Activate Seat Ibiza 2020 Owner's manual

Seat belts
belt webbing, contact a specialised work-
shop f
or help with any special de
vices to
ensure the optimum protection of the seat
belt and airbag. SEAT recommends taking
your car in for technical service. Seat belt tensioners
Ho w the seat belt t

ensioner worksThe seat belts for the front seats and the side
r
ear seats 1)
ar

e equipped with belt tensioners.
The belt tensioners are activated by sensors,
although only in severe head-on, lateral and
rear-end collisions. This retracts and tightens
the seat belts, reducing the forward motion of
the occupants.
The belt pre-tensioners work in combination
with the airbag system. In case of overturn,
the pre-tensioners do not activate unless the
head airbags are deployed. Note

Safety
Operation of the airbags Airbag syst em contr
ol lampsT
It lights up on the combi-instru-
ment
Fault in the airbag system and seat belt tensioners .
Have the syst
em checked immediately by a special-
ised workshop.  
It lights up on the dash panel
Fault in the airbag system.
Hav e the syst

em checked immediately by a special-
ised workshop.
Front passenger front airbag deactivated.
Check if the airbag shoul d be k

ept deactivated x
It lights up on the dash panel
Front passenger front airbag activated.
The control l
amp turns off automatically 60 seconds
after the ignition is switched on Several warning and control lamps light up
f
or a f

ew seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
If the airbag and seat belt tensioner system
control lamp T remains on or flashes, it indi-
cates a malfunction in the airbag and seat
belt tensioner system ››› . Have the systemchecked immediately by a specialised work-
shop
.
If the fr

ont passenger airbag is deactivated,
the warning lamp      re-
mains lit on the dash panel to remind you that
the airbag is deactivated. If, with the front
passenger airbag deactivated, this lamp
does not remain lit or if it is lit along with the
control lamp T on the instrument panel,
there is a fault in the airbag system ››› . If
the contr ol l

amp is flashing, there is a fault in
the disabling of the airbag system ››› . Have
the syst em check

ed immediately by a speci-
alised workshop. WARNING
In the event of a fault in the airbag and seat
belt t ensioner syst

em, the airbags and seat
belts may not trigger correctly, may fail to
trigger or may even trigger unexpectedly.

Safety
Activate and deactivate front pas-
senger fr ont airbag*Fig. 16
Switch for activating and deactivating
the fr ont passenger airbag. Fig. 17
Central part of the dashboard: control
l amp f
or the deactivation of the front passen-
ger front airbag. Deactivate the front passenger front airbag
only if you hav
e t

o use a rear-facing child
seat in the front passenger seat. SEAT recommends fitting the child seat in the
rear seat t

o avoid having to deactivate the
front passenger airbag.
When the front passenger airbag is deacti-
vated, this means that only the front passen-
ger front airbag is deactivated. All the other
airbags in the vehicle remain activated.
Deactivate and activate the front passen-
ger front airbag

Operation
Assist systems and vehicle settings Fig. 78
Schematic representation: Assist systems
and v ehicl
e settings The number of assist systems and settings
depend on the v
ersion and the country in
question.

v Driv

er assistance

v Park assist ››› page 234
.
v
Activat e / deactivate ESC, stabilisation
systems and brake assist ››› page 231
.

v Activate / deactivate the Start-Stop sys-
tem ››› page 196
.
v
Adaptive cruise contr ol (ACC)
››› page 222.

v Emergency brake assistance system
(Front Assist) ››› page 219
.

v Fatigue detection ››› page 76
.
90

Instruments and warning/control lamps
Multifunction steering wheel* Oper ation of the audio
, telephone and navigation system with voice control Fig. 79
Controls on the steering wheel. The steering wheel includes a multifunction
modul
e fr

om where it is possible to control the audio, telephone and radio/navigation
functions without needing to distr
act the driv-
er.
Applies to vehicles with analogue instrument panel Button
Radio MediaTelephone* Navigation*
A Turn
Turn volume up/down.
Turn volume up/down. Turn volume up/down.Turn announcement volume up/down.
A Press
Mute volume.
Mute volume. Mute incoming call.Mute voice navigation
B a)
Activate/deactivate voice control. b)
This function can be used fr om any mode

, except in the case of an active call.
C /
D Search for the previous/next sta-
tion
c)
. Short press: S
wit
ch to the previ-
ous/next track.
Long press: Fast rewind/forward d)
.

Lights
Note
“Tourist light” is only allowed temporarily. If
you ar e pl
anning a long stay in a country
that drives on the other side, you should
take the vehicle to an Authorised Technical
Service to change the headlights. Interior lights
Lighting of the instrument panel ,
displ

ays and switches Depending on the model, the lighting of the
instrument clust
er and s

witches can be ad-
justed in the infotainment system, using the
button    ! SETT,NGS ! Light !
,nterior lighting
››› page 90
.
With the ignition on and without light activa-
tion, the analogue instrument panel lighting
remains activated in daytime light conditions.
The lighting is reduced as the exterior light di-
minishes. In some cases, e.g. when driving
through a tunnel without the  function ac- tive, the instrument panel lighting may even
switch off. The objective of this function is to
provide the driver with a visual indication that
he or she should activate the dipped beam.
If your vehicle is equipped with a digital in-
strument panel (Digital SEAT Cockpit), the following message will appear
Turn on the
lights on the instrument panel.
Interior and reading lights Fig. 103
Detail of roof lining: front lighting of
the passenger compartment. Knob Function
 Turns off the interior lights.
 Turning the interior lights on or off.
 The interior lights come on automati-
cally when you unl
ock the v

