display RENAULT SCENIC 2007 J84 / 2.G Power Assisted Steering User Guide
Page 55 of 59
POWER-ASSISTED STEERING
Fault finding – Fault Finding Chart
36B
36B-55V5 MR-372-J84-36B000$924_fra.mif
EPAS
Vdiag no.: 05, 09,
0D
ALP8Assistance available but Check Steering warning message
displayed and Service indicator light continuously lit
NOTESNone.
Check the vehicle battery voltage and the condition of the electric power-assisted steering connector.
Repair and check the charge circuit if necessary.
Vdiag 05 and 09: Check status ET020 Steering wheel angle programming which should be STATUS 4. If not,
program the steering wheel angle sensor VP004 Steering wheel angle programming (see Configuration and
programming).
If the fault is still present, contact the Techline.
AFTER REPAIRPerform a test using the diagnostic tool.
DAE_V05_ALP8/DAE_V09_ALP8/DAE_V0D_ALP8
Page 59 of 59
POWER-ASSISTED STEERING
Fault finding – Fault Finding Chart
36B
36B-59V5 MR-372-J84-36B000$924_fra.mif
EPAS
Vdiag no.: 05, 09,
0D
ALP12The engine does not start and the message "steering not
unlocked" or "steering not locked" is displayed after switching
the ignition off
NOTESSpecial notes:
These messages are not displayed because of an electric power-assisted steering
failure.
Check the UCH (see 87B, Passenger compartment connection unit)
If the fault is still present, contact the Techline.
AFTER REPAIRPerform a test using the diagnostic tool.
DAE_V05_ALP12/DAE_V09_ALP12/DAE_V0D_ALP12