TOYOTA VENZA 2009 Owners Manual (in English)

491
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73004U)
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P. 571)
■ Turn the power back door main switch off. (vehicles with
power back door)
P. 6 1
■ Front bulb locations
Headlight low beam
Headlight
high beam
Front turn signal/parking light Front fog light Front side marker light

492 4-3. Do-it-yourself maintenance
VENZA_U (OM73004U)
Replacing light bulbs■ Headlight low beams (halogen bulb)
Turn the bulb base counterclock-
wise.
■Rear bulb locations
Stop/tail and rear side
marker lights
Back-up light Tail light
License plate light
Rear turn signal light
STEP1

493
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73004U)
Unplug the connector while
pushing the lock release.
■ Headlight high beams
Unplug the connector while
pushing the lock release.
Turn the bulb base counterclock-
wise.
STEP2
STEP1
STEP2

494 4-3. Do-it-yourself maintenance
VENZA_U (OM73004U)■
Front fog lights (if equipped)
Remove the engine under cover
bolt and pull down the engine
under cover.
Turn the bulb base counterclock-
wise.
Unplug the connector while
pushing the lock release.
STEP1
STEP2
STEP3

495
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73004U)
■
Front turn signal/parking lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2

496 4-3. Do-it-yourself maintenance
VENZA_U (OM73004U)■
Front side marker lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2

497
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73004U)
■
Rear turn signal lights, stop/ta il and rear side marker lights
Left side
Open the back door and remove
the cover.
To protect the cover, place a rag
between the flathead screwdriver
and cover as shown in the illus-
trations.
Right sideOpen the back door and remove
the cover.
To protect the cover, place a rag
between the flathead screwdriver
and cover as shown in the illus-
trations.
Turn the bulb base counterclock-
wise.
Stop/tail and rear side marker
lights
Rear turn signal light
STEP1
STEP1
STEP2

498 4-3. Do-it-yourself maintenance
VENZA_U (OM73004U)Remove the light bulb.
Stop/tail and rear side marker
lights
Rear turn signal light
■ Tail and back-up lights
Open the back door and remove
the trim board.
Turn the bulb base counterclock-
wise.
Back-up light
Tail light
Remove the light bulb. Back-up light
Tail light
STEP3
STEP1
STEP2
STEP3

499
4-3. Do-it-yourself maintenance
4
Maintenance and care
VENZA_U (OM73004U)
■
License plate light
Open the back door and remove
the trim board.
Turn the bulb base counterclock-
wise.
Remove the light bulb.
STEP1
STEP2
STEP3

500 4-3. Do-it-yourself maintenance
VENZA_U (OM73004U)■
Bulbs other than the above
If any of the bulbs listed below has burnt out, have your Toyota
dealer replace it.
● Headlight low beams (discharge bulb)
● High mounted stoplight
■Condensation build-up on the inside of the lens
Contact your Toyota dealer for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
● Large drops of water are built up on the inside of the lens.
● Water has built up inside the headlight.
■ LED light bulbs
The high mounted stoplight consists of a number of LEDs. If any LEDs burn
out, take your vehicle to your Toyota dealer to have the light replaced.
■ High-intensity discharge (HID) headlights (if equipped)
If voltage to the high-intensity discharge bulbs is insufficient, the light may
not come on, or may go out temporarily. The high-intensity discharge bulbs
will come on when normal power is restored.