TOYOTA 4RUNNER 1998 Manual Online

4RUNNER (1998)
CAUTION
Push and pull the child restraint
system in different directions to
be sure it is secure. Follow all
the installation instructions pro-
vided by its manufacturer.
3. To remove the convertible seat,
press the buckle- release button. ÐInstallation with 3- point
type seat belt

4RUNNER (1998)
(A) INFANT SEAT INSTALLATION
An infant seat is used in rear- fac-
ing position only.

4RUNNER (1998)
CAUTION
Never put a rear- facing child
restraint system in the front
seat because the force of the
rapid inflation of the passenger
airbag can cause death or seri-
ous injury to the child.
Do not put a rear- facing child
restraint system in the rear seat
if it interferes with the lock
mechanism of the front seats.
This can cause severe injury to
the child and front passenger in
case of sudden braking or a
collision.

4RUNNER (1998)
1. Run the lap and shoulder belt
through or around the infant seat
following the instructions provided
by its manufacturer and insert the
tab into the buckle taking care not
to twist the belt. Keep the lap por-
tion of the belt tight.
CAUTION
After inserting the tab, make
sure the tab and buckle are
locked and that the lap and
shoulder portions of the belt
are not twisted.
Do not insert coins, clips, etc.
in the buckle as this may pre-
vent you from properly latching
the tab and buckle.
If the seat belt does not
function normally, it cannot
protect your child from injury.
Contact your Toyota dealer
immediately. Do not use the
seat until the seat belt is fixed.

4RUNNER (1998)
2. Fully extend the shoulder belt to
put it in the lock mode. When the
belt is then retracted even slightly,
it cannot be extended.
To hold the infant seat securely, make
sure the belt is in the lock mode be-
fore letting the belt retract.

4RUNNER (1998)
3. While pressing the infant seat firm-
ly against the seat cushion and
seatback, let the shoulder belt re-
tract as far as it will go to hold the
infant seat securely.

4RUNNER (1998)
CAUTION
Make sure the seat belt is secure-
ly locked. Also make sure the
child restraint system is secure
by pushing and pulling it in dif-
ferent directions. Follow all the
installation instructions provided
by its manufacturer.
4. To remove the infant seat, press
the buckle- release button and allow
the belt to retract completely. The
belt will move freely again and be
ready to work for an adult or older
child passenger.

4RUNNER (1998)
(B) CONVERTIBLE SEAT INSTALLA-
TION
A convertible seat is used in for-
ward- facing and rear- facing posi-
tion depending on the child's age
and size. When installing, follow the
manufacturer 's instructions about
the applicable child's age and size
as well as directions for installing
a child restraint system.

4RUNNER (1998)
CAUTION
Never put a rear- facing child
restraint system in the front
seat because the force of the
rapid inflation of the passenger
airbag can cause death or seri-
ous injury to the child.

4RUNNER (1998)
Move seat fully back
A forward- facing child restraint
system should be allowed to
put on the front seat only when
it is unavoidable. Always move
the seat as far back as pos-
sible, because the force of a
deploying airbag could cause
death or serious injury to the
child.