headrest TOYOTA SEQUOIA 2001 Service Owner's Guide

BO47L±04
H24392
Headrest
Headrest
Support
Seatback CoverSeatback Pad
Seatback Frame
Seat Cushion Cover
Seat Cushion Pad
Seat Cushion Frame
Rear No. 2 Seat Inner Belt
Seat AdjusterReclining Connecting Pipe
Reclining Adjuster
Release Handle Reclining Pedal Cover No. 2 Rear Seat
Reclining Cover No. 2 Seat Reclining
Adjuster
Hog Ring
Rear Seat Cushion
Under Cover
Seat Track Handle No. 2 Seat Leg Cover No. 2 Seat Leg Cover
Hog Ring No. 2 Rear Seat
Reclining Cover
N´m (kgf´cm, ft´lbf) : Specified torque

Non±reusable part
19 (195, 14)
43 (440, 32)
43 (440, 32)
43 (440, 32)
19 (195, 14)
42 (430, 31)
43 (440, 32)
Headrest
Support
Headrest
BO±156
± BODYREAR NO.2 SEAT
3709 Author: Date:
2005 SEQUOIA (RM1146U)
REAR NO.2 SEAT
COMPONENTS
HINT:
The procedures listed below are for the LH side.

BO47M±02
H16771
± BODYREAR NO.2 SEAT
BO±157
3710 Author: Date:
2005 SEQUOIA (RM1146U)
DISASSEMBLY
CAUTION:
Wear safety gloves, because the sharp edges and surfaces
of the seat frame may cause injury to the hands.
HINT:

The procedures listed below are for the LH side.

A bolt without a torque specification is shown in the stan-
dard bolt chart (see page SS±2).
1. REMOVE HEADRESTS
2. REMOVE RECLINING ADJUSTER RELEASE HANDLE
3. REMOVE RECLINING PEDAL COVER
4. REMOVE NO. 2 REAR SEAT RECLINING COVER
(a) Remove the screw.
(b) Remove the No. 2 rear seat reclining cover as shown in
the illustration.
(c) Employ the same manner described above to the other
side.
5. REMOVE SEATBACK ASSEMBLY
Remove the 4 bolts and seatback assembly.
Torque: 43 N´m (440 kgf´cm, 32 ft´lbf)
6. REMOVE SEATBACK COVER
(a) Remove the seatback cover with pad from the seatback
frame.
(b) Remove the seatback cover from the seatback pad.
7. REMOVE NO. 2 SEAT RECLINING ADJUSTER
Remove the 4 nuts, 2 No. 2 seat reclining adjusters and reclin-
ing connecting pipe.
8. REMOVE NO. 2 SEAT LEG COVERS
9. REMOVE RECLINING REMOVE CONTROL LEVER
10. REMOVE SEAT TRACK HANDLE
11. REMOVE REAR SEAT CUSHION UNDER COVER
12. REMOVE SEAT CUSHION ASSEMBLY
Remove the 4 screws and seat cushion assembly
Torque: 19 N´m (195 kgf´cm, 14 ft´lbf)
13. REMOVE SEAT CUSHION COVER
(a) Remove the rear No. 2 seat inner belt.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
(b) Remove the seat cushion cover with pad from the seat
cushion frame.
(c) Remove the seat cushion cover from the seat cushion
pad.