TOYOTA AVALON 2001 Service Repair Manual
Page 861 of 1897
AB0119
I00167
I00172
ON
IDL
(-) (+)
DI-576
- DIAGNOSTICSCRUISE CONTROL SYSTEM
732 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check voltage between terminal IDL of cruise control ECU connector and body
ground.
PREPARATION:
(a) Remove the ECU with connector still connected.
(b) Disconnect the ECM connector.
(c) Turn ignition switch ON.
CHECK:
Measure voltage between terminal IDL of ECU connector and
body ground when the throttle valve is fully closed and fully
opened.
OK:
Throttle valve positionVoltage
Fully opened10 - 14 V
Fully closedBelow 2 V
OK Proceed to next circuit inspection shown in
problem symptom table (See page DI-560).
NG
2 Check harness and connector between ECM and throttle position sensor (See
page IN-30).
NG Repair or replace harness or connector.
OK
3 Check throttle position sensor circuit (See page DI-38).
NG Replace throttle position sensor.
OK
Page 862 of 1897
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-577
733 Author: Date:
2001 AVALON (RM808U)
4 Check throttle position sensor.
NG Replace throttle position sensor.
OK
5 Check for open and short in harness and connector between cruise control ECU
and ECM (See page IN-30).
NG Repair or replace harness or connector.
OK
Check and replace cruise control ECU (See
page IN-30).
Page 863 of 1897
DI-596
- DIAGNOSTICSCRUISE CONTROL SYSTEM
752 Author: Date:
2001 AVALON (RM808U)
Actuator Control Cable
INSPECTION PROCEDURE
1 Actuator control cable inspection
OK:
(a) Check that the actuator and control cable throttle link are properly installed and that the cable and link
are connected correctly.
(b) Check that the actuator and bell crank operate smoothly.
(c) Check that the cable is not loose or too tight.
OK:
Freeplay: less than 10 mm
HINT:
If the control cable is very loose, the vehicle's loss of speed going uphill will be large.
If the control cable is too tight, the idle RPM will become high.
DI6L9-01
Page 864 of 1897
AB0119
I00145
I00177
ON
CAN
(-) (+)
DI-590
- DIAGNOSTICSCRUISE CONTROL SYSTEM
746 Author: Date:
2001 AVALON (RM808U)
Cancel Switch Circuit (Cruise Control Switch)
CIRCUIT DESCRIPTION
When the cruise control cancel switch is turned ON, the cruise control does not operate.
WIRING DIAGRAM
See page DI-572.
INSPECTION PROCEDURE
1 Check voltage between terminal CAN of cruise control ECU connector and body
ground.
PREPARATION:
(a) Remove the ECU with connector still connected.
(b) Turn ignition switch ON.
CHECK:
Measure voltage between terminal CAN of cruise control ECU
connector when main switch is held ON and OFF.
OK:
Main switchVoltage
OFF10 - 14 V
ONBelow 0.5 V
OK Proceed to next circuit inspection shown on
problem symptom table (See page DI-560).
NG
DI6L8-01
Page 865 of 1897
N16045
3
4
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-591
747 Author: Date:
2001 AVALON (RM808U)
2 Check cancel switch continuity.
PREPARATION:
(a) Remove steering wheel center pad (See page SR-12).
(b) Disconnect the control switch connector.
CHECK:
Check continuity between terminals 3 and 4 of control switch
connector when cancel switch is held ON and OFF.
OK:
Switch positionTester connectionSpecified condition
OFF3 - 4No continuity
Hold ON3 - 4Continuity
NG Replace control switch.
OK
3 Check harness and connector between cruise control ECU and cancel switch
(See page IN-30).
NG Repair or replace harness or connector.
OK
Check and replace cruise control ECU (See
page IN-30).
