check engine RENAULT MEGANE 2000 X64 / 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine 8
71
12
1
9
1011
11
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page30
3.30
ROADBOX: FITTING(continued)
•Secure the seat belts by inserting
the buckles7into the catches8.•Fitcarpet10on the floor and then
install roadbox9in the vehicle.• Tighten bolts1andthenbolts11.
• Connect wiring harness12.
• Close the hood compartment
cover and make sure it is properly
locked.

Downloaded from www.Manualslib.com manuals search engine 13
14
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page31
3.31
ROADBOX: FITTING(continued)
Lid13locks or unlocks at the same
time as the vehicle doors.
To open or close lid13, slide it using
handle14.
A light illuminates when the lid is
open.
If lid13is not closed (or not
properly closed) when the doors
are locked using the plip remote
control, a bleep is sounded.

Downloaded from www.Manualslib.com manuals search engine 1
3
6
57
8
4
2
1
9
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page32
3.32
ROADBOX: REMOVING
With the vehicle hood folded down
and the hood compartment cover
open
•Disconnect the wiring harness2.
• Remove bolts1.• Open lid3.
•Removebolts4.• Take out the roadbox5.
• Remove carpet6from the floor.
• Release the rear seat belts7by
pressing buttons8.
• Install seatbackA:
Position each seatback lug in its
housing9.

Downloaded from www.Manualslib.com manuals search engine 1
1
13
13
14
B
10
7A
11
12
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page33
3.33
ROADBOX: REMOVING(continued)
• Route each of the rear seat belts7
though the corresponding belt
guide10.
• Secure the belts by fastening each
of the buckles11in their
corresponding catches12.•Tighten bolts1as far as they will
go.
• Ensure the seatback is held in
position securely.• Position seat baseBand tighten
the two bolts13as far as they will
go.
• Ensure the seat is locked in
position securely.
•When refitting the seatback,make sure the top part is latched in properly. If seat covers are used, make sure
that they do not prevent the latch for the seatback from locking into position.
•When moving the bench seat,make sure the seat belt catches14are in position correctly before folding the
seat base.
When refitting the rear bench seat, ensure that the seat belts are correctly positioned.

Downloaded from www.Manualslib.com manuals search engine 1
2
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page34
3.34
LUGGAGE COMPARTMENT
When closed, the luggage
compartment is locked at the same
time as the doors.
To unlock:
With the ignition on,use the
electric control.
With the ignition off,use the plip
remote control or turn the ignition
key in lock1.To open:
Press lock1and pull towards you.
To close:
Closetheluggagecompartmentlid
firmly but without using excessive
force.Fittings in the luggage
compartment
An elastic fastening2is provided
for holding items such as a warning
triangle.

Downloaded from www.Manualslib.com manuals search engine 11
23
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page35
3.35
SKI FLAP
Move the two screws1in the
luggage compartment a quarter of a
turn.
Lower flap2.Lift cover3.

Downloaded from www.Manualslib.com manuals search engine QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page36
3.36

Downloaded from www.Manualslib.com manuals search engine QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T4.WIN 24/2/2001 14:35-page1
4.01
Section 4: Maintenance
Bonnet ..................................................................................................................................................... 4.02 - 4.03
Engine oil level/Oil change ................................................................................................................ 4.04
¬4.07
Levels: Power-assisted steering pump ............................................................................................................ 4.08
Coolant .................................................................................................................................................. 4.09
Brake fluid ............................................................................................................................................ 4.10
Windscreen/headlight washer reservoirs ...........................................................................................4.11
Air filter ............................................................................................................................................................. 4.12
Hood maintenance ............................................................................................................................................ 4.13
Bodywork maintenance ......................................................................................................................... 4.14 - 4.15
Interior trim maintenance ................................................................................................................................ 4.16

Downloaded from www.Manualslib.com manuals search engine 1
2
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T4.WIN 24/2/2001 14:35-page2
4.02
BONNET
To open the bonnet, pull handle1.Bonnet security lock
To unlock, lift catch2.
Take care when working
in the engine compartment
as the engine cooling fan
maycutinatanymoment
without warning.

Downloaded from www.Manualslib.com manuals search engine 34
54
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T4.WIN 24/2/2001 14:35-page3
4.03
BONNET(continued)
Lift the bonnet, release stay4from
its holder3and, for your own safety,
it isvery importantto fix it into
retainer5in the bonnet.To close the bonnet, refit stay4in its
holder3, grip the bonnet in the
middle and lower it down to 8
inches (20 cm) above the closed
position, then release. It will lock
automatically under its own weight.
Ensure it is correctly
locked.Anyoperationonor
modification to the fuel
supply system (computers,
wiring, fuel circuit,
injector, protective covers...) is
strictly forbidden due to the safety
risks it may entail (except for
qualified staff from the Renault
network).
Before closing the bonnet, check to
make sure that nothing has been
left in the engine compartment.