tow SUBARU OUTBACK 2000 3.G Service Manual

9-18For OUTBACK models:
HB9018BA
HB9017BB
1. Pull the towing hook c over toward you while p ushi ng up the p ortion
A . The p ortion B will b e raised .
HB9020BA
HB9019BB
HB9022BA
HB9021BB
2. Pull the p ortion B toward you with your left hand . Simultaneously

In case of emergency9-19
–
CONTINUED –
p ull the p ortion
C toward you while p ushing the p ortion C with your
rig ht hand .
HB9024BA
HB9023BB
3. Push the p ortion D. Pull out the towing hook c over to remove it.
n Towing hook cover installation procedure
For except OUTBACK models:
HB9016BA
HB9015BA
1. Insert the towing hook c over into the c learanc e b etween the fog
lig ht (or b ump er trim c over) and the b ump er b od y.

9-20
HB9013CB
2. Push the towing hook c over in ac c ord anc e with the p ushing ord er
g iven in the illustration. For OUTBACK models:
HB9025BA
1. Insert the g uid e E into the hole F.

In case of emergency9-21
–
CONTINUED –
HB9027BB
HB9026BB
2. Fit the flang e G in the slit H from the left end . While hold ing the
towing hook c over at the p ortion G, p ush at the p ortion I.
HB9029BB
HB9028BB
3. Push at the p ortion J. Chec k that the tab of the p ortion K is fitted in
the b ump er as shown in the illustration.

In case of emergency9-23
–
CONTINUED –

Towing with all wheels on the ground
WARNING
Never turn the ignition switch to the “LOCK” position while the
vehicle is being towed because the steering wheel and the direc- tion of the wheels will be locked. Remember that the brake booster and power steering do not
function when the engine is not running. Because the engine isturned off, it will take greater effort to operate the brake pedal andsteering wheel.
CAUTION
If transmission failure occurs, transport your vehicle on a flat-
bed truck. For vehicles with automatic transmission, the traveling speed
must be limited to less than 20 mph (30 km/h) and the traveling
distance to less than 31 miles (50 km). For greater speeds and
distances, transport your vehicle on a flat-bed truck.
HB8010AA
1. Chec k the transmission and d ifferential oil level s and ad d oil to
b ring it to the up p er level if nec essary.
2. Release the p arking b rake and p ut the transmissio n in neutral.
3. The ig nition switc h should b e in the “ACC ” p osition while the ve-
hic le is b eing towed .

9-244. Take up slac k in the towline slowly to p revent d a
mag e to the ve-
hic le.
Moonroof — if the moonroof cannot be closed
If the moonroof c annot b e c losed with the moonroof switc h, you c an
c lose the moonroof manually.
Sedan
1. Take out the hex-head ed wrenc h from the g love c om p artment and
sc rewd river from the tool b ag .
HB9007BB
HB9006BA
2. Remove the sp ot lig ht lens b y p rying the ed g e of
the lens with a
reg ular sc rewd river, then remove the switc h b od y re taining sc rews
and take off the moonroof switc h.
HB9008BA

11-6
HBB003BA
To op en the hood :
1. Pull the hood release knob und er the instrument panel.
2. Release the sec ond ary hood release loc ated und er the front g rille b y
moving the lever toward the left. Lift up the hood , release the hood p rop
from its retainer and p ut the end of the hood p rop into the slot in the
hood .
To c lose the hood :
1. Lift the hood slig htly and remove the hood p rop f rom the slot in the
hood and return the p rop to its retainer.
2. Lower the hood until it ap p roac hes ab out 6 in. (1 5 c m) from the
c losed p osition and let it d rop .
3. After c losing the hood , b e sure the hood is sec ur ely loc ked .
If this d oes not c lose the hood , release it from a slig htly hig her p osition.
Do not p ush the hood forc ib ly to c lose it. It c ould d eform the metal.

11-10
HBB052BB
HBB051BB
HBB050BA
HBB049AA
6. Remove two c lip s at the front of the c over und er the oil filter.
7. Slid e the c over toward the vehic le front to remov e it.
8. Remove the oil filter with an oil filter wrenc h.
9. Before installing a new oil filter, ap p ly a thin c oat of eng ine oil to the
seal.
10. Clean the rub b er seal seating area of the lower c rank c ase and
install the oil filter b y hand turning . Be c areful not to twist or d amag e
the seal.
11. Tig hten it ap p roximately two-third s of a turn a fter the seal makes
c ontac t with the lower c rank c ase.
CAUTION
Never over tighten the oil filter because that can result in an oilleak.

11-12In c hoosing an oil, you want the p rop er q uality and
visc osity, as well
as one that will ad d to fuel ec onomy. The following tab le lists the rec -
ommend ed visc osities and ap p lic ab le temp eratures.
When ad d ing oil, d ifferent b rand s may b e used tog et her as long as
they are the same API c lassific ation and SAE visc os ity as those rec -
ommend ed b y SUBARU.
Eng ine oil visc osity (thic kness) affec ts fuel ec ono my. Oils of lower vis-
c osity p rovid e b etter fuel ec onomy. However, in hot weather, oil of
hig her visc osity is req uired to p rop erly lub ric ate the eng ine.
OM-H2756
SAE viscosity numbr and applicable temperature
Recommended grade and viscosity under severe driving conditions
If the vehic le is used in d esert areas, in areas wi th very hig h temp era-
tures, or used for heavy-d uty ap p lic ations suc h as a towing a trailer,
use of oil with the following g rad e and visc osities is rec ommend ed .
API classification SJ or SH: SAE viscosity No.: 30, 40, 10W-50,
20W-40, 20W-50

12-4AT d ifferential g ear oil 1.3 US q t (1.2 liters, 1.1
Imp q t)
Rear d ifferential g ear oil 0.8 US q t (0.8 liter, 0.7 Imp q t)
Power steering g ear fluid 0.7 US q t (0.7 liter, 0.6 Imp q t)
Eng ine c oolant MT 7.2 US q t (6.8 liters, 6.0 Imp q t) AT 7.1 US q t (6.7 liters, 5.9 Imp q t)
Tires Legacy
Typ e Steel b elted rad ial, Tub eless
Size Brig hton P195/60R15 87H L P205/60R15 90H
GT P205/55R16 89H
Temp orary sp are T135/70D16
Pressure
Front Brig hton 33 p si (230 kPa, 2.3 kg /c m 2
)
GT, L 32 p si (220 kPa, 2.2 kg /c m 2
)
Rear Brig hton 32 p si (220 kPa, 2.2 kg /c m 2
)
GT, L 30 p si (210 kPa, 2.1 kg /c m 2
)
Temp orary sp are 60 p si (420 kPa, 4.2 kg /c m 2
)
Wheel size 15 x 6JJ, 16 x 6 1
/2 JJ
OUTBACK
Typ e Steel b elted rad ial, Tub eless Size P225/60R16 97H
Temp orary sp are T145/80R16
Pressure
Front 30 p si (210 kPa, 2.1 kg /c m 2
)
Trailer towing 30 p si (210 kPa, 2.1 kg /c m 2
)
Rear 29 p si (200 kPa, 2.0 kg /c m 2
)
Trailer towing 32 p si (220 kPa, 2.2 kg /c m 2
)
Temp orary sp are 60 p si (420 kPa, 4.2 kg /c m 2
)
Wheel size 16 x 6 1
/2 JJ