light SUBARU FORESTER 2006 Owners Manual

11 - 4 6
Maintenance and service
3. Disconnect the electrical connector
from the bulb.
4. Install a new bulb into the electrical
connector, then set the retainer spring se-
curely.
5. Install the bulb cover.T
High beam light bulbs
1. Disconnect the electrical connector
from the bulb.
2. Remove the bulb from the headlight
assembly by turning it counterclockwise. 3. Replace the bulb with new one.
4. Reconnect the electrical connector. At
this time, use care not to touch the bulb
surface.
5. To install the bulb to the headlight as-
sembly, turn it clockwise until it clicks.
„
Rear combination lights1. Remove the upper and lower screws.
Then, slide the rear combination lamp as-
sembly to the rear and remove it from the
vehicle.
B00387
700093B00388
B00389
ProCarManuals.com

Maintenance and service
11 - 4 7
– CONTINUED –
1) Tail/stop light
2) Backup light
3) Rear turn signal light
4) Tail/stop light2. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
3. Pull the bulb from the holder. Install a
new bulb.
4. Set the bulb holder into the rear combi-
nation light assembly and turn it clockwise
until it locks.
5. Reinstall the rear combination light as-
sembly.
„License plate light
0
1. Remove the mounting screws using a
Phillips screwdriver.
2. Remove the cover and lens.
3. Pull the bulb out of the socket. Install a
new bulb.
4. Reinstall the lens and cover.
5. Tighten the mounting screws.
„Dome light and map lightDome light
Map light1. Remove the lens by prying the edge of
1234
B00390
B00391
B00090B00091
ProCarManuals.com

11 - 4 8
Maintenance and service
the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket. Install a
new bulb.
3. Reinstall the lens.„High mount stop light
0
1. Remove the mounting screw covers by
prying the edge with a flat-head screwdriv-
er.
2. Remove the mounting screws using a
Phillips screwdriver and then remove the
high mount stop light cover.
3. Pull the bulb from the socket. Install a
new bulb.
4. Reinstall the cover.
5. Tighten the mounting screws then rein-
stall the covers.
NOTEOther bulbs may be difficult to replace.
Have your SUBARU dealer replace
these bulbs if necessary.
B00093
ProCarManuals.com

Specifications
12-5
„Tires
„ Wheel alignmentTire size
P215/60R16 94H
P215/55R17 93H
Wheel size
16 × 6
1/2 JJ
17 × 7 JJ
Pressure
Front
Light load
29 psi (200 kPa, 2.0 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Full load
29 psi (200 kPa, 2.0 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Rear
Light load
28 psi (190 kPa, 1.9 kgf/cm
2)
30 psi (210 kPa, 2.1 kgf/cm
2)
Full load
36 psi (250 kPa, 2.5 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Trailer towing
41 psi (280 kPa, 2.8 kgf/cm
2)
36 psi (250 kPa, 2.5 kgf/cm
2)
Temporary spare tire
Size
T135/80D16
T135/90D16
Pressure
60 psi (420 kPa, 4.2 kgf/cm
2)
Item
2.5-liter non-turbo models
2.5-liter turbo models
Drive system
AWD
Toe
Front
0 ± 0.12 in (0 ± 3 mm)
Rear
0.079 ± 0.12 in (2 ± 3 mm)
Camber
Front
–0°25’ ± 45’
Rear
–0 °50’ ± 45’
–0 °55’ ± 45’
ProCarManuals.com

12-6
Specifications
Fuses and circuits„Fuse panel located behind the instrument pan-
el
1 234 56
789101112
1413 15 16 17 18 19
20 21 22 23
C00000
Fuse panel
Fuse rating
Circuit
1
15A
y
Heater fan
2
15A
y
Heater fan
3
15A
y
Power door lock
y
Remote keyless entry
4
15A
y
Cigarette lighter
y
Remote controlled rear view mirrors
5
10A
y
Tail light
y
Parking light
6
15A
y
SRS airbag
7
15A
y
Fog light
8
30A
y
ABS
y
Vehicle Dynamics Control system
(models with Vehicle Dynamics
Control system only)
9
15A
y
Radio
10
Empty
11
15A
y
Engine ignition system
y
SRS airbag
y
AT control system
12
10A
y
Illumination brightness control
13
20A
y
Wiper deicer
y
Outside mirror defogger
ProCarManuals.com

Specifications
12-7
– CONTINUED –
„Fuse panel located in the engine compartmentA) FWD socket (AT models without Vehicle Dynamics Control sys-
tem)
B) Main fuse
14
10A
y
Meter
15
30A
y
Windshield wiper and washer
16
20A
y
Brake light
17
15A
y
Air conditioner
18
15A
y
Backup light
y
Cruise control
19
15A
y
Power outlet (cargo)
20
15A
y
Rear window wiper and washer
21
15A
y
Ignition coil (Non-turbo model only)
22
15A
y
Seat heater
23
Empty
Fuse panel
Fuse rating
Circuit
A
12 4
3 B
5
6 789
10 11 12 13
C00105
14
ProCarManuals.com