ehicle,
open a door or remove the key from
the ignition.
The light goes out a few seconds after
closing all the doors, when locking the
vehicle or connecting the ignition.
* /
 Turning the reading light on and off The light controls may vary depending on the
v
ehicl

e version.
Luggage compartment lighting
The light is activated when the rear lid is
open, even when the ignition and lights are
turned off. For this reason, ensure that the
rear lid is always closed.
Ambient light*
The ambient light lights up the area of the
centre console and the footwell area and,
depending on the version, the front door pan-
els as well.
It will be switched on at full brightness when
the doors are opened and the lights will be
dimmed during driving, when the light selec-
tor is set to ,  or .
The intensity of the background light can be
adjusted through the infotainment system
menu. The colour can also be changed in
versions with lighting on the front door panel
(button    ! SETT,NGS ! Back-
ground lighting
››› page 86
). Note
If not all the vehicle doors are closed, the
int erior lights will be s

witched off after ap-
prox. 10 minutes, providing the ignition key
has been removed and the courtesy light
position selected. This prevents the battery
from discharging. 121

Data transfer
Data transfer
SEAT CONNEC T
Intr
oduction To use it, SEAT CONNECT must first be activa-
t
ed online by ent

ering into a SEAT CONNECT
contract with SEAT, S.A. and is subject to a
temporary use limitation depending on the
country.
Both the SEAT CONNECT service portfolios
offered by SEAT and individual services can
be modified, cancelled, deactivated, reacti-
vated, renamed and extended, even without
prior notification.
In https://my.seat you can create the user
account, see the description of services and
more information.
The execution and availability of the SEAT
CONNECT services and service portfolios
may vary depending on the country, as well
as the vehicle, its equipment and connectivi-
ty. Connectivity statuses )
(whit
e) Full connectivit
y, all services active
) (gr
ey) Limit
ed connectivity, some services
may not be av ail
able.
no icon No connectivity, no services availa-
bl
e

. SEAT CONNECT's voice recognition or search
t
echnol

ogy does not recognise or offer re-
sults for all words.
There are SEAT CONNECT services for which
registration is mandatory and others for
which it is not mandatory.
Description of services
Before running SEAT CONNECT services,
read and take into account the description of
the corresponding services. Descriptions are
updated non-periodically and are available
online at https://my.seat.

Data transfer
the possibility of accessing the data regis-
t er
ed through SEAT CONNECT and control
certain functions of your vehicle.
In the infotainment system you can check if
your vehicle is assigned to a person as the
main user. In this case, you can register your-
self as the main user of the vehicle and thus
automatically delete the previous main user.
Alternatively, through the infotainment sys-
tem you can directly and permanently delete
the previous user as the main user, as well as
put the vehicle in offline mode and thus limit
both the communication of your vehicle with
the SEAT, S.A. data server and the processing
of personal and vehicle data.
Deactivating SEAT CONNECT serv-
ices The following functions are available in the
inf
ot

ainment system to deactivate and acti-
vate SEAT CONNECT services:

Infotainment system
Privacy and Services Settings
SEAT CONNEC T services can be activ
ated
and deactivated individually. To do this, just
check the box corresponding to the service
you want to activate or deactivate. Use the
privacy mode option if you want to deacti-
vate all of the services at the same time.
Privacy mode
Allows you to deactivate or activate the serv-
ices depending on the selected privacy level. x
T r

acking Share location. Main users and co-
users can vie
w position dat
a on the
SEAT CONNECT portal or app.

L ocation Use l

ocation. P
osition, v ehicle, and
user data are used for services.
y
P ersonal No l

ocation. Only the v
ehicl e data
and user data are used for services.

Incognito Maximum priv

acy. Y
our services ar e
disabled. Only services required for
legal reasons use data. Setting options are not available in all mar-
k
ets or in all v

ehicle models. Note
If you deactivate each and every SEAT
CONNEC T service

, the OCU may continue
to transmit data. Full Link
Intr oduction With Full Link it is possible to view and use the
cont
ents and functions that ar

e shown on the
mobile phone device on the infotainment
screen.
To do this, the mobile phone device must be
connected with the infotainment system
through a USB interface.
Some technologies can also be used by
Wireless Full Link through the Bluetooth® in-
terface and a Wi-Fi connection.
The following technologies may be availa-
ble:

Driving
Ignition and start button* Fig. 137
In the lower part of the centre console:
st art butt
on. The engine can be started with a start button
(Pr
ess & Driv

e). To do so, there must be a valid
key inside the vehicle in the area of the front
or rear seats, or on the centre console.
In vehicles with the Keyless Access
››› page 98system, the engine can also be
started with the key in the luggage compart-
ment.
Opening the driver's door when exiting the
vehicle activates the electronic lock on the
steering column if the ignition is disabled.
Switching the ignition on/off manually
If you only want to switch on the ignition
(without starting the engine), briefly press the
start button once without pressing the brake
pedal or the clutch pedal ››› .The start button text
ST

ART ENGINE STOP flash-
es lik e a heartbeat when the syst
em is ready
for the ignition to be turned on or off.
Automatic ignition disconnection
If the driver leaves the vehicle, taking the key
with them but leaving the ignition on, the igni-
tion does not switch off automatically. The ig-
nition is switched off by pressing the lock but-
ton on the remote control  or by pressing
the sensor surface on the door lever
››› Fig. 88.
Automatic deactivation of the ignition on
vehicles with the Start-Stop system
The ignition is switched off automatically
when the vehicle is stopped and the auto-
matic engine shutdown is active, if: