RENAULT TWINGO RS 2009 2.G Electrical Equipment Owner's Manual

80B-9
HEADLIGHTS
Halogen headlight: Adjustment
80B
ADJUSTMENT
I - PREPARATION OPERATION
aPlace the vehicle on a level horizontal working area.
aDo not apply the parking brake.
aCheck and inflate the tyres (see Tyre pressure)
(MR 411, 35A, Wheels and tyres).
aOpen the cover.
aCheck:
-that the luggage compartment is empty,
-that the headlights are clean.
aPosition the headlight beam remote adjustment con-
trol on 0.
aSwitch on the dipped headlights.
II - TEST OPERATION
aPlace a headlight adjustment and checking tool
set to -1% in front of the vehicle (see equipment ins-
tructions).
aCheck the headlight beam adjustment using the
headlight adjustment and checking tool (see the
instructions for the equipment).III - ADJUSTMENT OPERATION
aUsing the headlight adjustment and checking
tool :
-perform lateral adjustment of the headlight using
the screw (1) ,
-adjust the headlight beam by using the screw (2) .
IV - FINAL OPERATION.
aClose the bonnet. Equipment required
headlight adjustment and checking tool
Note:
Do not get into the vehicle throughout the opera-
tion.
119377

80B-10
HEADLIGHTS
Front fog light: Removal - Refitting
80B
REMOVAL
I - REMOVAL PREPARATION OPERATION
Removing the left-hand fog light bulb
a
aPosition the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
aRemove:
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection).Removing the fog light bulb
aRemove:
-the lower bolts (1) of the front wheel arch liner,
-the bolt from the front section of the engine under-
tray on the side concerned.
Removing the fog light
aPosition the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
aRemove:
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection). D4F, and 780
Note:
The front bumper must be removed in order to
remove the left-hand fog light bulb.
K4M, and 854
119264

80B-11
HEADLIGHTS
Front fog light: Removal - Refitting
80B
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Removing the fog light bulb
a
aDisconnect the fog light connector.
aTurn the fog light bulb (3) a quarter of a turn anti-
clockwise by reaching through
b (2) .
aaTurn the fog light bulb (4) a quarter of a turn anti-
clockwise.
aRemove the fog light bulb.
2 - Removal of the fog light
aRemove:
-the bolts (5) from the front fog light,
-the front fog light. K4M, and 854 – D4F or D7F or K9K
Note:
For D4F/780 engines, the right-hand fog light
bulb is accessed from under the vehicle.
121079
D4F, and 780
Note:
The front bumper must be removed in order to
remove the left-hand fog light bulb.
121079
121079

80B-12
HEADLIGHTS
Front fog light: Removal - Refitting
80B
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
1 - Refitting the fog light bulb
aReplace the fog light bulb with an approved bulb.
aRefit the fog light bulb.
aTurn the fog light bulb a quarter of a turn clockwise.
aConnect the fog light connector.
2 - Refitting the fog light
aRefit the front fog light.
II - FINAL OPERATION.
Refitting the left-hand fog light bulb
aRefit:
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
-the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres).
Refitting the fog light bulb
aRefit:
-the lower bolts of the front wheel arch liner,
-the bolt for the front section of the engine undertray
on the side concerned.
Refitting the fog light
aRefit:
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),-the front wheel arch liners (see Front wheel arch
liner: Removal - Refitting) (55A, Exterior protec-
tion),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres).
D4F, and 780
K4M, and 854

80B-13
HEADLIGHTS
Side indicator: Removal - Refitting
80B
REMOVAL
OPERATION FOR REMOVAL OF PART
CONCERNED
aUnclip the side indicator (1) using a small flat-blade
screwdriver (2) .
aRemove the side indicator (1) from the bulb moun-
ting (3) by turning it a quarter of a turn anti-clockwi-
se.
REFITTING
REFITTING OPERATION FOR PART CONCERNED
aIf the side indicator bulb is replaced, use a W5W ap-
proved bulb.
aRefit the side indicator on the bulb mounting by tur-
ning it a quarter of a turn clockwise.
aFit the side indicator onto the front wing.
119384
121206

