RENAULT CLIO 2009 X85 / 3.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine
headrest................................................(up to the end of the DU)adjusting your driving position ..............(up to the end of the DU)
3.29
ENG_UD10520_1Appuis-tête arrière (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
The headrest is a safety component; check that it is fitted and in the correct po- sition. The top of the head- rest should be as close as possible to the top of the head.
To remove the headrest
Press button A of lock 1 and remove the headrest.
To refit the headrest
Insert the rods into the holes, press the tabs on both rods and lower the head- rest.
Positions for use
While pressing button A of lock 1, lift the headrest fully to use it in the top po- sition. Lower it until it locks to use it in the bottom position.
Storage position
Press button A and lower the headrest completely.
When the headrest is set at the lowest position, this is for storage only. It should not be in this position when a seat is occupied.
REAR HEAD RESTS
1
A

Downloaded from www.Manualslib.com manuals search engine
rear bench seat.....................................(up to the end of the DU)rear seatsfunctions .........................................(up to the end of the DU)
3.30
ENG_UD10581_1Banquette arrière : fonctionnalités (X85 - B85 - C85 - S85 - K85 \
- Renault)ENG_NU_853-3_BCSK85_Renault_3
JauneNoirNoir texte
Then lift up the rear section of cushion 1 and tilt the seat base so that it is next to the front seats.
To fold down the seatback
Remove the rear headrests (if fitted).
Ensure that the front seats are far enough forward.
Place the seat belts in their guides
B.
Press button 2 and lower the seat-
back C.
Rear bench seat: functions
Before moving the seatback, put the seat belt in belt guide B to avoid damaging it.
For safety reasons, carry out any adjustments when the vehicle is not being driven.
The configuration of the two seat bench with the small seatback C pulled down, does not allow the central seat to be used as it would be impossible to buckle the seat belt (belt buckles inaccessible).
The seat base and the seatback may be folded down (one or both sections) to allow bulky objects to be carried.
Start by folding down the seat base, then the seatback.
To fold away the seat base
Lift up the front of the seat cushion A until it reaches the stop.
Where the bench seat is in one section, check that the two sides of the seat base are correctly locked.
REAR BENCH SEAT: functions (1/2)
A
1
C
B
2

Downloaded from www.Manualslib.com manuals search engine
JauneNoirNoir texte

3.31
ENG_UD10581_1Banquette arrière : fonctionnalités (X85 - B85 - C85 - S85 - K85 \
- Renault)ENG_NU_853-3_BCSK85_Renault_3

To replace the seat base, proceed in the reverse order to removal.
Lift up the rear bench seat cushion in such a way so as to position the rear section of the seat base 1 under the seatback.
Then push the front 3 of the cushion A in order to lock the seat base.
To replace the seatback, proceed in the reverse order to removal.
Refit the seatback and click it back into place.
REAR BENCH SEAT: functions (2/2)
1
3
A
When refitting the seat- back, make sure it is cor- rectly locked in place.If seat covers are fitted, make sure these do not prevent the seatback latch from locking in.
Make sure that the seat belts are positioned correctly.Reposition the headrests.
When moving the rear seats, ensure that nothing obstructs the anchorage points (passenger’s arm or leg, a pet, gravel, cloth, toys, etc.).

Downloaded from www.Manualslib.com manuals search engine
rear parcel shelf ....................................(up to the end of the DU)rear parcel shelf ....................................(up to the end of the DU)
3.32
ENG_UD10582_1Tablette arrière (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Rear parcel shelf
Do not place any objects, especially heavy or hard objects, on the parcel shelf.
These may pose a risk to the vehicle occupants if the driver has to brake suddenly or if the vehi- cle is involved in an accident.
Rear parcel shelf
To remove:
– unhook both straps
1;
– unhook sun visor
2 (depending on vehicle);
– detach the flexible section attached
to the rear bench seatback (depend- ing on vehicle);
– lift the parcel shelf then unclip it up
- wards.
To refit, proceed in the reverse order to removal.
REAR PARCEL SHELF
11
2
Maximum weight on rear parcel shelf: 25 kg, evenly distributed.

Downloaded from www.Manualslib.com manuals search engine
3.33
ENG_UD12582_2Cache-bagages (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Luggage cover
LUGGAGE COMPARTMENT COVER: sport tourer versions
Removing the luggage
compartment cover
1
Press button 3 and lift the right-hand side of the roller at the same time.
Then lift the left-hand side of the roller and remove it.
To refit the luggage cover, carry out this procedure in reverse.
To remove the flexible
section
A of the luggage
compartment cover
1
Using the handle 2, pull the flexible part
gently A to release the pins from their mounting points located either side of the luggage compartment.
Guide the luggage cover onto the
roller.
Luggage compartment cover
storage
1
Lift the mobile floor B.
Store the luggage compartment cover by inserting it, one side at a time.
Replace the mobile floor.
1
A
3
B
Do not place any objects, especially heavy or solid objects on the lug-gage compartment cover. These may pose a risk to the vehicle occu-pants if the driver has to brake suddenly or if the vehicle is involved in an accident.
2

