bulb RENAULT SCENIC 2008 J84 / 2.G Gas Injection LPG 3000 Workshop Manual

17C-2
MR-372-J84-17C000$059.mif
V2
17C
GAS INJECTION
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedures applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma.
Type of diagnostic tools
–CLIP + multiplex line sensor
Special tooling required
3. REMINDERS
Procedure for Mégane 2
To carry out fault finding on the vehicle's computers, switch the ignition to fault finding mode (forced + after ignition).
Proceed as follows:
–Put the vehicle card in the card reader.
–Press and hold Start button (longer than 5 seconds) with start-up conditions not fulfilled.
–connect the diagnostic tool and perform the required operations.
To cut off the + after ignition feed, proceed as follows:
–disconnect the diagnostic tool,
–press the Start button twice briefly (less than 3 seconds),
–ensure that the + after ignition feed has been cut off by checking that the computer indicator lights on the
instrument panel have gone out.
Procedure for Logan
To run fault finding on the vehicle computers, switch on the ignition. Connect the diagnostic tool and perform the
required operations.Vehicle (s): LOGAN and MEGANE 2
Function concerned: Gas Injection
Engines: K4M 764/788/698Computer name: GAS 3000
Program No.: AB
Vdiag No.: 08/10
Special tooling required
Multimeter
Elé. 1681 Universal bornier
Note:
The left-hand and right-hand xenon bulb computers are powered when the dipped headlights are lit.
Fault finding on these computers is therefore not possible until after the ignition has been switched on in
diagnostic mode (forced + after ignition) and the dipped beam headlights have been switched on.
GAZ3000_V08_PRELI / GAZ3000_V10_PRELI
LPG 3000
Program No: AB
Vdiag No: 08/10
MR-372-J84-17C000$059.mif