key TOYOTA PRIUS V 2013 Accessories, Audio & Navigation (in English)

Page 11 T OYOTA — RS3200 PLUS Security System
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond en\
try point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to ad\
just the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
1.

ARM the system.

Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)

2.

W
ait until the STATUS MONITOR’S LED starts flashing. The
LED will flash 30 seconds after the last door, the trunk or
hatch is closed.
* for some vehicles the LED will turn off instead of flashing after the 30 seconds.



3.

With the tip of a key
, tap the center of the driver’s door
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Toyota dealer for
more information.
4.

DISARM the system to stop the W
ARN AWAY ALARM. Press
the unlock button

TOYOTA — RS3200 PLUS Security System Page 12
PROGRAMMING
The RS3200 PLUS is factory-set to not PASSIVELY ARM. To change the system’s
operation for PASSIVE ARMING operation, as well as adjust the ENTRY DELAY time,
follow the procedure below. For more information on this feature, please refer to page
7. (Not applicable to Highlander and Sienna. Please consult your Toyota Dealer for
programming information.)
PASSIVE ARMING ON/OFF SELECTION, ENTRY DELAY TIME SELECTION
1.

Before you begin:
Open the driver

’s door. Close the remaining
doors and the trunk or hatch. Unlock all doors
with the inside lock switch. Remove the key
from the
ignition
switch.
d. Lock , then unlock
the driver’s door
inside lock button
3 times.
f. The system locks the door
in 2 seconds; if this does not
happen, start over
.
Start the Programming Procedure. (Complete these steps within 40 seconds.)
b. Lock then unlock the
driver’s door inside lock
button 1 time.c. The system locks the door
in 2 seconds; if this does
not happen, start over.
Programming is now
complete.
3. Select the Operating Mode and Complete the Programming Procedure.
a. Close, then Open the driver ’s
door:
2 times = PASSIVE ARMING OFF
3 times = PASSIVE ARMING ON,
0 Sec. ENTR

Y DELAY
4 times = PASSIVE ARMING ON,
15 Sec. ENTR

Y DELAY
5 times = PASSIVE ARMING ON,
30 Sec. ENTR

Y DELAY
a. Close the
driver’s door. b.
Lock and unlock all doors
3 times by key or remote
control.c. Open and close
the driver ’s
door.
e.

Open the
driver

’s door.
g. Unlock the driver ’s
door knob.
2. Insert and remove the key from the igni-
tion key cylinder 3 times; this must be
completed within 5 seconds.