buttons RENAULT MEGANE 2000 X64 / 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine 3
A
2
1
43
0
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T1.WIN 24/2/2001 14:26-page53
1.47
HORN AND WARNING LIGHTS
Horn
Press buttons1or2on the steering
wheel bossA.
Headlight flasher
Pull stalk3towards you at right
angles to flash the headlights, even
if the lights are not in use.
“Hazard” warning lights
Press switch4.
This switch illuminates all four
direction indicators simultaneously.
It is to be used to warn other road
users if you:
• are obliged to stop for any reason
beyond your control in a
forbidden location,
• are obliged to drive under
particular conditions.
Direction indicators
Move stalk3parallel to the steering
wheel and in the direction you are
going to turn.
When driving on a motorway, the
steering wheel is not usually turned
sufficiently to return the stalk
to0automatically. There is an
intermediate position in which the
stalk may be held when changing
lanes.
It will return automatically to0
when released.

Downloaded from www.Manualslib.com manuals search engine 1
1
2
3
3
4
5
6
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page29
3.29
ROADBOX: FITTING
With the vehicle hood folded down
and the hood compartment cover
open
•Remove bolts1.•Removebolts3from the seat base.
• Lift up seat base2and remove it
from the vehicle.• Unclip rear seat belts5by
pressing buttons6.
• Thread the seat belts through the
belt guide4to release the seat
back.
• Take the seatback out of the
vehicle.

Downloaded from www.Manualslib.com manuals search engine 1
3
6
57
8
4
2
1
9
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T3.WIN 24/2/2001 14:31-page32
3.32
ROADBOX: REMOVING
With the vehicle hood folded down
and the hood compartment cover
open
•Disconnect the wiring harness2.
• Remove bolts1.• Open lid3.
•Removebolts4.• Take out the roadbox5.
• Remove carpet6from the floor.
• Release the rear seat belts7by
pressing buttons8.
• Install seatbackA:
Position each seatback lug in its
housing9.