Downloaded from www.Manualslib.com manuals search engine
3.34
ENG_UD12582_2Cache-bagages (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
The luggage compartment cover con-
sists of a rigid section A and a folding
section B.
The luggage cover is in the unfolded position.
The luggage compartment cover is removed.
To remove it: with the cover in the folded position and holding it horizontally:
– pull one side of the luggage compart
-ment cover towards you, pivoting it slightly;
– then pull the other side of the lug
-gage compartment cover to com-pletely detach it from its housing.
LUGGAGE COMPARTMENT COVER: utility versions
Do not place any objects, especially heavy or solid objects on the luggage compartment cover. These may pose a risk to the vehicle occu-pants if the driver has to brake sud-
denly or if the vehicle is involved in an accident.
The luggage compartment cover is in the folded position.
To fold it:
– lift shelf
A slightly and pull it towards you to remove;
– then fold section
B back on itself.
A
B

Downloaded from www.Manualslib.com manuals search engine
towing rings ..........................................(up to the end of the DU)tailgate ..................................................(up to the end of the DU)
3.35
ENG_UD10842_1Aménagements coffre à bagages (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Luggage compartment storage
Locations for anchorage
rings
1
Useful for securing objects transported in the luggage compartment. See the information on “Transporting objects in the luggage compartment”.
Depending on the vehicle, a net for re- taining luggage on the floor, located in the storage compartment under the
passenger seat, may be attached to these hooks.
LUGGAGE COMPARTMENT STORAGE (1/2)
Sport tourer versions
On equipped vehicles, remove the mobile floor to access the rings (refer to the information on “mobile floor”).
11
1
Always position objects being trans- ported so that the heaviest items are resting against the back of the rear bench seat.

Downloaded from www.Manualslib.com manuals search engine
3.36
ENG_UD10842_1Aménagements coffre à bagages (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Mobile floor
When fitted to the vehicle, it can be used to make loading easier.
The mobile floor can be stored in two ways.
First storage
– Lift section
3 and fold it against sec-
tion 2;
– lift the assembly and position it

against the rear bench seat ;
– push catch
4 to lock the mobile floor in the folded position.
Note: open flap 5 to access the ISOFIX ring and the net ring at the back of the luggage compartment.
Second storage
– Lift section
3 and fold it against sec-
tion 2;
– remove the assembly ;
– position it in the luggage com
-
partment, using the runners 6 as guides.
3
2
4
6
5
LUGGAGE COMPARTMENT STORAGE (2/2)
Maximum weight for the mobile floor: 100 kg evenly distributed.

Downloaded from www.Manualslib.com manuals search engine
tailgate ..................................................(up to the end of the DU)transporting objectsin the luggage compartment ...........(up to the end of the DU)
3.37
ENG_UD14667_3Transports d objets dans le coffre (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
Transporting objects in the luggage compartment
Always position the heavi- est items directly on the floor. Use the lashing points on the floor of the luggage compartment, if these are fitted to the vehicle. The luggage should be loaded in such a way that no items will be thrown forward and strike the occupants if the driver has to brake suddenly. Fasten the rear seat belts, even if the seats are not occupied.
If you have to place objects on the folded seatback, with the bench seat in the 3-seater position, remove the front headrests before folding the seatback so that is can be folded as flat as pos- sible against the seat base.
TRANSPORTING OBJECTS IN THE LUGGAGE COMPARTMENT
Always position the objects transported so that the largest surface is against:
– The rear bench seatback for normal
loads (example A).
– The folded down seat for maximum
loads (example B).
A
B

Downloaded from www.Manualslib.com manuals search engine
luggage retaining net ............................(up to the end of the DU)transporting objectsluggage net .....................................(up to the end of the DU)
3.38
ENG_UD12583_2Filet de séparation (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_3
JauneNoirNoir texte
Luggage net
LUGGAGE NET (1/2)
Luggage net A
On equipped vehicles, this can be used when transporting animals or luggage, to separate them from the passenger section.
It can be positioned:
– behind the front seats;
– behind the rear bench seat.
Fitting the luggage net
behind the front seats
Inside the vehicle on each side:
– lift the cover
1 to access the upper mounting ring of the net;
– fix the net strap hook onto the ring; –
move the cut-out in the carpet to

access lower mounting 3 for the net;
– once you have accessed the lower
mounting, attach the hook of the net
strap to the ring 3;
– adjust the net strap so that it is taut.
A
13
2
The luggage net is designed to retain a maximum weight of 10 kg.
Risk of injury.
Do not install the luggage net in this position when a passenger is occupying a rear seat