SUBARU LEGACY 1995 Service Repair Manual

B5M0247AB5M0248A
B5M0249A
G5M0122
3. Datum Dimensions
Use a tram tracking gauge to measure all dimensions. If a
measuring tape is used, be extremely careful because it
tends to deflect or twist, which results in a false reading.
NOTE:

A suffix character“R”or“L”refers to the right or the left.

All dimensions refer to the distance between the centers
of holes measured in a straight line.

Each dimension indicates a projected dimension
between hole centers.
14
5-1SERVICE DATA
2. Body Datum Points - 3. Datum Dimensions

1. FRONT STRUCTURE
B5M0320A
Unit: mm (in)
15
5-1SERVICE DATA
3. Datum Dimensions

2. CENTER STRUCTURE
Unit: mm (in)
B5M0251A
Unit: mm (in)
B5M0393A
16
5-1SERVICE DATA
3. Datum Dimensions

Unit: mm (in)
B5M0253A
17
5-1SERVICE DATA
3. Datum Dimensions

3. FRONT WINDSHIELD AND REAR WINDOW
B5M0254A
Unit: mm (in)
18
5-1SERVICE DATA
3. Datum Dimensions

4. DOORS
B5M0321A
Unit: mm (in)
19
5-1SERVICE DATA
3. Datum Dimensions

5. TRUNK LID AND REAR GATE
B5M0255A
Unit: mm (in)
20
5-1SERVICE DATA
3. Datum Dimensions

6. COMPARTMENT
B5M0256A
Unit: mm (in)
21
5-1SERVICE DATA
3. Datum Dimensions

4. Datum Points and Dimensions
Concerning On-Board Aiming
Adjustment
If headlight aiming is misaligned due to damaged body
panel, repair headlight mating surface using body and
headlight datum points as a guide.
NOTE:
It is recommended to conduct On-Board Aiming Adjust-
ment with headlights turned off.
If turned on during the adjustment, the duration should be
within two minutes.
B5M0364
Unit: mm (in)
22
5-1SERVICE DATA
4. Datum Points and Dimensions Concerning On-Board Aiming Adjustment

1. Front Hood and Hood Lock
B5M0258A
1Front hood

2Hinge (RH, LH)

3Front hood seal

4Lever ASSY

5Cable
6Striker

7Hood lock ASSY

8Front hood stay

9Front hood seal CTR
Tightening torque: N⋅m (kg-m, ft-lb)
T1: 14±9 (1.4±0.9, 10.1±6.5)
T2: 32±1 (3.3±0.1, 23.9±0.7)
23
5-1COMPONENT PARTS
1. Front Hood and Hood Lock