display TOYOTA 4RUNNER 2007 N210 / 4.G Navigation Manual

200
Your destination point might be shown on
the opposite side of the street.
When a portion of the route has regula-
tions prohibiting the entry of the vehicle
that vary by time or season or other rea-
sons.
The road and map data stored in your nav-
igation system may not be complete or
may not be the latest version.
After replacing the tire, implement the
operation described in the “ Current
position/tire change calibration”. (See
page 87.)
This navigation system uses tire turning data
and is designed to work with factory−speci-
fied tires for your vehicle. Installing tires that
are larger or smaller than the originally
equipped diameter may cause inaccurate
display of the vehicle’s position. The tire pres-
sure also affects the diameter of the tires so
please make sure the tire pressure of all four
tires is correct.
Map database information and
updates
This system uses the maps of DENSO.
© 2006 DENSO CORPORATION
© 2005 NAVTEQ. All rights reserved.
© 2005 Tele Atlas North America, Inc. All
rights reserved. This material is propri-
etary and the subject of copyright protec-
tion and other intellectual property rights
owned by or licensed to Tele Atlas North
America, Inc. The use of this material is
subject to the terms of a license agree-
ment. You will be held liable for any unau-
thorized copying or disclosure of this ma-
terial.
Data by infoUSA Copyright © 2005, All
Rights Reserved.
©2005 VISA Corporation
National Research Bureau ©2005
The Bullseye Design is a registered
trademark of Target Brands, Inc.
END USER TERMS
The data (“Data”) is provided for your
personal, internal use only and not for re-
sale. It is protected by copyright, and is
subject to the following terms and condi-
tions which are agreed to by you, on the
one hand, and DENSO CORPORATION
(“[CLIENT]”) and its licensors (including
their licensors and suppliers) on the other
hand.
© 2005 NAVTEQ. All rights reserved.
The Data for areas of Canada includes
information taken with permission from
Canadian authorities, including: © Her
Majesty the Queen in Right of Canada, ©
Queen’s Printer for Ontario, © Canada
Post Corporation, GeoBase.

203 LIMITED RIGHTS
CONTRACT NO.:
______________________________
CONTRACTOR (MANUFACTURER/
SUPPLIER) NAME: NAVTEQ
CONTRACTOR (MANUFACTURER/
SUPPLIER) ADDRESS:
222 Merchandise Mart Plaza, Suite
900, Chicago, Illinois 60654
The Government’s rights to use,
modify, reproduce, release, perform,
display, or disclose these technical
data are restricted by paragraph (b)(3)
of the Rights in Technical Data−Non-
commercial Items clause contained in
the above identified contract. Any re-
production of technical data or portions
thereof marked with this legend must
also reproduce the markings. Any per-
son, other than the Government, who
has been provided access to such data
must promptly notify the above named
Contractor.
and; (ii) for civilian agency acquisitions,
the NAVTEQ Data is licensed in
accordance with the rights set forth at
FAR 52.227−14(g)(1), RIGHTS IN
DATA−GENERAL (Protection of limited
rights data and computer software). In
the event that the Contracting Officer
requires the delivery of limited rights
NAVTEQ Data that has been withheld or
would otherwise be withholdable in
accordance with FAR 52.227−14(g)(1),
the NAVTEQ Data is licensed with
“Limited Rights” as set forth in the
following “Limited Rights Notice” at FAR
52.227−14(g)(2) (Alternate II), which
shall be affixed to the NAVTEQ Data and
the NAVTEQ Data shall be treated in
accordance with such Notice (which shall
be marked on any reproduction of the
NAVTEQ Data, in whole or in part):LIMITED RIGHTS NOTICE
(JUN 1987)
These data are submitted with limited
rights under Government Contract No.
_____ (and subcontract ______, if ap-
propriate). These data may be repro-
duced and used by the Government
with the express limitation that they will
not, without written permission of the
Contractor, be used for purposes of
manufacture nor disclosed outside the
Government; except that the Govern-
ment may disclose these data outside
the Government for the following pur-
poses, if any, provided that the Gov-
ernment makes such disclosure sub-
ject to prohibition against further use
and disclosure: There are no addition-
al purposes permitting disclosure of
such Data.
The manufacturer/supplier of the Data
is NAVTEQ, 222 Merchandise Mart
Plaza, Suite 900, Chicago, Illinois
60654.
If the Contracting Officer refuses to use
either of the licenses provided in (i) or
(ii), herein, the Contracting Officer
must notify NAVTEQ North America,
LLC prior to seeking additional or alter-
native rights in the NAVTEQ Data.

