fluid TOYOTA AVALON 2001 Service Manual PDF
Page 1440 of 1897
IN04Q-08
- INTRODUCTIONTERMS
IN-35
35 Author: Date:
2001 AVALON (RM808U)
TERMS
ABBREVIATIONS USED IN THIS MANUAL
AbbreviationsMeaning
ABSAnti-Lock Brake System
ACAlternating Current
ACCAccessory
ACISAcoustic Control Induction System
ACSDAutomatic Cold Start Device
A.D.D.Automatic Disconnecting Differential
A/FAir-Fuel Ratio
AHCActive Height Control Suspension
ALRAutomatic Locking Retractor
ALTAlternator
AMPAmplifier
ANTAntenna
APPROX.Approximately
A/TAutomatic Transmission (Transaxle)
AT FAutomatic Transmission Fluid
AUTOAutomatic
AUXAuxiliary
AV GAverage
AV SAdaptive Variable Suspension
BABrake Assist
BACSBoost Altitude Compensation System
BATBattery
BDCBottom Dead Center
B/LBi-Level
B/SBore-Stroke Ratio
BTDCBefore Top Dead Center
BVSVBimetallic Vacuum Switching Valve
Calif.California
CBCircuit Breaker
CCoCatalytic Converter For Oxidation
CDCompact Disc
CFCornering Force
CGCenter Of Gravity
CHChannel
COMB.Combination
CPECoupe
CPSCombustion Pressure Sensor
CPUCentral Processing Unit
CRSChild Restraint System
CTRCenter
C/VCheck Valve
CVControl Valve
Page 1468 of 1897
MA01O-02
B08915
- MAINTENANCECHASSIS
MA-7
49 Author: Date:
2001 AVALON (RM808U)
CHASSIS
INSPECTION
1. INSPECT STEERING LINKAGE
(a) Check the steering wheel free-play (See page SR-8).
(b) Check the steering linkage for looseness or damage.
Check that:
Tie rod ends do not have excessive play.
Dust seals and boots are not damaged.
Boot clamps are not loose.
2. INSPECT SRS AIRBAG (See pages RS-15, RS-30)
3. INSPECT STEERING GEAR HOUSING OIL
Check the steering gear housing for oil leakage.
4. INSPECT DRIVE SHAFT BOOTS
Check the drive shaft boots for clamp looseness, leakage or
damage.
5. INSPECT BALL JOINTS AND DUST COVERS
(a) Inspect the ball joints for excessive looseness.
Jack up the front of the vehicle and place wooden
blocks with a height of 180 - 200 mm (7.09 - 7.87
in.) under the front tires.
Lower the jack until there is about half a load on the
front coil spring. Place stands under the vehicle for
safety.
Check that the front wheels are pointing straight
ahead, and block them with chocks.
Using a lever, pry up the end of the lower arm, and
check the amount of play.
Maximum ball joint vertical play: 0 mm (0 in.)
If there is play, replace the ball joint.
(b) Check the dust cover for damage.
6. CHECK TRANSAXLE FLUID
Visually check the transaxle for fluid leakage.
If leakage is found, check for the cause and repair.
7. REPLACE TRANSAXLE FLUID (See page DI-160)
Page 1474 of 1897
MA001-12
- MAINTENANCEOUTSIDE VEHICLE
MA-1
43 Author: Date:
2001 AVALON (RM808U)
OUTSIDE VEHICLE
GENERAL MAINTENANCE
These are maintenance and inspection items which are considered to be the owner's responsibility.
They can be done by the owner or they can have them done at a service shop.
These items include those which should be checked on a daily basis, those which, in most cases, do not
require (special) tools and those which are considered to be reasonable for the owner to do.
Items and procedures for general maintenance are as follows.
1. GENERAL NOTES
Maintenance items may vary from country to country. Check the owner's manual supplement in which
the maintenance schedule is shown.
Every service item in the periodic maintenance schedule must be performed.
Periodic maintenance service must be performed according to whichever interval in the periodic main-
tenance schedule occurs first, the odometer reading (miles) or the time interval (months).
Maintenance service after the last period should be performed at the same interval as before unless
otherwise noted.
