clock SMART FORTWO COUPE 2008 Owner's Manual
Page 274 of 314
Battery
>> Practical hints.
273
!
Never loosen or detach battery terminal
clamps while the engine is running or the key
is in the starter switch. Otherwise the alter
nator and other electronic components could
be severely damaged.
Have the battery checked regularly at an
authorized smart center.
Refer to Maintenance Booklet for maintenance
intervals or contact an authorized smart cen
ter for further information.
!
Never invert the terminal connections!
Disconnecting, removing, charg
ing, reinstalling and reconnecting
the batteryDisconnecting the battery
>Set the parking brake.
>Move the gear selector lever to park
positionP.
>Turn off all electrical accessories.
>Turn off the engine.
>Open the passenger door.
>Move the passenger seat to the rear as far
as possible.>Unscrew the carpet holder in the
passenger’s footwell (
page 234).
>Lift the carpet.
1
Footrest
2
Fastening screw
>Unscrew fastening screw
2 counterclock
wise.
>Pull footrest
1 sideways out of the vehicle.
>Read and observe safety instructions and
precautions (page 271).
G
Warning!
With a disconnected battery
• you will no longer be able to turn the
key in the starter switch.
• the gear selector lever will remain
locked in positionP.P54.10283131
Page 276 of 314
Battery
>> Practical hints.
275
>Charge battery in accordance with the
instructions of the battery charger manu
facturer.!
Only use chargers of a correct and suit
able voltage.
!
Never attempt to recharge a frozen bat
tery. Have the battery checked at a smart
center. The battery housing could be dam
aged.Reinstalling the battery
>Reinstall the charged battery. Follow the
previously described steps in reverse
order.
!
The battery, its filler caps and the ventila
tion hose must always be securely installed
when the vehicle is in operation.
Reconnecting the battery
!
Always connect the battery in the order
described below. Otherwise the vehicle’s
electronics can be damaged.
>Turn off all electrical accessories.
>Remove the key from the starter switch.
!
Never invert the terminal connections!
>Connect the battery positive lead and
fasten cover
4 (page 274).
>Connect battery negative lead
3
(
page 274).
i
After battery power (e.g. due to reconnec
tion) was interrupted, you will have to set the
clock (
page 138).
i
Have the battery’s charge status and acid
level checked at the start of the cold season at
a smart center.
G
Warning!
Never charge a battery while still
installed in the vehicle. Gases may escape
during charging and cause explosions
that may result in paint damage, corro
sion or personal injury.
Page 281 of 314
Towing
280
>> Practical hints.
2
Rear cover
>Remove cover
1 or
2 using a suitable
object to reveal the threaded hole for the
towing eye bolt.Installing towing eye bolt
>Screw towing eye bolt in clockwise to its
stop and tighten with a suitable object.
G
Warning!
High outside temperature, stopandgo
traffic, driving on long uphill grades, or
driving at high engine speed may increa
se the temperature in the engine com
partment. Therefore the area around the
air slots in the rear apron may be hot. Let
the engine cool off before touching this
area to prevent burns.P88.20293031
G
Warning!
For safety reasons, recovery or lashing
down of the vehicle by means of the tow
ing eye is not allowed. Failure to observe
this could result in the towing eye being
ripped out of its mounting and people
being injured.