TOYOTA AVALON 2001 Service Repair Manual
Page 181 of 1897
17 CD Auto Chenger CD MAGAZINE INSERTED, BUT NO POWER
Radio assembly faulty.
Replace fuse. Check if RADIO No.2 fuse is OK? Is radio operating normally?
CD auto chenger faulty.
ACC wire harness faulty.
Power amplifier faulty.
Radio assembly faulty.No
No
NoNo Ye s
Ye s
Ye s
Ye s OKNG
18 CD Auto Chenger POWER COMING IN, BUT CD AUTO CHENGER NOT OPERATING
Is CD inserted with correct side up?
Is radio operating normally?Insert correctly.
CD magazine faulty.
Protective circuit in
operation. Function OK if different CD magazine inserted?
Has sudden temperature change
occurred inside cabin?
CD auto chenger faulty.Is temperature inside cabin hot?
Speaker wire harness faulty.
Speaker faulty.
Power amplifier faulty.
Recheck system after repair. Dose continuity exist in speaker wire harness?
Temporarily install another speaker.
Functions OK?
Hiss noise from speaker?
Radio assembly faulty.
Recheck system after repair.No
Ye s Ye s
Ye s
Ye s
Ye s
Ye s Ye s
Ye s No
No
NoNo
No
No
No
Formation of
condensation
due to temp. changes.
Is power supplied to ACC terminal of power amplifier?
Is power supplied to ACC terminal of radio assembly?Is power supplied to ACC
terminal of CD auto chenger? BE-152
- BODY ELECTRICALAUDIO SYSTEM
1756 Author: Date:
2001 AVALON (RM808U)
Page 182 of 1897
CD Auto Chenger SOUND JUMPS
19
CD auto chenger faulty. Does sound jump only during strong vibration?
Is CD auto chenger properly installed?
Functions OK if another CD is played?
Has sudden temperature change occurred inside cabin?Jumping caused by vibration.
Install properly.
CD faulty.
Formation of condensation due to
temp. changes. Ye sYe s
Ye s
Ye s No No
No
No
20 CD Auto Chenger SOUND QUALITY POOR (VOLUME FAINT)
Is radio operating normally?CD faulty. Function OK if another CD is played?
Speaker faulty. Temporarily install another speaker.
Functions OK?Ye s
No
Is speaker property installed?CD auto chenger faulty.
Install properly. Ye s
Ye s Ye s No
NoNo
Radio assembly or CD auto chenger or power amplifier faulty.
- BODY ELECTRICALAUDIO SYSTEM
BE-153
1757 Author: Date:
2001 AVALON (RM808U)
Page 183 of 1897
CD auto chenger faulty.
Power amplifier faulty.
Recheck system after repair. Temporarily install another speaker.
Function OK?21 CD Auto Chenger ANY SPEAKER DOES NOT WORK
Speaker wire harness faulty.
Speaker faulty. Is hiss noise produced by non-functioning speaker?
Does continuity exist in speaker wire harness? Is radio operating normally?
Ye sYe s
Ye s
Ye s No
No
NoNoRadio assembly faulty.
Recheck system after repair.
CD auto chenger faulty. 22 CD Auto Chenger CD MAGAZINE WILL NOT BE EJECTED
Is auto search button of radio
operating normally?
NoRadio assembly
faulty.
Replace fuse.
+B wire harness faulty.
Power amplifier faulty.
Radio assembly faulty. Check if RADIO No.1 fuse is OK?No
No
No Ye s
NG
OK
Ye s
Ye sYe s
Is power supplied to +B terminal of power amplifier?
Is power supplied to +B terminal of radio receiver?Is power supplied to +B terminal
of CD auto chenger? BE-154
- BODY ELECTRICALAUDIO SYSTEM
1758 Author: Date:
2001 AVALON (RM808U)
Page 184 of 1897
23 Power Amplifier NO POWER COMING IN
+ B wire harness faulty.
GND faulty.
Power amplifier or wire harness faulty.