Failure to do even one item an cause the engine to run poorly and increase exhaust emissions.
2. TIRES
(a) Check the pressure with a gauge. If necessary, adjust.
(b) Check for cuts, damage or excessive wear.
3. WHEEL NUTS
When checking the tires, check the nuts for looseness or for missing nuts. If necessary, tighten them.
4. TIRE ROTATION
Check the owner's manual supplement in which the maintenance schedule is shown.
5. WINDSHIELD WIPER BLADES
Check for wear or cracks whenever they do not wipe clean. If necessary, replace.
6. FLUID LEAKS
(a) Check underneath for leaking fuel, oil, water or other fluid.
(b) If you smell gasoline fumes or notice any leak, have the cause found and corrected.
7. DOORS AND ENGINE HOOD
(a) Check that all doors including the trunk lid operate smoothly, and that all latches lock securely.
(b) Check that the engine hood secondary latch secures the hood from opening when the primary latch
is released.
Page 1475 of 1897
MA003-12
MA-4
- MAINTENANCEUNDER HOOD
46 Author: Date:
2001 AVALON (RM808U)
UNDER HOOD
GENERAL MAINTENANCE
1. GENERAL NOTES
Maintenance items may vary from country to country. Check the owner's manual supplement in which
the maintenance schedule is shown.
Every service item in the periodic maintenance schedule must be performed.
Periodic maintenance service must be performed according to whichever interval in the periodic main-
tenance schedule occurs first, the odometer reading (miles) or the time interval (months).
Maintenance service after the last period should be performed at the same interval as before unless
otherwise noted.
Failure to do even one item an cause the engine to run poorly and increase exhaust emissions.
2. WINDSHIELD WASHER FLUID
Check that there is sufficient fluid in the tank.
3. ENGINE COOLANT LEVEL
Check that the coolant level is between the ºFULLº and ºLOWº lines on the see-through reservoir.
4. RADIATOR AND HOSES
(a) Check that the front of the radiator is clean and not blocked with leaves, dirt or bugs.
(b) Check the hoses for cracks, kinks, rot or loose connections.
5. BATTERY ELECTROLYTE LEVEL
Check that the electrolyte level of all battery cells is between the upper and lower level lines on the case.
6. BRAKE FLUID LEVEL
Check that the brake fluid level is near the upper level line on the see-through reservoirs.
7. ENGINE DRIVE BELTS
Check drive belt for fraying, cracks, wear or oiliness.
8. ENGINE OIL LEVEL
Check the level on the dipstick with the engine turned off.
9. POWER STEERING FLUID LEVEL
Check the level.
The level should be in the ºHOTº or ºCOLDº range depending on the fluid temperature.
10. AUTOMATIC TRANSMISSION FLUID LEVEL
(a) Park the vehicle on a level surface.
(b) With the engine idling and the parking brake applied, shift the selector into all positions from ºPº to ºLº,
and then shift into ºPº position.
(c) Pull out the dipstick and wipe off the fluid with a clean rag. Re-insert the dipstick and check that the
fluid level is in the ºHOTº range.
(d) Do this check with the fluid at normal driving temperature (70 - 80°C, 158 - 176°F).
HINT:
Wait until the engine cools down (approx. 30 min.) before checking the fluid level after extended driving at
high speeds, in hot weather, in heavy traffic or pulling a trailer.
11. EXHAUST SYSTEM
If any change in the sound of the exhaust or smell of the exhaust fumes is noticed, have the cause located
and corrected.
