coolant level TOYOTA 4RUNNER 1998 Owners Manual

4RUNNER (1998)
The gauge works when the ignition
switch is on and indicates the
approximate quantity of fuel remain-
ing in the tank.
Nearly fullÐNeedle at ºFº
Nearly emptyÐNeedle at ºEº
It is a good idea to keep the tank
over 1/4 full.
This fuel gauge has a non- return type
needle which remains at the last indi-
cated position when the ignition switch
is turned off.
If the fuel level approaches ºEº or the
low fuel level warning light comes on,
fill the fuel tank as soon as possible. On inclines or curves, due to the
movement of fuel in the tank, the fuel
gauge needle may fluctuate or the low
fuel level warning light may come on
earlier than usual.
If the fuel tank is completely empty,
the malfunction indicator lamp comes
on. Fill the fuel tank immediately.
The indicator lamp goes off after driv-
ing several times. If the indicator lamp
does not go off, contact your Toyota
dealer as soon as possible. Engine coolant temperatur
e
gauge

4RUNNER (1998)
3. Visually check to see if the engine drive belt (fan belt) is broken or
loose. Look for obvious coolant
leaks from the radiator, hoses, and
under the vehicle. However, note
that water draining from the air
conditioning is normal if it has
been used.
CAUTION
When the engine is running, keep
hands and clothing away from the
moving fan and engine drive
belts.
4. If the engine drive belt is brokenor the coolant is leaking, stop the
engine immediately. Call a Toyota
dealer for assistance.
5. If the engine drive belt is O.K. and there are no obvious leaks, you
may help the engine cool down
more quickly by running it at about
1500 rpm for a few minutes with
the accelerator pedal lightly de-
pressed.
6. Check the coolant reservoir. If it is dry, add coolant to the reservoir
while the engine is running. Fill it
about half full.
CAUTION
Do not attempt to remove the ra-
diator cap when the engine and
radiator are hot. Serious injury
could result from scalding hot
fluid and steam blown out under
pressure.
7. After the engine coolant tempera-ture has cooled to normal, again
check the coolant level in the res-
ervoir. If necessary, bring it up to
half full again. Serious coolant loss
indicates a leak in the system. You
should have it checked as soon as
possible at your Toyota dealer. If you have a flat tireÐ
1. Reduce your speed gradually, keep- ing a straight line. Move cautiously
off the road to a safe place well
away from the traffic. Avoid stop-
ping on the center divider of a
highway. Park on a level spot with
firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in ºPº (auto-
matic) or reverse (manual).
4. Have everyone get out of the ve- hicle on the side away from traffic.
5. Read the following instructions thoroughly.
CAUTION
When jacking, be sure to observe
the following to reduce the possi-
bility of personal injury: Follow jacking instructions.
Do not start or run the engine
while your vehicle is supported
by the jack.

4RUNNER (1998)
Automatic transmission ºParkº mech- anism
Check the lock release button of the
selector lever for proper and smooth
operation. On a safe incline, check
that your vehicle is held securely with
the selector lever in ºPº position and
all brakes released.
IN THE ENGINE COMPARTMENT
Items listed below should be
checked from time to time, e.g.
each time when refueling.
Washer fluid
Make sure there is sufficient fluid in
the tank. See Chapter 7- 3 for addi-
tional information.
Engine coolant level
Make sure the coolant level is be-
tween the ºFULLº and ºLOWº lines on
the see- through reservoir when the
engine is cold. See Chapter 7- 2 for
additional information.
Battery electrolyte level
Make sure the electrolyte level of all
battery cells is between upper and
lower level lines on the case. Add
only distilled water when replenishing.
See Chapter 7- 3 for additional in-
formation. Brake fluid level
Make sure the brake fluid level is cor-
rect. See Chapter 7- 2 for additional
information.
Engine oil level
Check the level on the dipstick with
the engine turned off and the vehicle
parked on a level spot. See Chapter
7- 2 for additional information.
Power steering fluid level
Check the level through the reservoir.
The level should be in the ºHOTº or
ºCOLDº range depending on the fluid
temperature. See Chapter 7- 2 for
additional information.
Exhaust system
If you notice any change in the sound
of the exhaust or smell exhaust
fumes, have the cause located and
corrected immediately. (See engine ex-
haust cautions in Part 2.)
Be on the alert for changes in perfor-
mance, sounds, and visual tip- offs
that indicate service is needed. Some
important clues are as follows:
Engine missing, stumbling, or ping-
ing
Appreciable loss of power
Strange engine noises
A leak under the vehicle (however,
water dripping from the air condi-
tioning after use is normal.)
Change in exhaust sound (This
may indicate a dangerous carbon
monoxide leak. Drive with the win-
dows open and have the exhaust
system checked immediately.)
Flat- looking tire; excessive tire
squeal when cornering; uneven tire wear
Vehicle pulls to one side when
driving straight on a level road
Strange noises related to suspen-
sion movement
Loss of brake effectiveness;
spongy feeling brake or clutch ped-
al; pedal almost touches floor; ve-
hicle pulls to one side when brak-
ing
Engine coolant temperature continu-
ally higher than normal
Does your vehicle need
repairing?

