Seat Ibiza 2018 Owner's manual

Start and driving

It lights up
Fault in the management of the petrol engine.
Have the engine check ed by a specialised w
orkshop
as soon as possible.
The warning lamp  (Electronic P
ower Control)
lights up when the ignition is switched on while sys-
tem operation is being verified. It should go out once
the engine is started. 
It lights up
Diesel engine glow plug system.
The engine glo w plug syst

em has been activated.
The engine can be started straight away when the
lamp switches off. 
Flashes
Fault in the management of the diesel engine.
Have the engine check ed by a specialised w

orkshop
as soon as possible. Note
While the control lamps are on , ;, 
or  there might be f aults in the engine

,
fuel consumption may go up and the en-
gine might lose power. Catalytic converter
To maintain the useful life of the catalytic
conver
t

er

Driving

Driver assistance systems
Driver assistance systems
St ar
t
-Stop system*
Control lamps 
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is activ
e.i
It lights up
The Start-Stop system is not available. Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated.
Start the engine manually
This driv er message is displ

ayed when cer-
tain conditions are not met during the stop-
ping phase and the Start-Stop system can-
not restart the engine. The engine must be
started manually.
Start-Stop system: Fault! Function
not available
There is a fault in the Start-Stop system. Take
the vehicle to a workshop to have the fault re-
paired. Description and operation
Fig. 225
Related video The Start-Stop system helps save fuel and
reduce CO
2 emissions.
In St art

-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping; for example when stopping at traf-
fic lights. The ignition remains switched on
during the stopping phase. The engine auto-
matically switches back on when required. In
this scenario, the light of the    button stays lit
1)
.
As soon as the ignition is s wit
ched on, the
St

art-Stop function is automatically activa-
ted.
Further information about the Start-Stop sys-
tem can be found on the Easy Connect sys-
tem: by pressing the button  /  in the Ve-
hicle status menu. Vehicles with a manual gearbox

Driving

Driver assistance systems
CAUTION
The Start-Stop system must always be
swit ched off when driving thr
ough flooded
areas

Driving
Cruise control operation Fig. 227
Instrument panel display: CCS status
indications. Read the additional information carefully

Driver assistance systems
Speed limiter Contr ol l
amp

Driving
Operate the speed limiter Fig. 229
On the left of the steering column:
control and butt ons t
o operate the speed limit-
er. Fig. 230
On the left of the steering column:
third l e
ver for operating the speed limiter. Function
Position of the turn signal lever

Driver assistance systems
Function
Position of the turn signal lever

Driving
After overtaking, the speed limiter can be
s wit
ched on with the pr
eviously set speed by
pressing button 3 on the turn signal lever in
the ar ea


 or by moving the third lever into
pressure point .
Switch the speed limiter off temporarily by
pressing down the accelerator (kick-
down)
If the accelerator is pressed right down (kick-
down) and the set speed is exceeded be-
cause driver wishes to do so, the limiter is
temporarily disabled.
To confirm it being switched off an acoustic
signal sound once. While the limiter is off, the
warning and control lamp