Power amplifier or wire harness faulty.
GND faulty. Is tape player operating normally?
Check if RAD-No.2 fuse is OK?Ye s
NG
No OK No
No
No
No OK
OK
OK Ye s
Ye s
Ye s
Ye sNG
NG
NG Check if RAD-No.1 fuse is OK?
Radio assembly faulty.Replace fuse.
ACC wire harness faulty. Radio assembly faulty.
Replace fuse.
Check if GND (wire harness side) of power amplifier
grounded normally?Is power supplied to ACC terminal of power amplifier?
Is power supplied to +B terminal of power amplifier?
Is power supplied to ACC terminal of radio assembly?
Is power supplied to +B terminal of radio assembly?
Check if GND (wire harness side) of radio assembly
grounded normally?
- BODY ELECTRICALAUDIO SYSTEM
BE-155
1759 Author: Date:
2001 AVALON (RM808U)
Page 185 of 1897
24 Power AmplifierPOWER COMIMG IN, BUT WOOFER (POWER) AMPLIFIER NOT
OPERATING
+ B wire harness faulty.
GND faulty.
Power amplifier faulty.
Speaker wire harness faulty. GND faulty. Is tape player operating normally?
Check if RAD-No.2 fuse is OK?Ye s
NG
No OK No
No
No
No OK
OK
OK Ye s
Ye s
Ye s
Ye sNG
NG
NG Check if RAD-No.1 fuse is OK?
Radio assembly faulty. Recheck system after repair.Replace fuse.
ACC wire harness faulty. Radio assembly faulty.
Replace fuse.
Is there continuity in speaker wire harness?
Temporarily install another speaker. Functions OK?
Hiss noise from speaker?Ye s
Ye s NoNo
No Ye sPower amplifier faulty.
Power amplifier faulty.
Recheck system after repair. Speaker faulty.
Is power supplied to ACC terminal of power amplifier?
Check if GND (wire harness side) of power amplifier
grounded normally? Is power supplied to +B terminal of power amplifier?
Is power supplied to ACC terminal of radio assembly?
Is power supplied to +B terminal of radio assembly?
Check if GND (wire harness side) of radio assembly
grounded normally? BE-156
- BODY ELECTRICALAUDIO SYSTEM
1760 Author: Date:
2001 AVALON (RM808U)
Page 186 of 1897
CD player faulty.
Power amplifier faulty.
Recheck system after repair. Temporarily install another speaker.
Function OK?25 Power Amplifier ANY SPEAKER DOES NOT WORK
Speaker wire harness faulty.
Speaker faulty. Is hiss noise produced by non-functioning speaker?
Does continuity exist in speaker wire harness? Is radio operating normally?
Ye sYe s
Ye s
Ye s No
No
NoNoRadio assembly faulty.
Recheck system after repair.
- BODY ELECTRICALAUDIO SYSTEM
BE-157
1761 Author: Date:
2001 AVALON (RM808U)
Page 187 of 1897
26 Noise NOISE OCCURS
No
Ye s
NG
OK Does the noise occur only in the radio?
Does the noise occur in a particular place?
Is there any additional installation part
around the glass imprinted antenna?
(Sun shade film, telephone antenna etc.)
Does the noise occur even pulling out the
antenna cord from the radio?
Does the noise occur even after pulling out the
antenna terminal on the glass surface?
Isn't there any adhesive (Butyl rubber)
stuck on the bases of the antenna
terminal, defogger terminal and bus bar?
Check the grounding of the antenna,
antenna cord, coke coil, and noise filter.
(See page BE-126) Does the noise occur even after pulling out
the defogger terminal?
Does the condition get better by replacing
the antenna cord.
Noise rediates directly to the antenna from the
generation source. Does the condition get better by replacing
the choke coil?
Replace the antenna cord. Replace the choke coil. Interfering noise from the defogger line
and choke coil.
Grounding failure. Failure of glass installation.