Page 866 of 1897
I13610
Cruise Control ECU
4
PI
R-B
W-B10
1D
IF17W-R
4 IG1 AM1Ignition Switch 2
W
AM1 GAUGE NO. 1
2 1
5
B-L1
ALTFL Block
1 B
FL MAIN
BatteryF8 2G1
F6 F10
1
1
2H
B 5
W-LW-L 1
43 3
1B1
1G
4
1C IG1 RERAY 4
4D13
4F4
M7 M64
4H17
4A17
GR-R
R-BGR-R Cruise Control
Indicator Light
(in Multi Display)
IG
C15
I15
2J/B No. 4 J/B No. 4
Driver Side J/B
Engine Room R/B No. 5
Engine Room J/B DI-592
- DIAGNOSTICSCRUISE CONTROL SYSTEM
748 Author: Date:
2001 AVALON (RM808U)
CRUISE MAIN Indicator Light Circuit
CIRCUIT DESCRIPTION
When the cruise control main switch is turned ON, CRUISE MAIN indicator light lights up.
WIRING DIAGRAM
DI090-28
Page 867 of 1897
AB0119
I00144
I00178
ON
PI
(-) (+)
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-593
749 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check voltage between terminals PI and GND of cruise control ECU connector.
PREPARATION:
Tun ignition switch ON.
CHECK:
Measure voltage between terminals PI and GND of cruise con-
trol ECU connector when main switch is ON and OFF.
OK:
Switch positionVoltage
OFF10 - 16 V
ONBelow 1.2 V
OK Proceed to next circuit inspection shown in
problem symptom table (See page DI-560).
NG
2 Check combination meter (See page BE-2).
NG Replace combination meter.
OK
Check and replace cruise control ECU (See
page IN-30).
Page 868 of 1897
I13609
Cruise Control ECU
4
PI
5
TC GR-R 10
4 DLC2
22 DLC1
II23B
LG-R A/D
Tc
Tc13
LG-R3A 13
3G 4 4A17
4B17
GR-R
LG-R
4H6
4A6
LG-R LG-R11D2
D1
C15
J/B No. 4
J/B No. 3
J/B No. 4 DI-594
- DIAGNOSTICSCRUISE CONTROL SYSTEM
750 Author: Date:
2001 AVALON (RM808U)
Diagnosis Circuit
CIRCUIT DESCRIPTION
This circuit sends a signal to the ECU that outputs DTC.
WIRING DIAGRAM
DI091-15
Page 869 of 1897
AB0119
I00169
I00179
ON
TC E1
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-595
751 Author: Date:
2001 AVALON (RM808U)
INSPECTION PROCEDURE
1 Check voltage between terminals Tc and E1 of DLC2.
PREPARATION:
Turn ignition switch ON.
CHECK:
Measure voltage between terminals Tc and E1 of DLC2.
OK:
Voltage: 10 - 14 V
OK Proceed to next circuit inspection shown in
problem symptom table (See page DI-560).
NG
2 Check harness and connector between cruise control ECU and DLC2, DLC2 and
body ground (See page IN-30).
NG Repair or replace harness or connector.
OK
Check and replace cruise control ECU (See
page IN-30).
Page 870 of 1897
I13611
Cruise Control ECU
9
B
Y-R
IG B 3 1
4IG1 RELAY
2
AM1 ECU-IG NO. 2
5 5
B-L
ALT FL Block
F6
B
FL MAIN
BatteryW-BW-B 1
2G
F8
W-B AA
J5
J/C 1 F101 1
1G
3
1B
1
2H13
1B
4
1C2
3C2
3D
7
IF1
7
3A20
3BGND
1W-B16 W-B WY-R
W-R42
I15Ignition Switch
C15
W-L
W-L
B-LIG1 AM1
2
1J/B No. 3
Driver Side J/B
Engine Room J/B
Engine Room R/B No. 5
J/B No. 3
- DIAGNOSTICSCRUISE CONTROL SYSTEM
DI-587
743 Author: Date:
2001 AVALON (RM808U)
ECU Power Source Circuit
CIRCUIT DESCRIPTION
The ECU power source supplies power to the actuator and sensors, etc, when terminal GND and the cruise
control ECU case are grounded.
WIRING DIAGRAM
DI08X-15