SKODA CITIGO 2018 Owners Manual

Inflation pressure for increased driving comfort at half load (slightly in-
creased fuel consumption and emissions)
Inflation pressure for full load
Tyre pressure value on the front axle
Tyre pressure value on the rear axle
The approved tyre sizes for your vehicle are listed in the vehicle

Spare wheel
A full spare wheel is identical to the wheels mounted on the vehicle.
A temporary spare wheel is provided with a warning label on the rim. Only use
this temporary spare wheel to reach the nearest specialist garage since it is
not intended for permanent use.
Instructions for using a temporary spare wheel

field of vision which is constantly visible. This specification determines the
maximum vehicle speed with mounted all-season or “winter”tires, that may not be exceeded 1)
.
Snow chains
The snow chains improve handling in wintry road conditions.
Only fit snow chains with links and locks not larger than 15 mm. Remove the full wheel trims before installing the snow chains

Do-it-yourself
Emergency equipment and self-help
Emergency equipment
Positioning of the warning triangle
Fig. 147
Positioning of the warning trian-
gle - natural gas vehicles
The following information applies to the warning triangle from the

CAUTIONScrew the jack back to its starting position prior to putting it back in its box -
otherwise, there is a risk of damage to the box.
Note
The declaration of conformity is included with the jack or the log folder.
Changing a wheel
Preliminary work
For safety

Removing/stowing the spare wheelFig. 150
Take out the wheel
The spare wheel is located in a well under the floor covering in the luggage
compartment and is fixed in place with a fastening screw

Anti-theft wheel boltsFig. 152
Anti-theft wheel bolt and at-
tachment
The anti-theft wheel bolts protect the wheels from theft. This can only be

The jacking points are located on the lower sill

Air compressor (the layout of the controls may be different depending on
the type of air compressor delivered with the vehicle)
Tyre inflation hose
Button for tyre pressure reduction
Tyre inflation pressure indicator
12 volt cable connector
ON and OFF switch
Tyre inflator bottle with sealing agent
Replacement valve core
Note
The declaration of conformity is included with the air compressor or the log
folder.
Preparing to use the breakdown kit

WARNING
vIf the tyre does not inflate to at least. 2.0 bar, the damage is too great.
The sealing agent cannot be used to seal the tyre.