clock TOYOTA HIGHLANDER HYBRID 2016 XU50 / 3.G User Guide
Page 445 of 608
4456-3. Do-it-yourself maintenance
HIGHLANDER_HV_U (OM48F12U)
6
Maintenance and care
■Front fog lightsRemove the 3 screws and
partly remove the fender
liner.
Unplug the connector while
pressing the lock release.
Turn the bulb base counter-
clockwise.
Install a new light bulb.
Align the 3 tabs on the light bulb
with the mounting and insert.
1
2
3
4
Page 446 of 608
4466-3. Do-it-yourself maintenance
HIGHLANDER_HV_U (OM48F12U)
Turn clockwise and secure
the bulb base.
Install the connector.
Shake the connector gently to
check that it is not loose, turn
the front fog lights on once and
visually confirm that no light is
leaking through the mounting.
When installing the fender liner, install by conducting with the
directions reversed.
Make sure that the fender liner is attached to the inside of the bumper.
5
6
71
Page 447 of 608
4476-3. Do-it-yourself maintenance
HIGHLANDER_HV_U (OM48F12U)
6
Maintenance and care
■Stop/tail lights and rear side marker lights, and rear turn signal
lights
Open the back door and
remove the 2 screws, and
remove the lamp assembly
by pulling it directly backward
from the rear of the vehicle.
Remove the wire harness.
Turn the bulb base counterclockwise.
1
2
3
Stop/tail lights and rear side
marker lightsRear turn signal lights
Page 449 of 608
4496-3. Do-it-yourself maintenance
HIGHLANDER_HV_U (OM48F12U)
6
Maintenance and care
■Tail lights and back-up lightsOpen the back door and
remove the cover.
Insert a flathead screwdriver or
similar into the hole at the top of
the cover and remove it as
shown in the illustration.
To prevent damaging the vehi-
cle, wrap the flathead screw-
driver with a tape.
Turn the bulb base counterclockwise.
Remove the light bulb.
When installing, reverse the steps listed.
1
2
Tail lightsBack-up lights
3
Tail lightsBack-up lights
4
Page 495 of 608
4957-2. Steps to take in an emergency
7
When trouble arises
HIGHLANDER_HV_U (OM48F12U)
Attach the adapter socket to the
spare tire clamp bolt.
Assembling the jack handle.
Remove the jack handle and
assemble it by following these
steps.
Loosen the screw.
Assemble the jack handle
and tighten the screw.
Check that the screw is firmly
tightened.
Connect the jack handle to the
adapter socket. Turn the jack
handle counterclockwise.
The tire will be lowered com-
pletely to the ground.
Turn the jack handle slowly to
lower the spare tire. If the handle
is turned quickly, as doing so
may cause the shaft to disen-
gage and the tire may not be low-
ered.
If the spare tire cannot be low-
ered: P. 502
5
6
1
2
7
Page 502 of 608
5027-2. Steps to take in an emergency
HIGHLANDER_HV_U (OM48F12U)
■If the spare tire cannot be lowered
If the spare tire cannot be lowered, it may not have been stowed properly.
Perform the following procedure:
If the spare tire still cannot be lowered, the wire cable may be severed.
Have the vehicle inspected by your Toyota dealer. Fully tighten the spare tire clamp bolt
by turning the jack handle clockwise
until two clicks are heard and the jack
handle skips.
Turn the jack handle counterclock-
wise to lower the spare tire.
If the spare tire still cannot be low-
ered, attempt to fully tighten the spare
tire clamp bolt again by turning the
jack handle clockwise. Then turn it
counterclockwise at least 2 turns to
lower the spare tire.
1
2
Page 507 of 608
5077-2. Steps to take in an emergency
7
When trouble arises
HIGHLANDER_HV_U (OM48F12U)
Before raising the tire, make
sure that the hoist assembly is
perpendicular to the wheel
opening. (Try to place the tire
directly beneath the vehicle,
near where the wire cable is
hanging from.)
Using the jack handle and adapter socket, tighten the tire clamp
bolt by turning it clockwise until the tire is in the correct position and
two clicks are heard as the jack handle skips.
Stow the jack and all tools.
Valve stem
5
6
7
Page 509 of 608
5097-2. Steps to take in an emergency
7
When trouble arises
HIGHLANDER_HV_U (OM48F12U)
Lay the tire on the ground with
the outer surface (valve stem)
facing up.
When stowing the tire, make
sure that the hoist assembly is
placed perpendicular to the
wheel opening.
Using the jack handle and adapter socket, tighten the spare tire
clamp bolt by turning it clockwise un til the tire is in the correct posi-
tion and two clicks are heard as the jack handle skips.
Install the inside spare tire
cover to the outside spare tire
cover.
Stow the jack and all tools.5
Va l v e s t e m
6
7
8
9
Page 595 of 608
595Alphabetical index
HIGHLANDER_HV_U (OM48F12U)
Care................................... 382, 386Aluminum wheels.................. 383
Exterior ................................. 382
Interior................................... 386
Seat belts .............................. 387
Cargo hooks............................. 351
CD player
*
Chains....................................... 321
Child restraint system ............... 62 Booster seats, definition ......... 63
Booster seats, installation ....... 74
Convertible seats, definition ............................... 63
Convertible seats,
installation ............................ 70
Front passenger occupant classification syst em............. 54
Infant seats, definition ............. 63
Infant seats, installation .......... 70
Installing CRS with LATCH anchors .................... 68
Installing CRS with seat belts ...................................... 70
Installing CRS with top tether strap ........................... 76
Child safety ................................ 61 12-volt battery
precautions ................. 413, 523
Airbag precautions .................. 44
Back door precautions .......... 139
Child restraint system ............. 62
Glass hatch precautions ....... 145
How your child should wear the seat belt .......................... 37
Installing child restraints ......... 66
Moon roof precautions .......... 186 Panoramic moon roof
precautions......................... 191
Power window lock switch .... 180
Power window precautions ... 182
Rear door child-protectors .... 131
Removed electronic key battery precautions............. 433
Seat belt extender
precautions........................... 40
Seat belt precautions .............. 39
Seat heater precautions ....... 338
Child-protectors ...................... 131
Cleaning ........................... 382, 386 Aluminum wheels ................. 383
Exterior ................................. 382
Interior .................................. 386
Seat belts.............................. 387
Clock......................................... 355
Coat hooks ............................... 361
Compass .................................. 376
Condenser................................ 407
Console box ............................. 345
Conversation mirror ................ 354
Cooling system........................ 406 Hybrid system overheating ... 525
Cruise control Cruise control ....................... 266
Dynamic radar cruise
control ................................ 271
Cup holders ............................. 347
Curtain shield airbags............... 42
Customizable features ............ 560
C
*: Refer to “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”