lights SKODA RAPID SPACEBACK 2019 Owners Manual

“Care Connect” Services
Proactive service
Fig. 12
Buttons and warning lights of the Care Connect services
The proactive service provides an overview of the technical status of your ve-
hicle and on any due service events. It is also possible to establish a connection
to the information or breakdown call centre.
Buttons and warning lights of “Care Connect”services

Instruments and warning lights
Instrument cluster

Fog lights

 Fog lights

Outside temperature
Warning lights
Driving data (multifunction display)
Total distance travelled
Distance travelled by resetting the memory (trip)
Cruise control / speed limiter
Service interval display
Information messages
Fuel gauge
Door, luggage compartment and bonnet alarm
When the door or luggage compartment / bonnet is open, a graphic warning appears in the display.
An acoustic signal will also sound if you drive the vehicle above 6 km/h when a
door is open.
Reset counter for distance travelled (trip)

Certain functions and conditions of individual vehicle systems are checked
continuously when the ignition is switched on. If there is a fault in the system, the following message will appear in the display of the instrument cluster.
As long as the faults are not rectified the messages are always shown. After
the message is displayed for the first time, the warning lights

WARNINGAlways adjust the headlight beam to meet the following conditions - other-
wise risk of accident.
v
The vehicle does not dazzle other road users, especially oncoming vehi-
cles.

v
The beam range is sufficient for safe driving.
Note

v If, with a dipped beam, the ignition is turned off, then the dipped beam will
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver

Before negotiating a long or steep gradient , reduce speed and shift down a
gear. As a result, the braking effect of the engine will be used, reducing the
load on the brakes. If, nevertheless, there is a need for additional braking, it
should be carried out at intervals.
Emergency braking warning - if it is necessary to brake hard, the system may
cause the brake lights to automatically flash, to alert the traffic behind.
New brake pads must first be “run in” because these do not initially have the
best possible braking effect. Drive especially carefully for the first 200 km or
so.
If the brake fluid level is too low, it can cause faults in the braking system

Headlights
The front of the vehicle may lift up when a trailer (accessory) is being towed
and the headlights may dazzle other road users. Set the range of the headlights

vDo not polish the films

v Do not use a high pressure cleaner on the films.
v
Rubber seals

v Do not treat the door seals and window guides deal with anything - the
protective varnish coating could be damaged.

v
Windows and door mirrors

v Do not clean the insides of the windows/mirrors with sharp objects - risk of
damage to the filaments or the antenna.

v Do not use a cloth which has been used to polish the body - this could dirty
the window and impair visibility.

v
Head / taillights

v Do not wipe head/taillights dry, do not use any sharp objects - risk of dam-
age to the protective coating and cracks forming on the headlight glass cov-
ers.

v
Reversing camera
The following instructions must be observed, otherwise there is a risk of
camera damage.

v Do not remove snow / ice with warm / hot water.

v To wash, never use a pressure washer or steam jet.

v For cleaning, do not use abrasive cleaners.

v
Door lock cylinders

v Make sure that as little water as possible gets into the locking cylinder
when washing the vehicle - there is a risk of freezing the lock cylinder!

v
Wheels

v Heavy soiling of the wheels can affect the balance of the wheels - the re-
sult can be a vibration, which can cause premature wear of the steering.
Removing snow and ice from the windscreens
Fig. 228
Installation location of the ice
scraper, removing the scraper