tow TOYOTA MR2 SPYDER 2001 Accessories, Audio & Navigation (in English)

Page 6 TOYOTARS3200 REMOTE KEYLESS Security system
OPERATION
ARMING THE RS3200 (except PASSIVE ARMING)
The system may be ARMEDin several ways. Do oneof the following:
Lock the doors with your key:
Remove the key from the ignition switch.
Exit the vehicle, and close all the doors.*
Close the trunk or hatch, if necessary.*
Insert the key into the door key switch and turn it toward the front of \
the vehicle: The S
TATUSMONITOR’SLED turns on for 30 seconds, then
starts flashing. The system is now ARMED.
Lock the doors from inside the vehicle:
Remove the key from the ignition switch.
Open the driver’s or front passenger’s door.
Push the central lock switch.
Exit the vehicle, and close all the doors.*
Close the trunk or hatch, if necessary.* Then: The S
TATUSMONITOR’SLED turns on for 30 seconds, then
starts flashing. The system is now ARMED.
Lock the doors with the remote control:
Remove the key from the ignition switch.
Exit the vehicle, and close all the doors.*
Close the trunk or hatch, if necessary.*
Press the LOCK button on the remote control. Simultaneously: The doors lock.

The vehicle’s tail and marker lights flash once.
The buzzer chirps once.
The STATUSMONITOR’SLED turns on for 30 seconds, then
starts flashing. The system is now ARMED.
* The system will not A
RMwhile any of the doors, trunk or hatch is open. However, when you press
the LOCK button when the trunk is open, the doors will lock; the system \
will arm 30 seconds
after the trunk is closed.

TURN TOWARD THE FRONT
OF THE VEHICLE

PRESS AND RELEASETHE LOCK BUTTON

PUSH THE LOCK SWITCH WHILE THE DOOR IS OPEN
LIGHTS FOR30SECONDS(PRE-ARMING)THEN
FLASHES
(SYSTEM IS ARMED)

THE TAIL AND MARKER LIGHTS FLASH ONCE WHEN THE SYSTEM IS REMOTE ARMED
ALL DOORS LOCK WHEN THE
SYSTEM IS REMOTE ARMED
THE BUZZER CHIRPS ONCE WHEN THE SYSTEM IS REMOTE ARMED

TOYOTARS3200 remote keyless Security systemPage 7
OPERATION
DISARMING THE RS3200 (except PASSIVE DISARMING)
The system may be DISARMEDin several ways. Do oneof the following:
Unlock the doors with your key:
Insert the key into the door key switch and turn it toward the rear of
the vehicle: The S
TATUSMONITOR’SLED stops flashing. The system is
now D
ISARMED.*
In the case of Sienna and 4Runner, you may also disarm the
system using the key in the back door; all the doors will unlock at the
same time. This feature is not available for Celica; you must disarm
the system before opening the hatch, or else an A
LARMwill be
Triggered.
Unlock the doors with the remote control:
Press the UNLOCK button on the remote control. Simultaneously: The driver’s door unlocks.

The vehicle’s tail and marker lights flash twice.
The interior lights turn on for 30 seconds.
The STATUSMONITOR’SLED stops flashing. The system is
now D
ISARMED.*
Press the UNLOCK button again within 3 seconds after unlocking the driver’s door to unlock the remaining doors.
Use the ignition switch:
Insert the key into the ignition switch, then turn it to ON. The S
TATUSMONITOR’SLED stops flashing. The system is
now D
ISARMED.*
This method of disarming is rarely used. You must be inside the
vehicle while the system is armed in order to do it.
NOTE: If your vehicle’s tail and marker lights turn on and the buzzer sound\
s for 2 seconds when the system is D
ISARMED, the TRIGGERMEMORYwas activated; an ALARMwas
T
RIGGEREDwhile you were away from the vehicle.
* Please note, if the system utilizes your vehicle’s engine immobilizer\
system LED instead of the S
TATUSMONITOR, the LED will continue to flash.

TURN TOWARD THE REAR
OF THE VEHICLE

TURN THE KEY TO“ON”TO
DISARM THE SYSTEM
THE DRIVER
’S DOOR UNLOCKS
WHEN THE SYSTEM IS REMOTE DISARMEDTHE TAIL AND MARKER LIGHTS FLASH TWICE AND THE INTERIORLIGHTS TURN ON FOR30SECONDS WHEN THE SYSTEM IS
REMOTE DISARMED

PUSH THE UNLOCK BUTTON
STOPS
FLASHING
WHEN THE SYSTEM IS DISARMED
 THE BUZZER CHIRPS TWICE WHEN THE SYSTEM IS REMOTE DISARMED

TOYOTARS3200 remote keyless Security systemPage 19
REMOTE CONTROL BATTERY REPLACEMENT
The following shows the procedure to replace the batteries in your remot\
e controls. We recom-
mend that you replace the batteries at least once a year, or when the re\
mote control’s transmitting
range diminishes. You may obtain the replacement battery from your Toyot\
a dealer, as well as
many retailers that sell watch batteries. The battery replacement type is a Lithium CR2025.
Important notes on battery replacement:
When replacing the battery, be careful not to lose the components.
Take care not to bend or damage the rubber gasket.
REMOVE THE BATTERY
1. Lay the remote control on a towel or other soft material. Place it with the back side facing up.
2. Using a coin, pry open the remote control. Use gentle pressure to avoid deforming the plastic.
3. Set the back cover aside.
4. Remove the rubber gasket and set it aside.
5. Push the battery down and toward you, and hold it down.
6. Pry the back edge of the battery up and toward you.