SUBARU FORESTER 2019 Quick Guide

9
Gauges
Speedometer
Trip meter and odometer
Auto Vehicle Hold operation
Vehicle Dynamics Control/
Vehicle Dynamics Control
operation
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger airbag ON
(Located on center console)
Front passenger airbag OFF (Located on center console)
Pre-Collision Braking
System OFF light
Lane Departure Warning OFF light
Auto Vehicle Hold ON
Turn signals
Front fog light indicator
light (if equipped)
Headlight indicator light
3495150_19a_Subaru_Forester_QRG_070318.indd 97/3/18 1:06 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

10
Personalize
Tilt and Telescopic Steering Column
Pull the lever down firmly to adjust the height and lengthwise positio\
n of the column; firmly
push the lever back up to lock the column in place. Do not adjust while \
driving.
Heated Steering Wheel (if equipped)
To activate, pull the Heated Steering Wheel switch while the ignition is \
in the ON position.
The indicator light on the switch will illuminate.
To deactivate, pull the Heated Steering Wheel switch again.
i/SET Combination Meter Display Controls
Use the controls to display and switch selected items in the combination meter displa\
y.
Please refer to your Owner’s Manual for details on these controls.
3495150_19a_Subaru_Forester_QRG_070318.indd 107/3/18 1:06 PM

11
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to
adjust the right-hand mirror. Move the knob in the direction you want to move the
mirror. Then return the knob to the neutral/center position.
Power Moonroof (if equipped)
With the moonroof in the fully closed position, press the switch 1 to fully open
the moonroof. Press the switch
2 to close the moonroof. To stop the moonroof
in a midway position while opening or closing, momentarily press the switch to the
1 side or 2 side.
1
2
Personalize
HomeLink® 5 Accessory Mirror (if equipped)
The HomeLink 5 accessory mirror
provides three buttons to replace up
to three hand-held radio frequency
remotes used to activate devices
such as garage door openers,
gate openers, entry door locks,
security systems and home lighting.
Please see your Owner’s Manual for
programming instructions or visit
www.subaru.com/homelink to
view a how-to video.
3495150_19a_Subaru_Forester_QRG_070318.indd 117/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

12
Controls
While the light switch is on, rotate the dial downward to dim the instrument panel illumination. Rotate the dial upward to make the illumination brighter. When the dial is fully rotated upward
(dots aligned), the instrument panel illumination stays at full bright\
ness.
Light Controls

Turns on instrument panel
lights, tail lights, parking lights
and license plate lights.
Turns on headlights, instrument
panel illumination, parking lights,
tail lights and license plate lights.
Rotate to
turn on
fog lights
(if equipped).AUTO: The vehicle’s lights are
automatically on or off, depending
on the level of outside light.
Push forward to change from low
beam to high beam. Pull the lever
back to center to return to low beam.
Push slightly down
for lane change
or fully down for
left turn signal.
Push slightly up
for lane change
or fully up for
right turn signal.
3495150_19a_Subaru_Forester_QRG_070318.indd 127/3/18 1:07 PM

13
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you. Rotate the dial to adjust the intermittent
wiper speed.
To operate the rear wiper, rotate the end of the knob upward to the intermittent,
continuous, or wash position. When the rear wiper is off, rotate the knob downward
to wash and wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only the front daytime running
lights will be automatically turned on when the engine has started, the parking
brake is fully released and the light switch is in the “OFF”, “AUTO” or “\
”
position. The brightness of the illumination of the high beam headlights\
is reduced
by the daytime running light system. You must always switch on your headlights
when it is dark outside by turning the light switch to the “
” position or have the
switch in the “AUTO” position.
1
2
3
INT.
LOW
HIGH
OFF
Controls
3495150_19a_Subaru_Forester_QRG_070318.indd 137/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

14
Automatic Climate Control System (if equipped)
1
Automatic On and Off
This system automatically controls
outlet air temperature, fan speed, air
flow distribution, air inlet control, and air
conditioner compressor operation. Press
“AUTO” to activate. Press “OFF” to turn
off the system.
2
Temperature Control Dial
Rotate the dial clockwise to increase
the temperature or rotate the dial
counterclockwise to decrease the
temperature and maintain a comfortable
climate within the driver and passenger
compartment. The temperature is
displayed digitally on the screen.




