TOYOTA PRIUS 2020 Owners Manual (in English)

Page 561 of 728

PRIUS_OM_OM47D44U_(U)
5616-3. Do-it-yourself maintenance
6
Maintenance and care
Turn the bulb base counterclockwise.4
Back-up lightRear turn signal light
Rear side maker light

Page 562 of 728

562
PRIUS_OM_OM47D44U_(U)
6-3. Do-it-yourself maintenance
Remove the light bulb.5
Back-up lightRear turn signal light
Rear side maker light

Page 563 of 728

PRIUS_OM_OM47D44U_(U)
5636-3. Do-it-yourself maintenance
6
Maintenance and care
Install a new light bulb then install the bulb base to the light unit
by inserting it and turning the bulb base clockwise.6
Back-up lightRear turn signal light
Rear side maker light

Page 564 of 728

564
PRIUS_OM_OM47D44U_(U)
6-3. Do-it-yourself maintenance
Align the grooves on the light
unit with the claws, and insert
the light unit straight so that
the 2 pins on the light unit fit
into the holes. Confirm that
the light unit is completely
secured.
Install the 2 screws.
Install the cover.7
8
9

Page 565 of 728

PRIUS_OM_OM47D44U_(U)
5656-3. Do-it-yourself maintenance
6
Maintenance and care
■Replacing the following bulbs
If any of the lights listed below has burnt out, have it replaced by
your Toyota dealer.
● Headlights and daytime running lights
● Parking lights (LED type: if equipped)
● Fog lights
● Front turn signal lights
● Tail lights
● Stop lights
● High mounted stoplight
● License plate lights
■LED lights
The lights other than the parking lights (bulb type: if equippe d), front side
marker lights, rear turn signal lights, rear side maker lights and back-up lights
each consist of a number of LEDs. If any of the LEDs burn out, take your
vehicle to your Toyota dealer to have the light replaced.
■ Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact your Toyota dealer for more information in the
following situations:
● Large drops of water have built up on the inside of the lens.
● Water has built up inside the light.
■ When replacing light bulbs
P. 553

Page 566 of 728

566
PRIUS_OM_OM47D44U_(U)
6-3. Do-it-yourself maintenance
WARNING
■Replacing light bulbs
● Be sure to stop the hybrid system and turn off the lights. Do not attempt to
replace the bulb immediately after turning off the lights.
The bulbs become very hot and may cause burns.
● Do not touch the glass portion of the light bulb with bare hand s. When it is
unavoidable to hold the glass portion, use and hold with a clea n dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
● Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headligh t unit. This
may damage the headlights or cause condensation to build up on the lens.
● Do not attempt to repair or disassemble light bulbs, connectors , electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
■ To prevent damage or fire
● Make sure bulbs are fully seated and locked.
● Check the wattage of the bulb before installing to prevent heat damage.

Page 567 of 728

567
PRIUS_OM_OM47D44U_(U)
7When trouble arises
7-1. Essential informationEmergency flashers .......... 568
If your vehicle has to be stopped in an
emergency ...................... 569
If the vehicle is trapped in rising water ..................... 570
7-2. Steps to take in an emergency
If your vehicle needs to be towed ......................... 572
If you think something is wrong .............................. 579
If a warning light turns on or a warning buzzer
sounds ............................ 580
If a warning message is displayed......................... 591
If you have a flat tire (vehicles without
spare tire)........................ 599
If you have a flat tire (vehicles with
spare tire)........................ 619
If the hybrid system will not start ........................... 633
If the electronic key does not operate properly ........ 635
If the 12-volt battery is discharged ...................... 638
If your vehicle overheats ... 644
If the vehicle becomes stuck ............................... 649

Page 568 of 728

568
PRIUS_OM_OM47D44U_(U)
7-1. Essential information
Emergency flashers
Press the switch.
All the turn signal lights will flash. To turn them off, press the switch once
again.
■ Emergency flashers
●If the emergency flashers are used for a long time while the hy brid system is
not operating (while the “READY” indicator is not illuminated), the 12-volt
battery may discharge.
● If any of the SRS airbags deploy (inflate) or in the event of a strong rear
impact, the emergency flashers will turn on automatically.
The emergency flashers will turn off automatically after operating for approx-
imately 20 minutes. To manually turn the emergency flashers off, press the
switch twice.
(The emergency flashers may not turn on automatically depending on the
force of the impact and conditions of the collision.)
The emergency flashers are used to warn other drivers when the
vehicle has to be stopped in the road due to a breakdown, etc.
Vehicles with 7-inch displayVehicles with 11.6-inch display

Page 569 of 728

569
PRIUS_OM_OM47D44U_(U)
7
When trouble arises
7-1. Essential information
If your vehicle has to be stopped in an
emergency
Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase th e effort
required to slow the vehicle.
Shift the shift position to N.
If the shift positi on is shifted to N
After slowing down, stop the vehi cle in a safe place by the road.
Stop the hybrid system.
If the shift position c annot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicl e
speed as much as possible.
To stop the hybrid system,
press and hold the power
switch for 2 consecutive sec-
onds or more, or press it briefly
3 times or more in succession.
Stop the vehicle in a s afe place by the road.
Only in an emergency, such as if it becomes impossible to stop
the vehicle in the normal way, st op the vehicle using the follow-
ing procedure:
1
2
3
4
3
Press and hold for 2 seconds or
more, or press briefly 3 times or
more
4
WARNING
■ If the hybrid system has to be turned off while driving
Power assist for the steering wheel will be lost, making the steering wheel
heavier to turn. Decelerate as m uch as possible before turning off the hybrid
system.
5

Page 570 of 728

570
PRIUS_OM_OM47D44U_(U)
7-1. Essential information
If the vehicle is trapped in rising water
●Remove the seat belt first.
● If the door can be opened, open the door and exit the vehicle.
● If the door can not be opened, open the window using the power
window switch and exit the vehicle through the window.
● If the window can not be opened using the power window switch,
remain calm, wait until the water level inside the vehicle rises to the
point that the water pressure inside of the vehicle equals the water
pressure outside of the vehicl e, and then open the door and exi t the
vehicle.
In the event the vehicle is submerged in water, remain calm and
perform the following.
WARNING
■ Using an emergency hammer*1 for emergency escape
The rear side windows and rear window of this vehicle can be shattered by
an emergency hammer
*1 used for emergency escape, however, since the
windshield and front side windows
*2 are laminated glass they can not be
shattered by an emergency hammer
*1.
*1: Contact your Toyota dealer or aftermarket accessory manufacturer for fur-
ther information about an emergency hammer.
*2: Vehicles with laminated glass
■ Escaping the vehicle from the window
There are cases where escaping the vehicle from the window is not possi-
ble due to seating position, passenger body type, etc.
When using an emergency hammer, consider your seat location and the
size of the window opening to ensure that the opening is accessible and
large enough to escape.

Page:   < prev 1-10 ... 521-530 531-540 541-550 551-560 561-570 571-580 581-590 591-600 601-610 ... 730 next >