SUBARU OUTBACK 2000 3.G Owners Manual

In case of emergency9-17
–
CONTINUED –
n
Towing hook cover removal procedure
For except OUTBACK models:
HB9013BB
1. Push at the notc hed p ortion A, and p ull the towing hook c over to-
ward you.
HB9014BB
2. Insert your fing ers und er the raised p ortion B. Then, p ull it toward
you so that the towing hook c over may swing op en. R emove the c ov-
er.

9-18For OUTBACK models:
HB9018BA
HB9017BB
1. Pull the towing hook c over toward you while p ushi ng up the p ortion
A . The p ortion B will b e raised .
HB9020BA
HB9019BB
HB9022BA
HB9021BB
2. Pull the p ortion B toward you with your left hand . Simultaneously

In case of emergency9-19
–
CONTINUED –
p ull the p ortion
C toward you while p ushing the p ortion C with your
rig ht hand .
HB9024BA
HB9023BB
3. Push the p ortion D. Pull out the towing hook c over to remove it.
n Towing hook cover installation procedure
For except OUTBACK models:
HB9016BA
HB9015BA
1. Insert the towing hook c over into the c learanc e b etween the fog
lig ht (or b ump er trim c over) and the b ump er b od y.

9-20
HB9013CB
2. Push the towing hook c over in ac c ord anc e with the p ushing ord er
g iven in the illustration. For OUTBACK models:
HB9025BA
1. Insert the g uid e E into the hole F.

In case of emergency9-21
–
CONTINUED –
HB9027BB
HB9026BB
2. Fit the flang e G in the slit H from the left end . While hold ing the
towing hook c over at the p ortion G, p ush at the p ortion I.
HB9029BB
HB9028BB
3. Push at the p ortion J. Chec k that the tab of the p ortion K is fitted in
the b ump er as shown in the illustration.

9-22
HB9030BB
4. Push the p ortion L.
Using a flat-bed truck
HB8008AA
This is the b est way to transp ort your vehic le. Use the following p roc e-
d ures to ensure safe transp ortation.
1. Shift the selec tor lever into the “P ” p osition for automatic transmis-
sion vehic les or “1st ” for manual transmission vehic les.
2. Pull up the p arking b rake lever firmly.
3. Sec ure the vehic le onto the c arrier p rop erly with safety c hains.
Eac h safety c hain should b e eq ually tig htened and c are must b e tak-
en not to p ull the c hains so tig htly that the susp e nsion b ottoms out.

In case of emergency9-23
–
CONTINUED –

Towing with all wheels on the ground
WARNING
Never turn the ignition switch to the “LOCK” position while the
vehicle is being towed because the steering wheel and the direc- tion of the wheels will be locked. Remember that the brake booster and power steering do not
function when the engine is not running. Because the engine isturned off, it will take greater effort to operate the brake pedal andsteering wheel.
CAUTION
If transmission failure occurs, transport your vehicle on a flat-
bed truck. For vehicles with automatic transmission, the traveling speed
must be limited to less than 20 mph (30 km/h) and the traveling
distance to less than 31 miles (50 km). For greater speeds and
distances, transport your vehicle on a flat-bed truck.
HB8010AA
1. Chec k the transmission and d ifferential oil level s and ad d oil to
b ring it to the up p er level if nec essary.
2. Release the p arking b rake and p ut the transmissio n in neutral.
3. The ig nition switc h should b e in the “ACC ” p osition while the ve-
hic le is b eing towed .

9-244. Take up slac k in the towline slowly to p revent d a
mag e to the ve-
hic le.
Moonroof — if the moonroof cannot be closed
If the moonroof c annot b e c losed with the moonroof switc h, you c an
c lose the moonroof manually.
Sedan
1. Take out the hex-head ed wrenc h from the g love c om p artment and
sc rewd river from the tool b ag .
HB9007BB
HB9006BA
2. Remove the sp ot lig ht lens b y p rying the ed g e of
the lens with a
reg ular sc rewd river, then remove the switc h b od y re taining sc rews
and take off the moonroof switc h.
HB9008BA

In case of emergency9-25
–
CONTINUED –
3. Insert the wrenc h in the end of the motor shaft.
To lower the moonroof, turn the wrenc h c loc kwise.
To c lose the moonroof, turn the wrenc h c ounterc loc k wise.
Have your vehic le c hec ked b y an authorized SUBARU d ealer.
Station wagon
1. Take out the hex-head ed wrenc h from the g love c om p artment and
sc rewd river from the tool b ag .
HB8000BB
HB8001BA
2. Remove the p lug on the roof trim b y inserting the end of the reg ular
sc rewd river b etween the roof and p lug and p rying it off.
3. Insert the wrenc h in the end of the motor shaft.
To c lose the moonroof, turn the wrenc h c loc kwise.
Have your vehic le c hec ked or rep aired b y an authori zed SUBARU
d ealer.

9-26Maintenance tools
HB9011AA
Your vehic le is eq uip p ed with the following mainten
anc e tools:
Sc rewd river
Wheel nut wrenc h
Hex-head ed wrenc h (for vehic les with moonroof)
Jack and jack handle
HB9001BA
HBF015CB
Jack handle
Jack
Spare tire