Operation in Manual Mode
3
Recirculated/Outside Air Button
Press the air inlet selection button to
prevent outside air from being drawn
into the passenger compartment. Press
the button again to allow outside air
into the compartment. TO PREVENT
WINDSHIELD FOGGING, DO NOT
REMAIN IN THE RECIRCULATED MODE
FOR AN EXTENDED PERIOD OF TIME
4
Fan Speed Control Knob
Rotate the fan speed control
knob to select the desired fan speed.
5
Air Flow Mode Selection Dial
Turn the “MODE” dial to select the
desired air flow mode. The selected
air flow mode – either ventilation, bi-level,
heat or heat-defrost – is shown on
the display.
Controls
1
3
4
5
8
2
796
3495150_19a_Subaru_Forester_QRG_070318.indd 147/3/18 1:07 PM

15
Located in the multi-function display;
top center of dash
6 Air Conditioner Button
Press the “A/C” button to activate
the air conditioning. Press it again to
turn off the air conditioning.
7
Defroster Button
Press the button to defrost or
dehumidify the windshield and front
door windows.


8
Rear Window Defogger Button
Press the button to turn on the
defogger. It will automatically shut
off after about 15 minutes. If the
window clears before that time, you
can press the button again to turn
it off. If equipped, the outside mirror
defogger and windshield wiper
deicer will also activate.
9
Maximum Air Conditioner Button
For quicker cooling, press the “MAX
A/C” button.
Controls
3495150_19a_Subaru_Forester_QRG_070318.indd 157/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

16
Controls
Dual Zone Automatic Climate Control System (if equipped)
1 Automatic On and Off
This system automatically controls
outlet air temperature, fan speed,
air flow distribution, air inlet control,
and air conditioner compressor
operation. Press “AUTO” to activate.
Press “OFF” to turn off the system.
2 Temperature Control Dial
Rotate the dial clockwise to increase
the temperature or rotate the dial
counterclockwise to decrease the
temperature and maintain a comfortable
climate within the driver and passenger
compartment. The temperature is
displayed digitally on the screen.

Separate temperature settings
can be adjusted for the driver’s
side and passenger’s side.
Operation in Manual Mode
3 Recirculated/Outside Air Button
Press the air inlet selection button to
prevent outside air from being drawn
into the passenger compartment. Press
the button again to allow outside air
into the compartment. TO PREVENT
WINDSHIELD FOGGING, DO NOT
REMAIN IN THE RECIRCULATED MODE
FOR AN EXTENDED PERIOD OF TIME.
4 Fan Speed Control Knob
Rotate the fan speed control knob
to select the desired fan speed.
5 Air Flow Mode Selection Button
Press the “MODE” button to select the
desired air flow mode. The selected
air flow mode – either ventilation,
ventilation 2, bi-level, heat, heat-defrost,
or defrost – is shown on the display.
1
9
3
8
10
4
7
56
22
3495150_19a_Subaru_Forester_QRG_070318.indd 167/3/18 1:07 PM

17
6 SYNC Button
Press the button to synchronize both
the driver’s side and passenger’s
side temperatures using the
driver’s side temperature control.
7 Air Conditioner Button
Press the “A/C” button to activate
the air conditioning. Press it again
to turn off the air conditioning.
8 MAX Air Conditioner Button
For quicker cooling, press
the “MAX A/C” button.
9 Defroster Button
Press the button to defrost or
dehumidify the windshield and
front door windows.
10 Rear Window Defogger Button
Press the button to turn on the
defogger. It will automatically shut
off after about 15 minutes. If the
window clears before that time,
you can press the button again to
turn it off. If equipped, the outside
mirror defogger and windshield
wiper deicer will also activate.
Located in the multi-function display;
top center of dash
Controls
3495150_19a_Subaru_Forester_QRG_070318.indd 177/3/18 1:07 PM
Getting
Started Instrument

Panel Gauges
Personalize ControlsWhile

Operating Safety/In Case

of Emergency Additional

Information

18
USB Port
The USB ports are located in the front of the center
console. You can connect a USB-equipped portable
music player to the USB port and hear the music
stored on it through the vehicle speakers. Press
the “SOURCE” button located on the audio system
repeatedly until the USB mode is selected.
Auxiliary Input Jack
The 3.5mm auxiliary input jack is located in the front of the center console. You can connect a
portable music player to the auxiliary jack and hear the music stored on it through the vehicle
speakers. Press the “SOURCE” button located on the audio system to select the \
auxiliary mode.
Controls
Steering Wheel Audio Controls (if equipped)
Voice recognition switch;
please refer to your SUBARU
STARLINK
™ Owner’s Manual.
Press the button to select the
desired audio mode – FM, AM,
SXM, CD, AUX, MEDIA. With any of the radio modes
selected, press the left or
right arrow button to toggle
through your presets. In CD
mode, press the buttons to
skip forward or back a track.
Push the switch
up (+) to increase
volume or down (–)
to decrease volume.
3495150_19a_Subaru_Forester_QRG_070318.indd 187/3/18 1:07 PM