SKODA KAMIQ 2020 Owner´s Manual

The engine makes noises after the cold start
The increased running noise is due to the briefly in-
creased engine speed. This is not a defect.
START STOPUsage
The START STOP system reduces environmentally
damaging emissions, including CO 2, and saves fuel.
If the system determine that the engine is not nee-
ded when the vehicle stops, it turns o

Automatic gearbox
Lever positions
Parked vehicle The drive wheels are
locked.
Only set the posi-
tion when the vehi- cle is stationary.
Reverse gear
Only set the posi-
tion when the vehi- cle is stationary.
Neutral
There is no transmission of engine power to the
wheels.
Forward drive / sports program
The gear is changed automatically.
In
mode, the gear is changed at higher speeds
than in mode.
Choose between and (spring-loaded posi-
tion)
Moving the selector lever out of the
or position
lights up - the selector lever is locked

If the engine threatens to over-rev

Operation
Select driving mode

Distribution of the load over the vehicle and trailer
combination

WARNING
Danger of brake failure!
If the brake fluid change date is exceeded, heavy
braking may cause vapour bubbles to form in the
brake system.
Troubleshooting
Brake fluid level is too low
illuminates

Multi-Collision Brake (MCB)
MCB helps to decelerate and stabilize the vehicle af-
ter a collision with an obstacle. This reduces the risk
of further collisions.
Operating conditions
q There has been a frontal, side and rear collision of
a certain severity.
q The impact speed was greater than 10 km/h.
q The brakes, ESC and other required systems re-
mained functional after the impact.
q The accelerator pedal is not pressed.
Trailer Stability Assist (TSA)
TSA helps to stabilize the trailer. As the trailer begins
to lurch, TSA stabilizes the trailer by slowing down
the individual vehicle wheels.
Operating conditions
q The hitch was supplied from the factory or pur-
chased from

Settings
Automatic activation
Front Assist is automatically activated when the igni-
tion is switched on.
Activation/deactivation in the instrument cluster
In the display in the Assist systems menu item.
Activation / deactivation and setting in Infotain-
ment
In the menu:

Show system deactivation in the display of the in-
strument cluster
illuminates together with
or
illuminates together with
Deactivate Front Assist when handling the vehi-
cle on a truck, a car ferry etc.
Troubleshooting
Front Assist is not available

Variant with GRAA Activate GRA (condition for the subsequent
activation of the limiter).
To activate the speed limiter , press button D
or
E
.
Deactivate limiter
Interrupt control (sprung position)
B Resume control1)
/Increase limitC Start control with current speed/Reduce
limitDDepending on the equipment:
Switch between GRA and speed limiter
Or:
Show menu of assist systems - Possibility of
switching between GRA and speed limiter
Switching to GRA interrupts the control.
EShow menu of assist systems - Possibility of
switching between GRA and speed limiter
Switching to GRA interrupts the control.
Adjusting the speed limit with the buttons
B
and
C
By pressing in steps of 1 km/h.
By holding in steps of 10 km/h.
Variant with ACCActivate ACC (condition for the subsequent
activation of the limiter). To activate the limit-
er, press button A
.
Resume control 1)
/Increase limit in steps of 1
km/h (sprung position)Interrupt control (sprung position)Deactivate the limiterIncrease limit in steps of 10 km/hDecrease limit in steps of 10 km/hStart control/Reduce limit in steps of 1 km/hAChange between ACC and speed limiter (by
switching to GRA, control is interrupted)
Limit exceeded