reset TOYOTA YARIS HATCHBACK 2011 Owners Manual

4
OVERVIEW
Driver seat belt reminder\f
(alarm will sound if speed is over 1\f mph)
Front passenger seat belt reminder
\f
(alarm will sound if speed is over 1\f mph) Brake system warning
1,\f
1\ff indicator does not turn off within a few seconds of starting engine, there may
be a malfunction. Have vehicle inspected by your Toyota dealer.2For
\b2,
3For
Service indicator and reminder
Speedometer
Automatic Transmission shift position indicator (if equipped)
Odometer/Trip meter switch and trip meter reset button
Odometer and two trip meters
Fuel gauge
Clock
Clock reset button
Tachometer
Without tachometer
With tachometer
Charging system warning1,\f
For details, refer to “Indicators and warning lights,” Section \f\f, 2011
Owner’s Manual\b
11YarisLB.qxd:\b1\b\9\f37M2 \f/\b/10 6:0\b A\9M Page \b

14
FEATURES/OPERATIONS
Audio(ifequipped)
To scan tracks onadisc Push “SCAN\b” Pushagain tohold selection\b
Radio
Topreset stations Tuneinthe desired stationandhold down apreset
button (16)untilyouhear abeep\b Pushdesired presetbutton (16)to
select\b
To scan stations Push“SCAN\b” Pushandhold toscan preset stations\b Push
again tohold selection\b
CDplayer
Preset buttons functions inother
modes indicated abovenumber\b
ViewCDtext
Push toskip up
/down folder
Eject
CD
Push toturn
ON/OFF Push
toadjust
tone &balance
Mode
Seek
station/
CD track select
Station/CD
track scan
Byinserting amini plugofacommercially availablecomponent intothe
AUX port, youcanlisten tomusic fromaportable audiodevice through
the vehicle’s speakersystemwhileinAUX mode\b
AUX port (ifequipped)
Lu
Ope
Pow
Desig
posit
Do
Ope
Clock
Press andhold clock resetbutton foradjustment mode\bPressagain to
adjust minutes andhours, waiting 5seconds aftereach\b
Refer tothe Owner’s Manualforadjustment instructions\b
Clockresetbutton
Without tachometerWithtachometer
11YarisLB.qxd:\b1\b\9\f37M2 \f/\b/10 6:0\b AM Page 1\b

140
2-2. Instrument cluster
Gauges and meters
Vehicles with tachometer
The following gauges, meters and displays illuminate when the
engine switch is in the ON position. Tachometer
Displays the engine speed in revolutions per minute.
Speedometer
Displays the vehicle speed.
Fuel gauge
Displays the quantity of fuel remaining in the tank.
Clock
Indicates the time.
Clock reset button
Adjusts the time. ( →Π. 229 )

141
2-2. Instrument cluster
2
When driving
Odometer/trip meter
Odometer:
Displays the total distance the vehicle has been driven.
Trip meter:
Displays the distance the vehicle has been driven since the meter was
last reset. Trip meters A and B can be used to record and display differ-
ent distances independently.
Odometer/trip meter switching and trip meter resetting button
Switches between odometer and trip meter displays. Pushing and hold-
ing the button will reset the trip meter when the trip meter is being dis-
played.

142 2-2. Instrument cluster
Vehicles without tachometer
Speedometer
Displays the vehicle speed.
Fuel gauge
Displays the quantity of fuel remaining in the tank.
Odometer/trip meter switching and trip meter resetting button
Switches between odometer and trip meter displays. Pushing and hold-
ing the button will reset the trip meter when the trip meter is being dis-
played.
Odometer/trip meter
Odometer:
Displays the total distance the vehicle has been driven.
Trip meter:
Displays the distance the vehicle has been driven since the meter was
last reset. Trip meters A and B can be used to record and display differ-
ent distances independently.
Clock
Indicates the time.
Clock reset button
Adjusts the time. (→Π. 229)

143
2-2. Instrument cluster
2
When driving
Odometer and trip meter display button
Pressing this button switches between odometer and trip meter dis-
plays.
Vehicles with tachometer Odometer
Trip meter A
*
Trip meter B*
*:Pushing and holding the buttonwill reset the trip meter.

144 2-2. Instrument cluster
Vehicles without tachometerOdometer
Trip meter A*
Trip meter B*
*:Pushing and holding the buttonwill reset the trip meter.
Instrument panel light control
The brightness of the instrument panel lights can be adjusted.
Brighter
Darker
With the dial turned fully up, the
intensity of the instrument panel
lights will not be reduced even
when the tail lights/headlights are
turned on.

158 2-4. Using other driving systems
nCruise control can be set when
lThe shift lever is in D or 3 (vehicles with an automatic transmission).
l Vehicle speed is above approximately 25 mph (40 km/h).
n Accelerating
The vehicle can be accelerated normally. After acceleration, the set speed
resumes.
n Automatic cruise control cancellation
The set speed is automatically canceled in any of the following situations.
lActual vehicle speed falls more than approximately 10 mph (16 km/h)
below the preset vehicle speed.
At this time, the memorized set speed is not retained.
l Actual vehicle speed is below approximately 25 mph (40 km/h).
l VSC is activated.
n If the cruise control indicator flashes
Press the ON-OFF button to turn the cruise control off, and then reactivate
the system.
If the cruise control speed cannot be set or if the cruise control cancels
immediately after being activated, there may be a malfunction in the cruise
control system. Have the vehicle inspected by your Toyota dealer.

197
3-2. Using the audio system
3
Interior features
Using the radio
Setting station presets (excluding XM® Satellite Radio)
Search for desired stations by turning or pressing “
∧” or
“ ∨ ” on .
Press and hold the button (from
to ) that the sta-
tion is to be set to until you hear a beep.
Scanning radio stations (excluding XM® Satellite Radio)
n Scanning the preset radio stations
Press and hold until you hear a beep.
Preset stations will be played for 5 seconds each.
Vo lu m e
Station scan Station selector
Frequency seek Frequency adjust
(AM, FM mode) or
channel (SAT mode)
AM·SAT/FM mode buttonsPower
Text message display
(SAT mode)

198 3-2. Using the audio system
When the desired station is reached, press the button once
again.
n Scanning all radio stations within range
Press .
All stations with reception will be played for 5 seconds each.
When the desired station is reached, press the button once
again.
XM® Satellite Radio* (if equipped)
n Receiving XM
® Satellite Radio
Press and select the XM
® band.
The display changes as follows each time is
pressed.
AM → SAT1 → SAT2 → SAT3
Turn to select the desired channel in the all catego-
ries or press “
∧” or “∨ ” on to select the desired chan-
nel in the current category.
n Setting XM
® Satellite Radio channel presets
Select the desired channel. Press and hold the button (from
to ) that the channel is to be set to until you hear a beep.
n Changing the channel category
Press “
∧” or “ ∨” on the .
n Scanning XM
® Satellite Radio channels
l Scanning channels in the current category
Press .