jacking SUZUKI NEXA 2015 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine 
(0(5*(1&<6(59,&(
06(
-DFNLQJ,QVWUXFWLRQV
75F062
1) Place the vehicle on level, hard ground.
2) Set the parking brake firmly and shift
into “R” (Reverse).
3) Turn on the hazard warning flasher if
your vehicle is near traffic.
4) Block the front and rear of the wheel
diagonally opposite of the wheel being
lifted.5) Place the spare wheel near the wheel
being lifted as shown in the illustration
in case that the jack slips.
54G253
63J10063J101
6) Position the jack at an angle as shown
in the illustration and raise the jack by
turning the jack handle clockwise until
the jack-head groove fits around the
jacking bar beneath the vehicle body.
7) Continue to raise the jack slowly and
smoothly until the tire clears the
ground. Do not raise the vehicle more
than necessary.
:$ 5 1 , 1 *

Downloaded from www.Manualslib.com manuals search engine 
(0(5*(1&<6(59,&(
06(
NOTE:
For more details, please contact an
DXWKRULVHG0DUXWL6X]XNLZRUNVKRS.&KDQJLQJ:KHHOVTo change a wheel, use the following pro-
cedure:
1) Remove the jack, tools and spare
wheel from the vehicle.
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
4) Remove the wheel nuts and wheel.
65J4033
5) Before installing the new wheel, clean
any mud or dirt off from the surface of
the wheel (1), hub (2), thread part (3)
and surface of the wheel nuts (4) with a
clean cloth. Clean the hub carefully; it
may be hot from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
7LJKWHQLQJWRUTXHIRUZKHHOQXW
1PNJPOEIW
7) Lower the jack and fully tighten the nuts
in a crisscross fashion with a wrench as
shown in the illustration.
NOTICE
1HYHU DSSO\ D JDUDJH MDFN WR WKH
H[KDXVW SLSH VLGH XQGHU VSRLOHU LI
HTXLSSHG HQJLQH XQGHUFRYHU RU UHDU
WRUVLRQEHDP
:$ 5 1 , 1 *