208 No Warranty. This information is pro-
vided to you “as is,” and you agree to use
it at your own risk. DENSO and its licen-
sors (and their licensors and suppliers,
collectively “DENSO”) make no guaran-
tees, representations or warranties of
any kind, express or implied, arising by
law or otherwise, including but not limited
to, and DENSO expressly disclaims any
warranties regarding content, quality, ac-
curacy, completeness, effectiveness,
reliability, fitness for a particular purpose,
non-infringement, usefulness, use or re-
sults to be obtained from this information,
or that the information or server will be
uninterrupted or error-free. Some states,
territories and countries do not allow cer-
tain warranty exclusions, so to that ex-
tent, the above exclusion may not apply
to you.
Disclaimer of Liability: DENSO SHALL
NOT BE LIABLE TO YOU FOR ANY
CLAIM, DEMAND OR ACTION,
IRRESPECTIVE OF ITS NATURE,
ALLEGING ANY LOSS, INJURY OR
DAMAGES, WHETHER DIRECT,
INDIRECT, INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES,
INCLUDING ANY LOSS OF PROFIT,
REVENUE OR CONTRACTS ARISING
OUT OF YOUR POSSESSION, USE OF
OR INABILITY TO USE THIS
INFORMATION, ANY DEFECT IN THE
INFORMATION, OR THE BREACH OF
THESE TERMS OR CONDITIONS,
WHETHER IN AN ACTION IN
CONTRACT OR TORT OR BASED ON
A WARRANTY, EVEN IF DENSO OR
ITS LICENSORS HAVE BEEN
ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES. Some states,
territories and countries do not allow
certain liability exclusions or damages
limitations, so to that extent the above
may not apply to you.Indemnity. You agree to indemnify,
defend and hold DENSO and its
licensors (including their respective
licensors, suppliers, assignees,
subsidiaries, affiliated companies, and
the respective officers, directors,
employees, shareholders, agents and
representatives of each of them) free and
harmless from and against any liability,
loss, injury (including injuries resulting in
death), demand, action, cost, expense,
or claim of any kind or character,
including but not limited to attorney’s
fees, arising out of or in connection with
any use or possession by you of this
information.
END USER NOTICE
The marks of companies displayed by
this product to indicate business loca-
tions are the marks of their respective
owners. The use of such marks in this
product does not imply any sponsorship,
approval, or endorsement by such com-
panies of this product.

209 There are two types of areas available for
route guidance. In one type of area, pri-
marily around metropolitan centers, de-
tailed route guidance is available for the
entire area. In the other type of area, all
roads are displayed on the map but route
guidance is limited. The navigation route
might lack precision because the data (no
right turns, oneway traffic, etc.) is not
complete. It is still possible to reach the
destination by following the arrow direc-
tion and distance as shown on the bottom
left of the screen. The arrow points in the
direction of the destination. The distance
shown is as measured in a straight line
from the current vehicle position to the
destination area.
In order to provide you with as accurate map
information as possible, we are always gath-
ering information such as on road repairs and
carrying out on−site investigations. However,
the names of roads, streets, facilities, and
their locations are often changed. In some
places, construction on roads may be in pro-
gress. For that reason, information on some
areas in this system might be different from
the actual location.
— Changing the map
DVDROM
7U5001
1. Push the “LOAD·” button. The
“LOAD·EJECT” screen appears.
6U5025aG
2. Touch “MAP ”. The display opens
and the map disc is ejected.
7U5002
3. Insert the new map DVDROM with the
label side up.

210 4. Push the “LOAD·
” button to close
the display.
The map database is normally updated once
a year. Contact your dealer for information
about the availability and pricing of an update.
CAUTION
Do not place anything on the opened
display, as such items may be thrown
about and possibly injure people in
the vehicle during sudden braking or
in an accident.
To reduce the chance of injury in the
case of an accident or sudden stop-
ping while driving, keep the display
closed.
Take care not to jam your hand while
the display is moving. Otherwise, you
could be injured.
NOTICE
Do not obstruct the display while it is
moving. It could damage your naviga-
tion system.
INFORMATION
Under extremely cold conditions, the
display may react slowly or operation
sound may become louder.
To confirm the database version and
disc coverage area
1. Push the “MENU” button.
4U5024aG
2. Touch “Map DVD”.
RS02001
Make sure the version of the database on this
screen. (The database version on the screen
above may be different from the actual
screen.)

211 To display the disc coverage area, touch
“Covered Area”. Confirm the covered area
on the screen.
Contact your dealer to find out if there is a
more recent update released.