SKODA OCTAVIA TOUR 2009 1.G / (1U) Owner's Manual

Fuses and light bulbs
200Main beam light and low beam lightChange light bulb for main beam light and low beam light
– Switch the ignition and all lights off.
– Open the bonnet.
– Remove the cover of the headlight.
– Hold the sprung wire clamp and disconnect the plug .
– Unhook the sprung wire clamp by pressing in direction of the light
bulb and fold it in direction of arrow.
– Remove the light bulb and insert the new light bulb in such a way that the fixing lug on the reflector lies in the corresponding recess in
the lamp plate.
– Fold the sprung wire clamp over the lamp holder and press it until it
locks into the holder.
–Plug in plug.
– Insert the cover of the headlight. Note
Get the headlight setting checked by a specialist garage after replacing the light
bulb.Fog lights*Change light bulbs for fog lights
– Switch the ignition and all lights off.
– Open the bonnet.
– Turn the plastic cover of the head
light towards the middle of the
vehicle and remove it.
– Disconnect the plug connector .
– Unhook the sprung wire clamp out of the slots of the lamp housing and fold it down.
– Remove the halogen lamp with cable. Insert the new halogen lamp in such a way that the fixing lug on th e reflector lies in the corresponding
recess in the lamp plate.
Fig. 184 Change light bulbs
for main beam lights and low
beam lights
AB
AA
AB
A1
Fig. 185 Change light bulbs
for fog lights
ABAA
s2ig.book Page 200 Monday, November 10, 2008 11:20 AM

Fuses and light bulbs201
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
– Close the sprung wire clamp over the plate. Press together the sprung
wire clamp and lock together again.
–Plug in plug.
– Insert the plastic cover.
NoteGet the headlight setting checked by a specialist garage after replacing the light
bulb.Turn signal light (at the front)Changing light bulb for turn signal light (at the front)
– Switch the ignition and all lights off.
– Open the bonnet.
– Unscrew the screw .
– Push the lamp out in direction of arrow ⇒fig. 186 .
– Turn the holder with the light bu lb to the left and pull it out. – Press the defective light bulb into the socket, turn to the left and
remove.
– Press a new light bulb into the socket and turn the light bulb to the right as far as the stop.
– Insert the holder with the light bulb into the housing of the turn signal
light and turn it to the right up to the stop.
– Push the housing of the turn signal light back in such a way that the guide lugs lock into the circlips of the main headlight.
– Screw in the screw .
Light unit (Octavia)Changing light bulbs in the lamp holder
– Switch the ignition and all lights off.
– Open the boot lid/luggage compartment door.
– Raise the floor covering.
– Press off the catches in the direction of arrow ⇒fig. 187 and take out
the lamp holder.
Fig. 186 Removing the light
bulb for the turn signal light
A1
A1
Fig. 187 Luggage compart-
ment: Light bulb holder
s2ig.book Page 201 Monday, November 10, 2008 11:20 AM

Fuses and light bulbs
202
– Press the defective light bulb into the socket, turn to the left and remove.
– Insert the new light bulb and turn it to the right up to the stop.
– Insert the light bulb holder again, the flexible tongues must lock in place.
– Push the cover back into place.Rear light unit (Combi)Changing light bulbs in the lamp holder
– Switch the ignition and all lights off.
– Open the boot lid/luggage compartment door.
– Open the relevant storage compar tment in the luggage compartment.
– Press off the flexible tongue in direction of arrow ⇒fig. 188 and
remove the lamp holder.
– Press the defective light bulb into the socket, turn to the left and remove.
– Insert the new light bulb and turn it to the right up to the stop. – Insert the light bulb holder again, the plastic tongue must lock in
place.
Licence plate lightChanging light bulbs of licence plate light
– Switch the ignition and all lights off.
– Open the boot lid and unscrew the light glass.
– Take the faulty bulb out of the holder and insert a new one.
– Re-insert the light glass. Press the light glass in up to the stop - check for correct seating of the sealing rubber.
– Screw on the light glass but not too tightly.
Fig. 188 Luggage compart-
ment: Light bulb holder
Fig. 189 Licence plate light:
Replacing light bulb
s2ig.book Page 202 Monday, November 10, 2008 11:20 AM

Technical Data203
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Technical DataTechnical DataGeneral informationThe details given in the official vehicle registration documents always take prece-
dence over the details in th e Owner's Manual. Please refer to the official vehicle
registration documents or consult a specia list garage concerning the engine with
which your vehicle is equipped.Used abbreviationsPerformancesThe listed performance values were determined without performance-reducing
equipment, e.g. air conditioning system.
WeightThe loading capacity is reduced in line with the range of the special equipment. The
unloaden weight contains a fu el tank topped up to 90%. A driver with a weight of
75 kg is also included in the value.Identification detailsVehicle data sticker
The vehicle data sticker ⇒fig. 190 is located on the floor of the luggage compart-
ment and is also stated in the Service schedule.
The vehicle data sticker co ntains the following data:
Vehicle identificati on number (VIN)
Vehicle type
Abbreviation
Importance
kW
Kilowatt, measuring unit for the engine output
rpm
Engine revolutions per minute
Nm
Newton meter, measuring unit for the engine torque
CO2 in g/km
discharged quantity of carbon dioxide in grams per driven kilom-
eter
RON
Research octane number, measur ing unit for the knocking resist-
ance of petrol
M5
5-speed manual gearbox
PD
Unit injector engine
Fig. 190 Vehicle data sticker
A1A2
s2ig.book Page 203 Monday, November 10, 2008 11:20 AM