12-8
Specifications
Fuse panel
Fuse rating
Circuit
1
30A
y
Radiator cooling fan (Main)
2
30A
y
Radiator cooling fan (Sub)
3
50A
y
Vehicle Dynamics Control system
(Models with Vehicle Dynamics
Control system only)
30A
y
ABS motor
4
30A
y
Engine sensor (Non-turbo models
only)
5
20A
y
Rear window defogger
6
15A
y
Hazard warning flasher
y
Horn
7
15A
y
Turn signal lights
8
10A
y
Automatic transmission control unit
9
10A
y
Alternator
10
15A
y
Headlight (right side)
11
15A
y
Headlight (left side)
12
20A
y
Lighting switch
13
15A
y
Clock
y
Interior light
14
10A
y
Secondary air combination valve
(Turbo models only)
Fuse panel
Fuse rating
Circuit
ProCarManuals.com

Specifications
12-9
Bulb chartDescriptionWattage Bulb type
Headlight
High beam 12V-60W 9005 (HB3)
Low beam Canada-spec. 2.5XT 12V-35W D2R
All except Canada-
spec. 2.5XT 12V-55W H1
Front fog light 12V-55W 9006 (HB4)
Front turn signal 12V-21W 1474
Parking light 12V-5W 168
Side marker light (Front) 12V-5W 168
Rear combination light Tail/stop light 12V-21/5W 7443
Turn signal 12V-21W (Amber) 1474
Tail/stop light 12V-21/5W 7443
Backup light 12V-16W 921
High mount stop light 12V-13W 912
License plate light 12V-5W 168
Cargo area light 12V-15W –
Front ashtray light 12V-1.4W –
Doom light 12V-8W –
Map light 12V-8W –
ProCarManuals.com

13-2
Consumer information and Reporting safety defects
Consumer information and Reporting safety defects
For U.S.A.
The following information has been com-
piled according to Code of Federal Regu-
lations “Title 49, Part 575”.
Tire information„Tire labelingMany markings (e.g. Tire size, Tire
Identification Number or TIN) are
placed on the sidewall of a tire by tire
manufacturers. These marking can
provide you with useful information on
the tire.T
Tire size
Your vehicle comes equipped with P-
Metric tire size. It is important to un-
derstand the sizing system in select-
ing the proper tire for your vehicles.
Here is a brief review of the tire sizing
system with a breakdown of its indi-
vidual elements.
V
P Metric
With the P-Metric system, Section
Width is measured in millimeters. To
convert millimeters into inches, divide
by 25.4. The Aspect Ratio (Section
Height divided by Section Width)
helps provide more dimensional infor-
mation about the tire size. Example:
(1) P = Certain tire type used on light
duty vehicles such as passenger cars
(2) Section Width in millimeters
(3) Aspect Ratio (= section height
÷
section width).
(4) R = Radial Construction
(5) Rim diameter in inches
V
Load and Speed Rating Descrip-
tions
The load and speed rating descrip-
tions will appear following the size
designation.
They provide two important facts
about the tire. First, the number des-
ignation is its load index. Second, the
letter designation indicates the tire’s
speed rating.
Example:
(6) Load Index: A numerical codeP 215 / 60 R 16(1) (2) (3) (4) (5)P 215 / 60 R 16 94 H
Size designation (6) (7)
ProCarManuals.com

Consumer information and Reporting safety defects
13-5
– CONTINUED –
„Recommended tire inflation pressureT
Recommended cold tire inflation pressure
Recommended cold tire inflation pressure for your vehicle’s tires is as follows,Tire size
P215/60R16 94H
P215/55R17 93H
Wheel size
16 × 6
1/2 JJ
17 × 7 JJ
Pressure
Front
Light load
29 psi (200 kPa, 2.0 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Full load
29 psi (200 kPa, 2.0 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Rear
Light load
28 psi (190 kPa, 1.9 kgf/cm
2)
30 psi (210 kPa, 2.1 kgf/cm
2)
Full load
36 psi (250 kPa, 2.5 kgf/cm
2)
32 psi (220 kPa, 2.2 kgf/cm
2)
Trailer towing
41 psi (280 kPa, 2.8 kgf/cm
2)
36 psi (250 kPa, 2.5 kgf/cm
2)
Temporary spare
tire
Size
T135/80D16
T135/90D16
Pressure
60 psi (420 kPa, 4.2 kgf/cm
2)
ProCarManuals.com