Must plane the butyl rubber. Noise mixing into the antenna cable. Check the radio. Influence of the film or the noise radiation
of the additional installation part. Does the noise stop by removing it? An electric environment.Refer to No.27. (It occurs in the cassette and CD.)
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s No
No
No
No
No
No
No
No
BE-158
- BODY ELECTRICALAUDIO SYSTEM
1762 Author: Date:
2001 AVALON (RM808U)
Page 188 of 1897
27 Noise NOISE PRODUCED BY VIBRATION OR SHOCK WHILE DRIVING
No
Ye s Is speaker properly installed?
Noise is produced from static eletricity accumulating in the vehicle body. With vehicles stationary lightly tap each system.
Is noise produced?Install properly.
Each system faulty. Is speaker properly installed?
No
No Ye s
Ye s
28 Noise NOISE PRODUCED WHEN ENGINE STARTS
NoYe s Whistling noise which becomes high-pitched when
accelerator strongly depressed, disappears shortly
after engine stops.Generator noise.
A/C noise.
Fuel gauge noise.
Horn noise.
Ignition noise.
Turn signal noise.
Washer noise.
Engine coolant temp. gauge noise.
Wiper noise. Whining noise occurs when A/C is operating.
Scratching noise occurs during sudden acceleration, driving on rough
roads or when ignition switch is turned ON.
Clicking sound is heard when horn button is pressed, then
released. Whirring/grating sound is heard when pushed
continuously.
Murmuring sound stops when engine stops.
Tick-tack noise occurs in co-ordination with blinking
offlasher.
Noise occurs during window washer operation.
Scratching noise occurs while engine is running,
and continues a while even after engine stops.
Scraping noise in line with wiper beat.
Other type of noiseYe s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s No
No
No
No
No
No
No
No
- BODY ELECTRICALAUDIO SYSTEM
BE-159
1763 Author: Date:
2001 AVALON (RM808U)
Page 189 of 1897
BE04P-05
- BODY ELECTRICALBODY ELECTRICAL SYSTEM
BE-1
1605 Author: Date:
2001 AVALON (RM808U)
BODY ELECTRICAL SYSTEM
PRECAUTION
HINT:
Take care to observe the following precautions when performing inspections or removal and replacement
of body electrical related parts.
1. HEADLIGHT SYSTEM
Halogen bulbs have pressurized gas inside and require special handling. They can burst if scratched or
dropped. Hold a bulb only by its plastic or metal case. Don't touch the glass part of a bulb with bare hands.
2. SRS (SUPPLEMENTAL RESTRAINT SYSTEM)
The AVALON is equipped with an SRS (Supplemental Restraint System) such as the driver airbag and front
passenger airbag. Failure to carry out service operation in the correct sequence could cause the SRS to
unexpectedly deploy during servicing, possibly leading to a serious accident. Before servicing (including re-
moval or installation of parts, inspection or replacement), be sure to read the precautionary notices in the
RS section.
3. AUDIO SYSTEM
If the negative (-) terminal cable is disconnected from the battery, the preset AM, FM 1 and FM 2 sta-
tions stored in memory are erased, so make sure to note the stations and reset them after the negative
(-) terminal cable is reconnected to the battery.
If the negative (-) terminal cable is disconnected from the battery, the radio, tape player and CD player
will not operate as well as audio anti - theft system. Be sure to input the correct ID number so that the
radio, tape player and CD player can be operated again.
4. MOBILE COMMUNICATION SYSTEM
If the vehicle is equipped with a mobile communication system, refer to precautions in the IN section.
Page 190 of 1897
BE0I5-03
I0502712
3 5
1
2 3
5
BE-34
- BODY ELECTRICALBACK-UP LIGHT SYSTEM
1638 Author: Date:
2001 AVALON (RM808U)
INSPECTION
INSPECT BACK-UP LIGHT RELAY CONTINUITY
ConditionTester connectionSpecified condition
Constant1 - 2Continuity
Apply B+ between
terminals 1 and 2.3 - 5Continuity
If continuity is not as specified, replace the relay.