4RUNNER (1998)
1. Windshield and back window washer fluid tank
2. Engine oil filler cap
3. Brake fluid reservoir
4. Fuse block
5. Battery
6. Engine coolant reservoir
7. Power steering fluid reser- voir
8. Engine oil level dipstick
Engine compartment overview
3RZ- FE engine

4RUNNER (1998)
1. Windshield and back window
washer fluid tank
2. Power steering fluid reser- voir
3. Engine oil filler cap
4. Brake fluid reservoir
5. Fuse block
6. Battery
7. Engine coolant reservoir
8. Engine oil level dipstick

5VZ- FE engine

4RUNNER (1998)
Parts and tools
Here is a list of parts and tools you
will need on performing do- it- yourself
maintenance. Remember all Toyota
parts are designed in metric sizes, so
your tools must be metric.
Checking the engine oil level
Parts (if level is low): Engine oil API grade SH, ºEnergy-
Conserving IIº or SJ, ºEnergy-
Conservingº multigrade or ILSAC
multigrade having viscosity proper
for your climate
Tools: Rag or paper towel
Funnel (only for adding oil)
Checking the engine coolant level
Parts (if level is low): Ethylene- glycol antifreeze
Demineralized or distilled water
Tools: Funnel (only for adding coolant)
Checking brake fluid
Parts (if level is low): SAE J1703 or FMVSS No. 116
DOT 3 brake fluid
Tools: Rag or paper towel
Funnel (only for adding fluid) Checking power steering fluid
Parts (if level is low):
Automatic transmission fluid DEXRON II or III
Tools: Rag or paper towel
Funnel (only for adding fluid)
Checking battery condition
Tools: Warm water
Baking soda
Grease
Conventional wrench (for terminal
clamp bolts)
Checking and replacing fuses
Parts (if replacement is necessary): Fuse with same amperage rating
as original
Tools: Conventional wrench (for instrument
lower panel nut)
Adding washer fluid
Parts: Water
Washer fluid containing antifreeze
(for winter use)
Tools: Funnel Replacing light bulbs
Parts:
Bulb with same number and watt-
age rating as original (See charts
in ºReplacing light bulbsº in Chap-
ter 7- 3.)
Tools: Screwdriver

4RUNNER (1998)
Part 7
DO- IT- YOURSELF
MAINTENANCEÐ
Chapter 7- 2
Engine and Chassis
Checking the engine oil level
Checking the engine coolant
level
Checking brake fluid
Checking power steering fluid
Checking tire pressure
Checking and replacing tires
Rotating tires
Installing snow tires and
chains
Replacing wheels
Aluminum wheel precautions
Checking the engine oil level

4RUNNER (1998)
The top portion of the label shows the
oil quality by API (American Petroleum
Institute) designations such as SJ.
The center portion of the label shows
the SAE
viscosity grade such as SAE 5W- 30.
ºEnergy- Conservingº shown in the
lower portion, indicates that the oil
has fuel- saving capab ilities.
The ILSAC (International Lubricant
Standardization and Approval Commit-
tee) Certification Mark is displayed on
the front of the container. Look at the see- through coolant
reservoir when the engine is cold.
The coolant level is satisfactory if
it is between the ºF (Full)º and ºL
(Low)º lines on the reservoir. If the
level is low, add ethylene- glycol
type coolant.
The coolant level in the reservoir will
vary with engine temperature. Howev-
er, if the level is on or below the ºLº
line, add coolant. Bring the level up
to the ºFº line.
Use only ethylene- glycol type coolant.
See information in the next column.
If the coolant level drops within a
short time after replenishing, there
may be a leak in the system. Visually
check the radiator, hoses, radiator cap
and drain cock and water pump.
If you can find no leak, have your
Toyota dealer test the cap pressure
and check for leaks in the cooling
system.
CAUTION
To prevent burning yourself, do
not remove the radiator cap when
the engine is hot.
Coolant type selection
Your coolant must contain ethylene-
glycol antifreeze. In addition to pre-
venting freezing and subsequent dam-
age to the engine, this will also
prevent corrosion. Further supplemen-
tal inhibitors or additives are neither
needed nor recommended.
Read the antifreeze container for in-
formation on freeze protection. Follow
the manufacturer 's directions for how
much to mix with water. The total ca-
pacity of the cooling system is given
in Part 8. We recommend 50% solu-
tion be used for your Toyota, or a
sufficient quantity to provide protection
to about -35
C (- 31 F).
NOTICE
Do not use alcohol type antifreeze
or plain water alone.
Checking the engine coolan
level