start stop button TOYOTA TACOMA 2016 Accessories, Audio & Navigation (in English)

TOYOTA — RS3200 PLUS Security System Page 8
ALARM INFORMATION
ALARM TRIGGERS
While the system is ARMED, an ALARM will be TRIGGERED when any of the following
occurs:
Forcibly opening a door, or the trunk or hatch without a key
Pulling the trunk release lever inside the vehicle will also
TRIGGER an ALARM.



Manually unlocking a door
Manually operating an inside lock button will TRIGGER an
ALARM.
Note: Because this action will TRIGGER an ALARM, it is important that you do not ARM the system while
someone is in the vehicle.
Pressing the Start Button
If the start button is pressed while the vehicle is ARMED, an
ALARM will be TRIGGERED.


“Hot wiring” the vehicle
The RS3200 PLUS can detect the absence of the ignition key if
the ignition circuit is shorted in attempt to start the vehicle.



Tapping on or breaking the glass
The noise from tapping on, or breaking of glass TRIGGERS a
WARN AWAY ALARM first, then a regular ALARM. See the de-
scription of how the GLASS BREAKAGE SENSOR TRIGGERS
ALARMS on page 9.

Power restoration
If power to the system is interrupted while it is ARMED, an
ALARM will be TRIGGERED immediately when power is
restored.
ENGINE
START STOP

Page 9 TOYOTA — RS3200 PLUS Security System
ALARM INFORMATION
ALARM DESCRIPTIONS
Regular ALARM
When an ALARM is triggered in any way other than initial detection by the GLASS \
BREAKAGE SENSOR, the following occur:
The horn sounds repeatedly for 60 seconds.
The headlights flash repeatedly for 60 seconds.
The tail and marker or turn signal lights flash repeatedly for 60 seconds.
The starter is disabled (no engine start) until the system is DISARMED\
.
The door lock will be relocked if someone reaches in and unlocks the ins\
ide
lock button.
After 60 seconds of ALARM, the system will REARM and continue to protect
the vehicle.
WARN-AWAY ALARM
Upon initial detection of noise from tapping on, or breaking glass, the GLASS BREAK-
AGE SENSOR TRIGGERS a WARN AWAY ALARM: The horn sounds repeatedly for 20 seconds.
The headlights flash repeatedly for 20 seconds.
The tail and marker or turn signal lights flash repeatedly for 20 seconds.
If the GLASS BREAKAGE SENSOR detects noise again, or if a door or trunk \
is
opened while the system is still ARMED, the regular ALARM (described above) is
activated.
STOPPING AN ALARM Simply DISARM the system using the remote control or key as described on\
page 6.
The horn
sounds for
20 seconds Tail or turn signal
lights flash for 20
seconds
123
Headlights flash for 20 secondsMarker or turn
signal lights flash for 20 seconds
The horn
sounds for 60 secondThe starter is
disabled until the
system is disarmed
Marker or turn
signal lights flash for 60 seconds Tail or turn
signal lights flash for 60 seconds
123
Head lights flash for 60 seconds
123
123

TOYOTA — RS3200 PLUS Security System Page 10
GLASS BREAKAGE SENSOR INFORMATION
The RS3200 PLUS provides protection for your vehicle above and beyond en\
try point
monitoring–it “listens” for the noise made by tapping on, or br\
eaking of glass. Using a
microphone designed specifically for this task, the GLASS BREAKAGE SENSOR is
capable of ignoring other noises, which helps to prevent “false alarm\
s” from occurring.
GLASS BREAKAGE SENSOR CHECK PROCEDURE
When the RS3200 PLUS was installed in your vehicle, care was taken to ad\
just the
sensitivity level of the GLASS BREAKAGE SENSOR. You may observe how it works
following the procedure listed below.
1. ARM the system.
Press the lock button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door, the trunk or
hatch is open.)

2. Wait until the STATUS MONITOR’S LED starts flashing.
The LED will flash 30 seconds after the last door, the trunk
or hatch is closed.
NOTE: For some vehicles the LED flashes during and after
the 30 seconds (pre-arming).



3. With the tip of a key, tap the center of the driver’s door
window. Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in cold weather, or you may crack or break it.
A WARN AWAY ALARM should be TRIGGERED. If the
ALARM is not TRIGGERED, make sure you performed the
procedure correctly and try again. If you find that the system
did not perform as expected, contact your Toyota dealer for
more information.
4. DISARM the system to stop the WARN AWAY ALARM.
Press the unlock button or use the key to DISARM the
system.