automatic Transaxle Operation.................. 110
Parking Brake........................................... 115
Shifting Into Park (P) ................................. 116
Shifting Out of Park (P)............................. 117
Parking Over Things That Burn................. 118
Engine Exhaust......................................... 119
Running the Engine While Parked............. 120
Mirrors......................................................... 121
Manual Rearview Mirror with OnStar
®....... 121
Outside Power Mirrors............................... 121
Outside Convex Mirror............................... 122
OnStar
®System.......................................... 122
Storage Areas............................................. 126
Glove Box................................................. 126
Cupholder(s).............................................. 126
Sunglasses Storage Compartment............. 127
Front Seat Storage Net............................. 127
Center Console Storage Area.................... 127
Assist Handles.......................................... 127
Convenience Net....................................... 127
Sunroof....................................................... 128
Section 2 Features and Controls
83

Keys
{CAUTION:
Leaving children in a vehicle with the
ignition key is dangerous for many
reasons. They could operate the power
windows or other controls or even make
the vehicle move. The children or others
could be badly injured or even killed.
Do not leave the keys in a vehicle with
children.
84

The key can be used for
the ignition, as well as
the driver’s door
lock and storage
compartments.
The key comes with a bar coded tag attached to
the key ring. Keep this bar coded tag and give it to
your dealer if a new key needs to be made.The vehicle has the PASS-Key®III vehicle theft
system. The key has a transponder in the key head
that matches a decoder in the vehicle’s instrument
panel. The key will have PK3 stamped on it. If a
replacement key or an additional key is needed, it
must be purchased from your dealer.
Any new PASS-Key
®III key must be programmed
before it will start the vehicle. SeePASS-Key®III
on page 102for more information on programming
a new key.
In an emergency, contact Roadside Assistance.
SeeRoadside Assistance Program on page 498
for more information.
Notice:If you ever lock your keys in your
vehicle, you may have to damage the vehicle
to get in. Be sure you have spare keys.
85

"(Unlock):Press the unlock button one time to
unlock the driver’s door. Press the unlock
button again within ve seconds to unlock the
other doors. The interior lamps will come on and
stay on for 20 seconds or until the ignition is turned
on. If enabled through the DIC, the parking
lamps may ash once and the horn may chirp
once to indicate unlocking has occurred. See
“REMOTE LOCKS FEEDBACK” underDIC
Controls and Displays (Base Level DIC) on
page 186orDIC Controls and Displays (Uplevel
DIC with Trip Computer) on page 190. Pressing
the unlock button on the remote keyless entry
transmitter will disarm the content theft-deterrent
system. SeeContent Theft-Deterrent on page 100
for more details.
V(Trunk Release):Press and hold this
button for about one second to release the trunk
lid. The transaxle must be in PARK (P) for
this feature to operate.
L(Panic Alarm):Press this button to activate
the alarm. The ignition must be in OFF for the
remote alarm to work. When the remote alarm
button is pressed the headlamps will ash and the
horn will sound repeatedly for two minutes. The
alarm will turn off when the ignition is moved
to RUN or the remote alarm button is pressed
again.
Matching Transmitter(s) to Your
Vehicle
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your
vehicle. If a transmitter is lost or stolen, a
replacement can be purchased through your
GM dealer. Remember to bring any additional
transmitters with you when you go to your dealer.
When the dealer matches the replacement
transmitter to your vehicle, any remaining
transmitters must also be matched. Once your
dealer has coded the new transmitter, the
lost transmitter cannot unlock your vehicle. The
vehicle can have a maximum of four transmitters
matched to it.
88

3. Put the two halves back together. Make sure
the cover is on tight so water will not get
inside the transmitter.
4. Test the operation of the transmitter with the
vehicle.
Remote Vehicle Start
Your vehicle may have a remote start feature.
This feature allows you to start the engine
from outside the vehicle. It may also start the
vehicle’s heating or air conditioning systems and
rear window defogger. When the remote start
system is active, the climate control system will
heat or cool the inside of the vehicle based on the
outside temperature. The rear window defogger
will be turned on by the climate control system
when it is heating the inside of the vehicle. Normal
operation of the system will return after the key
is turned to RUN.
Laws in some communities may restrict the use of
remote starters. For example, some laws may
require a person using remote start to have
the vehicle in view when doing so. Check local
regulations for any requirements on remote starting
of vehicles.Do not use the remote start feature if your vehicle
is low on fuel. Your vehicle may run out of fuel.
The remote start feature provides two separate
starts per ignition cycle, each with 10 minutes of
engine running time.
The remote start system needs to be reset after
your vehicle’s engine is started two times using the
transmitter’s remote start button. The remote
start system is reset by inserting the vehicle’s key
into the ignition switch and turning to RUN.
SeeIgnition Positions on page 105for information
regarding the ignition positions on your vehicle.
Your remote keyless entry transmitter with
the remote start button provides an increased
range of operation. You can start your vehicle from
about 492 feet (150 m) away. However, the
range may be less while the vehicle is running,
and as a result you may need to be closer to your
vehicle to turn it off than you were to turn it on.
There are other conditions which can affect
the performance of the transmitter, seeRemote
Keyless Entry (RKE) System on page 86for
additional information.
90

/(Remote Start):If your vehicle has the remote
vehicle start feature, the keyless entry transmitter
will have a button with this symbol on it.
To start the vehicle using the remote start feature,
do the following:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter’s lock
button, then immediately press and hold
the transmitter’s remote start button for
4 seconds or until the vehicle’s turn signal
lamps ash. The vehicle’s doors will be
locked.
3. When the vehicle starts, the parking lamps
will turn on and remain on while the engine
is running, and the DIC will display REMOTE
START ACTIVE PRESS HAZARD SWITCH
TO CANCEL.
The engine will shut off automatically after
10 minutes, unless a time extension has been
done or the vehicle’s key is inserted into
the ignition switch and turned to RUN.
If you enter the vehicle after a remote start,
and the engine is still running, insert the
key into the ignition switch and turn to RUN
to drive the vehicle.4. To manually shut off a remote start, do any of
the following. The parking lamps will turn off.
Aim the remote keyless entry transmitter
at the vehicle, and press the remote
start button.
Turn on the hazard warning ashers.
Turn the ignition switch to RUN and then
to OFF.
Your vehicle’s engine can be started two times
using the transmitter’s remote start feature. If only
one remote start procedure has been done,
since last driving the vehicle, or resetting the
remote start system, the engine may be started
again remotely by following the remote start
procedure a second time.
If the remote start procedure is used again before
the rst 10 minute time frame has ended, the
rst 10 minutes will immediately expire and
the second 10 minute time frame will start.
The remote vehicle start feature will not operate if
any of the following occur:
The remote start system is disabled through
the DIC.
The vehicle’s key is in the ignition.
A door on the vehicle is open.
91