SUBARU BRZ 2017 1.G Quick Reference Guide

2017 Quick Reference Guide

2
Remote keyless entry system
Remote
transmitter key
(if equipped) Access key
(if equipped)
Lock/Unlock doors
basic ope
Ration
All doors and trunk will be locked/unlocked by the following procedures carrying the access
key on your person. (The driver should always carry the access key.)
For detailed operating and safety information, please refer to
your o wner’s Manual.
Keyless access function (if equipped)
1
Locks both side doors
2
The driver’s door will be unlocked.
(To unlock other doors, briefly press the
button a second time within 3 seconds.)
3
Unlocks the trunk lid (press and hold)
4
Sounds the alarm (press and hold)
*Grip the driver’s door handle to unlock the
driver’s door. Grip the passenger’s door
handle to unlock all doors. Side door:
Unlocking the trunk lid:
34
2
1
1
2
3
4
LockUnlock*
Grip
To u c hPress
Lock sensor
(the indentation on the side
of the door handle)
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

3
Ignition switch must be in ACC or ON .
1
Turn the control switch to the side that you want
to adjust. L is for the left mirror, R is for the right
mirror.
2
Move the control switch in the direction you want
to adjust the mirror.
a djust each component
1
Seat position adjustment
2
Seatback angle adjustment
3
Vertical height adjustment (driver’s side only)
4
Seatback fold strap
Front seat
Tilt/telescopic steering wheel
Outside rear view mirror switch
1
Hold the steering wheel and push the lever down.
2
Adjust to the ideal position by moving the steering
wheel horizontally and vertically.
3
After adjustment, pull the lever up to secure the
steering wheel.
1
23
12
124
3
2
4
Getting in the rear seats:
Lift the seatback angle adjustment
lever.Getting out the rear seats:Pull the seatback fold strap.
The seat can be slid forward and backward. (Front passenger seat only)\

4
start/stop engine
Push-button ignition switch (if equipped)
Engine (ignition) switch (if equipped)
Performing the following operations when carrying the access key on your person starts the
engine or changes push-button ignition switch modes.
Starting the engine;
STEP1: Check that the parking brake is set.
STEP2: Check that the select lever is set in P (AT models).
Check that the shift lever is set in neutral (MT models).
STEP3: Firmly depress the brake pedal (AT models).
Firmly depress the clutch pedal (MT models).
The push button start system indicator light (green) will
turn on.
STEP4: Press the push-button ignition switch.
Stopping the engine;
STEP1: Stop the vehicle (AT models). While depressing the
clutch pedal, stop the vehicle (MT models).
STEP2: Shift the select lever to P (AT models). Shift the shift lever to neutral (MT models).
STEP3: Set the parking brake.
STEP4: Release the brake pedal (AT models). Release the clutch pedal (MT models).
STEP5: Press the push-button ignition switch.
STEP6: Check that the keyless access with push button start system indicator light (green) is off.
Off ( Tu r n e d o f f ) ACC (G r e e n) ON (G r e e n)
Modes can be changed by pressing the push-button ignition switch with the brake
pedal (vehicles with an automatic transmission) or clutch pedal (vehicles with a manual
transmission) released. (The mode changes each time the switch is pressed)
Changing push-button ignition switch mode
LOCK : The steering wheel is locked and the key can be
removed. (Vehicles with an automatic transmission:
The key can be removed only when the select lever
is in P.)
ACC : Some electrical components such as the power
outlet can be used.
ON : All electrical components can be used.
START : The engine can be started.
Flashes slowly
Flashes slowly
0058 Some functions are available on certain models.
00030058 For detailed operating and safety information, please refer to your Own\
er’s Manual.

5
operate s elect lever/ shift lever
Automatic transmission (if equipped)
Manual transmission (if equipped)
P = Parking/Starting the engine
R = Reversing
N = Neutral
D = Drive:
For normal driving/Temporary manual mode
driving
M = Manual mode
Manual mode driving:
To enter manual mode, shift the select lever to the M position.
While the engine switch is in the ON position or the push-button ignition switch is in
ON mode, move the select lever with the brake pedal depressed.
Temporary manual mode driving (vehicles with
paddle shift levers):
Temporary manual mode driving can be changed to by
operating the paddle shift levers while the select lever is
in the D position.
Shifting the shift lever to R
Shift the shift lever to R while lifting up the ring section.
Downshift (-)
U p s h i f t (+)

6
Main pa Rts an D opeRation
1
Headlights
2 High/low beam change, High beam flash
3
Turn signal
4 Front fog lights (if equipped)

Headlight switch/Turn signal lever/Front fog light switch (if equipped)A
1
Wiper:
To operate, push lever down/up to the following positions:
: Temporary
: Off
: Intermittent
: Low speed
: High speed
2
Intermittent interval
3
Washer/wiper dual operation
Windshield wiper and washer switchB
43
3
1
2
1
2
3
A
H
G
DI
F
J
E
B
C
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.

7
Hazard warning flasher switchC
Instrument panel light control dialD
All the turn signal lights will flash.
Use the switch to warn other drivers.
Windshield defogger/Rear window defogger switchE
Ty p e A Ty p e B
1
Windshield defogger:
The dehumidification function operates and fan speed increases.
Set the outside/recirculated air mode button to outside air mode if the recirculated air
mode is used. (It may switch automatically.)
2
Rear window defogger switch:
The rear window defogger and the outside rear view mirror defogger (if equipped) turns
on. The function will automatically turn off after approximately 15 min.
Press
Brighter
Darker
1
2
1
2

8
1
Closing
2
One-touch closing*
3
Opening
4
One-touch opening*
* : Pushing the switch in the opposite direction will stop
window travel partway.
5
Window lock switch
1
Locks both side doors
2
Unlocks both side doors
Power windows switchesH
Power door lock switchI
Trunk lid opener switchF Engine hood lock release lever G
1
2
4
5
3
1
2
Pull
Press and hold
0058 Some functions are available on certain models.
00030058 For detailed operating and safety information, please refer to your Own\
er’s Manual.

9
Fuel filler lid openerJ
Front seatbelt guide
To enable the seatbelt to be easily extended, pass the
seatbelt through the guide.
When getting in or out of the rear seats, release the
seatbelt from the guide.
Seat heater switches (if equipped)
Pull up
Rapid heating
Normal heating

10
FUnction F oR M oRe co MFoRtab Le DR iVe
Cruise control switchA
1
ON- OFF button: To activate and deactivate
2 + R E S▲ / - S E T ▼:
+RES▲ side: To increase the speed/To resume
-SET▼ side : To set speed/To decrease the speed
3
CANCEL: To cancel
Use the cruise control to maintain a set speed without
depressing the accelerator pedal.
1
2
3
2
EF
AG
CDB
u Some functions are available on certain models.
u For detailed operating and safety information, please refer to your Own\
er’s Manual.