Page 1482 of 1897
PP0M4-05
- PREPARATIONAUTOMATIC TRANSAXLE
PP-31
81 Author: Date:
2001 AVALON (RM808U)
LUBRICANT
ItemCapacityClassification
Automatic transaxle fluid
(w/o Differential oil)
Dry fill
Drain and refill
8.0 liters (8.5 US qts, 7.0 Imp. qts)
4.75 liters (5.0 US qts, 4.2 Imp. qts)ATF D-II or DEXRON®III (DEXRON®II)
Page 1485 of 1897
PP0B4-01
- PREPARATIONBODY ELECTRICAL
PP-55
105 Author: Date:
2001 AVALON (RM808U)
EQUIPMENT
Voltmeter
Ammeter
Ohmmeter
Test lead
ThermometerEngine oil level warning switch, Seat heater
SyphonBrake fluid level warning switch
Oil bathEngine oil level warning switch
Bulb (3 W)Fuel sender gauge
Bulb (3.4 W)Seat belt warning relay
Bulb (21 W)Turn signal flasher relay
Dry cell batteryFuel sender gauge
Heat lightSeat heater
Torque wrench
Masking tapeRear window defogger wire
Tin foilRear window defogger wire
Page 1500 of 1897
PP0UC-02
- PREPARATIONBRAKE
PP-41
91 Author: Date:
2001 AVALON (RM808U)
LUBRICANT
ItemCapacityClassification
Brake fluid-SAE J1703 or FMVSS No. 116 DOT3
Page 1538 of 1897
PP0V7-02
PP-48
- PREPARATIONSTEERING
98 Author: Date:
2001 AVALON (RM808U)
LUBRICANT
ItemCapacityClassification
Power steering fluid
Total0.8 liters (0.8 US qts, 0.7 lmp.qts)ATF DEXRON® II or III
Page 1542 of 1897
- PREPARATIONSTEERING
PP-43
93 Author: Date:
2001 AVALON (RM808U)
09631-12071Steering Rack Oil Seal Test ToolPS gear
09631-20081Seal Ring ToolPS gear
09631-33010Steering Rack Cover ºIºPS gear
09640-10010Power Steering Pressure Gauge
SetPower steering fluid
(09641-01010)Gauge Assy
(09641-01030)Attachment B
(09641-01060)Attachment E
09910-00015Puller SetTilt steering column
(09911-0001 1)Puller Clamp
(09912-00010)Puller Slide Hammer
09922-10010Variable Open WrenchPS gear
09950-50012Puller C SetTilt steering column
(09951-05010)Hanger 150
Page 1581 of 1897
SS0G9-03
SS-32
- SERVICE SPECIFICATIONSSTEERING
148 Author: Date:
2001 AVALON (RM808U)
STEERING
SERVICE DATA
DRIVE BELT
Drive belt tension* New belt120 - 185 lbf
Drive belt tension* Used belt95 - 135 lbf
POWER STEERING FLUID
Fluid level rise Maximum5 mm (0.20 in.)
Fluid pressure at idle speed with valve closed Minimum7,845 kPa (80 kgf/cm2, 1,138 psi)
STEERING WHEEL
Steering wheel freeplayMaximum30 mm (1.18 in.)
Steering effort at idle speedReference5.9 N´m (60 kgf´cm, 52 in.´lbf)
POWER STEERING VANE PUMP
Vane pump rotating torque0.3 N´m (2.8 kgf´cm, 2.4 in.´lbf) or less
Oil clearance between pump shaft and bushing STD0.03 - 0.05 mm (0.0012 - 0.0020 in.)
Oil clearance between pump shaft and bushingMaximum0.07 mm (0.0028 in.)
Vane plate heightMinimum8.6 mm (0.339 in.)
Vane plate thickness Minimum1.397 mm (0.0550 in.)
Vane plate lengthMinimum14.991 mm (0.5902 in.)
Clearance between the rotor groove and plateMaximum0.035 mm (0.0014 in.)
Vane plate length Pump rotor and cam ring mark
None14.999 - 15.001 mm (0.59051 - 0.59059 in.)
114.997 - 14.999 mm (0.59043 - 0.59051 in.)
214.995 - 14.997 mm (0.59035 - 0.59043 in.)
314.993 - 14.995 mm (0.59027 - 0.59035 in.)
414.991 - 14.993 mm (0.59020 - 0.59027 in.)
Spring free length Minimum32.3 mm (1.272 in.)
POWER STEERING GEAR
Steering rack runout Maximum0.03 mm (0.0012 in.)
Total preload (Control valve rotating torque)0.8 - 1.4 N´m (8 - 14 kgf´cm, 6.9 - 12.2 in.´lbf)
*: For use with belt tension gauge