81A-1
REAR LIGHTING
Rear lighting: List and location of components
81A
I - LIST OF COMPONENTS
II - LOCATION OF COMPONENTS
1 - Signalling light switch
To remove the signalling light switch (see 84A, Con-
trol - Signals, Signals and lighting switch: Removal
- Refitting, page 84A-8) .2 - UCH
The UCH is located in the dashboard, above the pas-
senger compartment relay/fuse box, for removal (see
87B, Passenger compartment connection unit,
UCH: Removal - Refitting, page 87B-1) .
3 - Passenger compartment fuse and relay box No. Description
(1) Signalling light switch
(2) UCH
(3) Passenger compartment fuse and relay
box
(4) Rear light on wing
(5) High level brake light
(6) License plate light
121133
119507
119504

81A-2
REAR LIGHTING
Rear lighting: List and location of components
81A
4 - Rear light on wing
5 - High level brake light6 - License plate light
119520
119532
121082

81A-3
REAR LIGHTING
Rear wing light: Removal - Refitting
81A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aSwitch off the ignition.
II - REMOVAL OPERATION FOR PART
CONCERNED
aDisconnect the connector (1) from the rear light on
the wing.
aRemove:
-the bolt (2) from the rear light on the wing,
-the rear light on the wing,
-the rear light bulbs on the wing (see 81A, Rear li-
ghting, Rear light bulb: Removal - Refitting,
page 81A-4) .
REFITTING
REFITTING OPERATION FOR PART CONCERNED
aRefit:
-the rear light bulbs on the wing (see 81A, Rear li-
ghting, Rear light bulb: Removal - Refitting,
page 81A-4) ,
-the rear light on the wing,
-the rear light bolt on the wing.
aConnect the connector for the rear light on the wing.
119533

81A-4
REAR LIGHTING
Rear light bulb: Removal - Refitting
81A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aSwitch off the ignition.
1 - Rear light bulbs on the wing
aRemove the rear light on the wing (see 81A, Rear li-
ghting, Rear wing light: Removal - Refitting, page
81A-3) .
2 - High level brake light bulb
aRemove the high level brake light (see 81A, Rear li-
ghting, 3rd brake light: Removal - Refitting, page
81A-6) .
3 - License plate light bulb
aRemove the license plate light (see 81A, Rear li-
ghting, Number plate light: Removal - Refitting,
page 81A-8) .
II - REMOVAL OPERATION FOR PART
CONCERNED
1 - Rear light bulbs on the wing
aUnclip the plate by pressing on the clips (1) .aRemove:
-the side light and brake light bulb (2) ,
-the indicator bulb (3) ,
-the rear fog light bulb (left rear light) or the rever-
sing light bulb (right rear light) (4) .
2 - High level brake light bulb
aRemove the high level brake light bulb (5) .
119535
119536
119534

81A-5
REAR LIGHTING
Rear light bulb: Removal - Refitting
81A
3 - License plate light bulb
aUnclip the light at (6) .
aRemove the license plate light bulb.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a
1 - Rear light bulbs on the wing
aRefit:
-the side light and brake light bulb (P21/5W),
-the indicator bulb (PY21W),
-the rear fog light bulb (left rear light) or the rever-
sing light bulb (right rear light) (P21W).
2 - High level brake light bulb
aRefit the high level brake light bulb (W16W).
3 - License plate light bulb
aRefit the license plate light bulb (W5W).II - FINAL OPERATION.
1 - Rear light bulbs on the wing
aRefit the rear light on the wing (see 81A, Rear li-
ghting, Rear wing light: Removal - Refitting, page
81A-3) .
2 - High level brake light bulb
aRefit the high level brake light (see 81A, Rear li-
ghting, 3rd brake light: Removal - Refitting, page
81A-6) .
3 - License plate light bulb
aRefit the license plate light (see 81A, Rear lighting,
Number plate light: Removal - Refitting, page
81A-8) .
121080
Note:
When replacing a bulb, only use approved bulbs.