Technical Data
204Gearbox code, paint number, interior equipment number, engine output,
engine code
Partial description of the vehicle
Vehicle identification number (VIN)
The vehicle identification num ber - VIN (vehicle body number) is stamped into the
engine compartment on the right hand shoc k absorber dome. This number is also
located on a sign on the lower left hand edge below the windscreen (together with
a VIN bar code).
Engine number
The engine number is stamped into the engine block.
Type plate (production plate)
The type plate is located in the engine co mpartment at the front on the left hand
shock absorber dome.
Homologation sign
The homologation sign is located on the lo ck carrier. Vehicles for certain countries
do not have an homologation sign.
Sticker on inside of fuel filler flap
The sticker is affixed to the inside of the fuel filler flap. The sticker contains the
following data:
•
The prescribed types of fuel,
•
Tyre si z e,
•
Tyre pressure.
Fuel consumption according to the regulations (99/100/EU)Depending on the range of the special equipment, style of driving, traffic situation,
weather influences an d vehicle condition, the consum ption values which in prac-
tice result when using the vehicle ca n deviate from the indicated values. Urban traffic
The consumption measurement in urban traf
fic begins with starting of the cold
engine. Afterwards the normal urban traffic is simulated.
Non-urban traffic
For the consumption measurement in non-ur ban traffic the vehicle, as in daily
motoring, is accelerated and braked several times in all gears. The vehicle speed
changes within the range from 0 to 120 km/h.
Combined traffic
The consumption value in the combined traf fic consists of 37% from the value for
the urban traffic and of 63% from the value for the non-urban traffic.A3A4s2ig.book Page 204 Monday, November 10, 2008 11:20 AM

Technical Data205
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
DimensionsDimensions (mm)
OCTAVIA
CO M B I
Length
4507
4513
Width
1731
1731
Width including exterior mirror
1984
1984
Height
1431/1455
a)
a)The value is valid for vehicles with rough road package.
1457/1481
a)
Wheel base
2512
2512
Tr a c k g a u g e f r o n t / r e a r
1513/1494
1513/1494
Clearance
134
134
s2ig.book Page 205 Monday, November 10, 2008 11:20 AM

Technical Data
2061.4 ltr./55 kW - EU4Engine
Performances
Fuel consumption (in ltr./100°km) and CO
2 emission (in g/km)
Power output
kW per rpm
55/5000
Maximum torque
Nm per rpm
126/3800
Number of cylinders
4
Displacement
cm3
1389
Fuel - unleaded petrol min. RON
95
OCTAVIA - M5
CO M B I - M 5
Maximum speed
km/h
171
171
Acceleration 0 - 100 km/h
s
15,3
15,5
OCTAVIA - M5
COMBI - M5
Urban consumption
9,1
9,1
Non-urban consumption
5,4
5,4
Consumption - combination
6,8
6,8
CO2 emission - combination
163
163
s2ig.book Page 206 Monday, November 10, 2008 11:20 AM

Technical Data207
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Capacities (in liter)
Weight (in kg)
Fuel tank capacity/of which spare
55/7
Reservoir for windscreen washer system/ with headlight cleaning system
3/5,5
Engine oil
a)
a)Oil capacity with oil filter change. Inspect oil
level according to filling - see Owner's Manual.
3,2
Cooling system of the vehicle
5,5
OCTAVIA - M5
COMBI - M5
Permissible gross weight
1750
1770
Unloaden weight ready for work
1175
1190
Loading capacity
575
580
Loading capacity when using the TLC
525
530
Permissible front axle load
1000
1000
Permissible rear axle load
990
1000
Permissible trailer loads, trailer braked
850
a)/850
b)
a)for uphills up to 12%b)only country specific up to 8% uphill
850
a)/850
b)
Permissible trailer loads, trailer unbraked
500
500
s2ig.book Page 207 Monday, November 10, 2008 11:20 AM

Technical Data
2081.6 ltr./75 kW - EU4/EU2 DDKEngine
Performances
Fuel consumption (in ltr./100°km) and CO
2 emission (in g/km)
Power output
kW per rpm
75/5600
Maximum torque
Nm per rpm
148/3800
Number of cylinders
4
Displacement
cm3
1595
Fuel - unleaded petrol min. RON
95
OCTAVIA - M5
CO M B I - M 5
Maximum speed
km/h
190
190
Acceleration 0 - 100 km/h
s
11,8
11,9
OCTAVIA - M5
COMBI - M5
Urban consumption
9,9
10,1
Non-urban consumption
5,5
5,7
Consumption - combination
7,1
7,3
CO2 emission - combination
169
174
s2ig.book Page 208 Monday, November 10, 2008 11:20 AM

Technical Data209
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Capacities (in liter)
Weight (in kg)
Fuel tank capacity/of which spare
55/7
Reservoir for windscreen washer system/ with headlight cleaning system
3/5,5
Engine oil
a)
a)Oil capacity with oil filter change. Inspect oil
level according to filling - see Owner's Manual.
4,7
Cooling system of the vehicle
7,0
OCTAVIA - M5
CO M B I - M 5
Permissible gross weight
1790
1805
Unloaden weight ready for work
1205
1220
Loading capacity
585
585
Loading capacity when using the TLC
525
525
Permissible front axle load
1000
1000
Permissible rear axle load
990
1000
Permissible trailer loads, trailer braked
1200
a)/1400
b)
a)for uphills up to 12%b)only country specific up to 8% uphill
1200
a)/1400
b)
Permissible trailer loads, trailer unbraked
500
500
s2ig.book Page 209 Monday, November 10, 2008 11:20 AM