TOYOTA 4RUNNER 2000 Owners Manual

1572000 4Runner (OM35762U)
Garage door opener box
The box is designed to store a garage
door opener transmitter.
Open the cover and remove the Velcro
loop.Remove the paper strip covering the adhe-
sive on back side of loop and adhere loop
to back side of the transmitter near cen-
ter.Please note if transmitter has wire clip for
sun visor, this clip must be removed prior
to adhesion of the Velcro.
ProCarManuals.com

1582000 4Runner (OM35762U)
Place the transmitter with Velcro loop fac-
ing inside of box into the box. Make sure
the transmitter button is located above
button pins.Remove spacers from the box. Place the
largest spacer on the pin that would be
below transmitter button when the cover is
closed. Close the cover.When the garage door opener transmitter
is properly installed, you can operate the
transmitter by pushing the cover.
ProCarManuals.com

1592000 4Runner (OM35762U)
If the spacer does not contact with your
garage door opener transmitter:

Check to see if spacer is on correct
pin.

Attach another spacer to the top of
original spacer. Check operation. If re-
quired, continue add spacers until con-
tact is achieved.
If the transmitter is clattering during driv-
ing, fill in a piece of felt or pad to prevent
the transmitter from clattering.Put the remained spacers back in its
place.
CAUTION
To reduce the chance of injury in
case of an accident or a sudden stop,
always keep the garage door opener
box closed while driving.
Eyeglass holder
To use the eyeglass holder, open the
lid.
CAUTION

To reduce the chance of injury in
case of an accident or a sudden
stop, always keep the eyeglass
holder closed while driving.

As this holder is designed for hold-
ing eyeglasses, do not place any
object heavier than approximately
50g (0.11 lb.) in it. Heavier objects
may cause the holder to open and
contents to fly out resulting in inju-
ries.
ProCarManuals.com

1602000 4Runner (OM35762U)
NOTICE
In hot weather, inside of the vehicle
becomes very hot. Do not leave any-
thing flammable or deformable such
as a lighter, the glasses, etc. inside.
Auxiliary box
To open the box, turn the two knobs.
Warning reflector holder
The auxiliary box is equipped with two
straps to hold the warning reflector.
Although the warning reflector itself is not
included as an original equipment, this
auxiliary box can be used to store the
warning reflector.
Hold the warning reflector kit with the
straps.
1. To release: Push in both sides of the
buckle as shown in the illustration.
2. To tighten: Connect the buckle, then
pull on the belt.
ProCarManuals.com

1612000 4Runner (OM35762U)
Rear console box
UPPER TRAY
To access the upper tray, raise the con-
sole box lid without touching the lock
release lever.
CONSOLE BOX
To access the rear console box, pull up
the lock release lever while raising the
rear console box lid.
ProCarManuals.com

1622000 4Runner (OM35762U)
Card holder
There is a card holder on the inside of
the rear console box lid.
To use the card holder, raise the console
box lid without touching the lock release
lever.
Front cup holders
The cup holders are designed for hold-
ing cups or drink- cans securely in its
holes.
ProCarManuals.com

1632000 4Runner (OM35762U)
CAUTION

Do not place anything else other
than cups or drink- cans on the cup
holder, as such items may be
thrown about in the compartment
and possibly injure people in the
vehicle during sudden braking or in
an accident.

To reduce the chance of injury in
case of an accident or a sudden
stop while driving, keep the cup
holder closed when it is not in use.
Rear cup holders
The cup holders are designed for hold-
ing cups or drink- cans securely in its
holes.
USING REAR CUP HOLDERS
To use the rear cup holders, pull out
the rear cup holder lid.
You can select from 3 arm positions.
CAUTION

Do not place anything else other
than cups or drink- cans on the cup
holder, as such items may be
thrown about in the compartment
and possibly injure people in the
vehicle during sudden braking or in
an accident.

To reduce the chance of injury in
case of an accident or a sudden
stop while driving, keep the cup
holder closed when it is not in use.
ProCarManuals.com

1642000 4Runner (OM35762U)
CLOSING REAR CUP HOLDER LID
To close the rear cup holder lid, re-
place the arms and pull up the lid.
NOTICE
Be sure to replace the arms before
closing the rear cup holder lid.
Tie- down hooks
To secure your luggage, use the tie-
down hooks as shown above.
See Luggage stowage precautionsº in
Section 2 for what to observe in loading
luggage.
Luggage cover
To use the luggage cover, pull it out of
the retractor and hook it to the an-
chors.
ProCarManuals.com

1652000 4Runner (OM35762U)
To remove the luggage cover:
1. Detach its hooks from the head re-
straints.
2. Lift it up.
NOTICE
As the plastic parts used on both
ends of the luggage cover may break
if exposed to a shock, take care not
to hit or knock them when attaching,
detaching or storing the cover.
Floor mat
Use a floor mat of the correct size.
If the floor carpet and floor mat have a
hole, then it is designed for use with a
locking clip. Fix the floor mat with locking
clip into the hole in the floor carpet.CAUTION
Make sure the floor mat is properly
placed on the floor carpet. If the floor
mat slips and interferes with the
movement of the pedals during driv-
ing, it may cause an accident.
ProCarManuals.com

1662000 4Runner (OM35762U)
ProCarManuals.com