remote control TOYOTA AVALON 2004 XX30 / 3.G Navigation Manual

AVALON_Navi_U (L/O 0408)
vi
2004 AVALON Navigation from Aug. ’04 Prod. (OM41413U)
Display, symbols and switches
Northup or headingup symbol and
scale of map
Indicates a map view with north up or
heading up. Touching this symbol
changes the map orientation. The figure
also indicates the map scale. For
details, see page 46.
Clock
The digital clock
indicates the time. For
details, see page 110.
Distance and time to destination
Displays the distance and the
estimated travel time to the
destination. The direction will be
indicated when your vehicle is off
the route. For details, see page 31.
Operation guide
To display the switch
function on each screen. Current vehicle position mark
To indicate the current position,
see page 35 for details.
Signal reception
portion
Receives the signals
from the remote
controller. For details,
see page 2.
Outside temperature
display
The display indicates the
outside temperatures.
For details, see page
111.

AVALON_Navi_U (L/O 0408)
3
2004 AVALON Navigation from Aug. ’04 Prod. (OM41413U)
The controller can be removed from its
original position, and be used as a
wireless remote controller. To use it as
a remote controller, direct the signal
output portion of the controller to the
signal reception portion of the display.
CAUTION
If dropped, the navigation controller
may interfere with the accelerator and
brake pedals. To prevent this, keep
the controller in its original position
while driving.
NOTICE
Observe the following, otherwise the
navigation controller may be dam-
aged.
Do not leave the controller exposed
to high temperatures (such as on
the instrument panel) for a long
time.
Do not drop or knock the controller
hard against other objects.
Do not sit or place heavy objects
on the controller.
Do not modify or disassemble.
1NO104
TO REMOVE THE CONTROLLER
1. Push the “PUSH” button.
2. Lift up the rear edge of the controller,
and pull it to backward.
1NO105
TO FIT THE CONTROLLER IN PLACE
1. Insert the front edge of the controller.
2. Push down the rear edge of the con-
troller until it is fixed.