display SUBARU FORESTER 2000 SF / 1.G Owners Manual

Audio5-13
–
CONTINUED –

Display mode
You c an selec t either the time d isp lay mod e or func tion d isp lay mod e b y
p ressing the “DISP/CLK ” b utton when the ig nition switc h is either “ACC ”
or “ON ” p osition.
Time display mode
When the time d isp lay mod e is selec ted , the time d i sp lay takes p rior-
ity of the func tion d isp lay. The time is shown on t he d isp lay whenever
the ig nition switc h is “ACC ” or “ON ” p osition.
When the rad io is turned on or the station is c hang ed d uring the time
d isp lay mod e, the time d isp lay is rep lac ed b y the f req uenc y d isp lay.
However, after the freq uenc y has b een d isp layed for five sec ond s, it
is rep lac ed b y the time d isp lay ag ain. Function display mode
When the func tion d isp lay mod e is selec ted , the tim e is not shown on
the d isp lay. The d isp lay ind ic ates the c urrent func tion only.
When the rad io is turned off d uring the func tion d i sp lay mod e, the
b ac k-up lig ht on the d isp lay g oes out.
Setting the time
1. Turn the ig nition switc h to “ACC ” or “ON ”.
2. To adjust hour: Press the “DISP ” b utton and the “TUNING ” b utton
ind ic ated with “ ” tog ether to ad vanc e the hours in one-hour inc remen ts.
Keep ing the b uttons p ressed ad vanc es the hours q uic kly.
3. To adjust minute: Press the ”DISP ” b utton and the “TUNING ” b utton
ind ic ated “
 ” tog ether to ad vanc e the minutes in one-minute inc r ements.
Keep ing the b uttons p ressed ad vanc es the minutes q u ic kly.
NOTE
If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, the time set-ting will be cleared. If this occurs, it is necessary to reset the time.

Interior equipment6-9
–
CONTINUED –

Display
HS6004BB
The d isp lay op erates when the ig nition switc h is in the “ACC ” or
“ ON ” p osition.
The d isp lay b rig htness c an b e ad justed b y p ressing the “LIGHT
CONTROL ” b utton rep eated ly to c hang e from d im to b rig ht to off.
HS6005BB
Measurement unit selection (Default setting is English units)
The following p roc ed ure is req uired to selec t measu rement units other
than Eng lish.

6-10
HS6006BB
1. Turn on the ig nition switc h to the “ACC ” p osition and the d isp lay
shows the d efault Eng lish measurement units.
2. Dep ress the “ADJ ” switc h for 5 sec ond s or more and the d isp lay
will show “DEVIATION ” tog ether with the “5 ” and “W ”.
HS6007BB
3. Chang e the measurement units b y p ressing the “MODE ” switc h
until the p rop er mod e ap p ears.
4. Press the “ADJ ” switc h to save your selec tion.
NOTE If the setting is not completed in 30 seconds, the display will
return to the initial mode. When the battery is disconnected, you may have to perform
this operation again to reset to the desired units.

Interior equipment6-15
–
CONTINUED –
Range
: 21.26 to 30.86 inHg or 720 to 1045 hp a
NOTE The reading may change during air-conditioner operation,
door window operation, driving in a tunnel, and so forth. All barometric readings reported in local weather reports are
corrected to a sea-level reading regardless of altitude. The Gauge
Pack displays true local air pressure and hence may differ signifi-cantly from local weather reports (especially at higher altitudes).The barometer is not adjustable. Since air pressure changes with altitude, the barometric read-
ing will vary when the vehicle is moving up or down an incline.For accurate barometric trending, the vehicle should be station-
ary. Altimeter
The altimeter has two mod es, Stand ard elevation mod e and Relative
elevation mod e.
HS6013BB

10-10
Recommended grade and viscosity CAUTION
Use only engine oil with the recommended grade and viscosity.
Oil grade: API classification SJ or SH with the words “ENERGY
CONSERVING II ” (if you cannot obtain the oil with SJ
or SH grade, you may use SG grade oil.) or the new
API mark (Starburst mark) displayed on the container.
New API Certification Mark (Starburst Mark)API Service label
1
2
3
1 Ind ic ates the oil q uality b y API d esig nations
2 Ind ic ates the SAE oil visc osity g rad e
3 Ind ic ates that the oil has fuel saving c ap ab ilities
In c hoosing an oil, you want the p rop er q uality and visc osity, as well
as one that will ad d to fuel ec onomy. The following tab le lists the rec -
ommend ed visc osities and ap p lic ab le temp eratures.
When ad d ing oil, d ifferent b rand s may b e used tog et her as long as
they are the same API c lassific ation and SAE visc os ity as those rec -
ommend ed b y SUBARU.
Eng ine oil visc osity (thic kness) affec ts fuel ec ono my. Oils of lower vis-
c osity p rovid e b etter fuel ec onomy. However, in hot weather, oil of
hig her visc osity is req uired to p rop erly lub ric ate the eng ine.