light VOLKSWAGEN CC 2015 Owner´s Manual

Length 189 in – 193 in (4802 –
4902 mm)
Width 73 in (1855 mm)
Height (unloaded) 55.7 – 56.1 in (1417 –
1425 mm)
Wheelbase 106.6 in (2708 mm)
Minimum turning circle diameter
(wall to wall)2
37.4 ft (11.4 m)
Track2, front 61.1 – 61.3 in (1552 –
1556 mm)
Track2, rear 61.3 – 61.5 in (1557 –
1562 mm)
Ground clearance (unloaded) 4.9 in (124 mm)

NOTICE
Please be careful when parking your vehicle in areas with
parking barriers or curbs. These vary in height and could dam-
age your bumper and related parts if the front of your vehicle
hits a barrier or curb that is too high while you are getting into or
out of a parking spot.
Always be careful when you enter a driveway or drive up or
down steep ramps or over curbs or other obstacles. Parts of the
vehicle close to the ground may be damaged (such as bumper
covers, spoilers, and parts of the engine, suspension, and ex-
haust systems).

2 Slight differences to these figures are possible, depending on wheel and tire size fitted and the level selected.

Locking and unlocking the luggage compartment pass-through ⇒ 
Seat functions.
Locking and unlocking the luggage compartment lid using the key
switch in the driver door ⇒ Driver door overview
Manually locking and unlocking the vehicle ⇒Emergency closing
and opening.
Reinserting the emergency key
Insert the emergency key (3) into the opening in the remote control
vehicle key.
Slide the emergency key in the direction opposite to the arrow until it
locks into place.
Indicator light in the remote control vehicle key

Fig. 22 Indicator light in the remote control vehicle key.

WARNING
Improper use of power windows can result in serious personal
injury.
Never let anyone get in the way of a power window when
closing it.
When locking the vehicle from the outside, make sure that no
one, especially children, remains in the vehicle. The windows
will not open in case of an emergency.
Always take the key with you when you leave the vehicle. You
can still use the power windows for several minutes after the
ignition is switched off as long as the driver or front passenger
door has not been opened.
Always use the safety switch when children are in the back
seat to disable the rear power windows and keep them from be-
ing opened and closed.
NOTICE
The windows must go down slightly when you unlock the vehi-
cle. Otherwise the windows and seals could be damaged when
opening the doors.
If the power windows malfunction, the one-touch feature, as well
as pinch protection may not work properly. See an authorized
Volkswagen dealer or authorized Volkswagen Service Facility right
away.
Power window pinch protection

The buttons 1 , 2 , and 3 on the keypad in the sun visor can operate
up to 3 separate devices (for example, a gate and garage door,
house alarm or lighting system).

Please carry out each step only in the order specified:
1. For first time programming only: Press and hold the two
outer HomeLink buttons 1 and 3 at the same time for about 20
seconds, releasing only when the HomeLink indicator light
above button 2 begins to flash.
This step deletes any old settings. Do not perform this step
when programming the additional HomeLink buttons.
2. Position the hand-held transmitter for your remote control de-
vice 1-3 inches (25-75 mm) away from the HomeLink keypad
on the driver side sun visor, keeping the HomeLink indicator
light in view, as shown ⇒ fig. 41.
3. Using both hands, simultaneously press and hold both the
HomeLink button you want to program ( 1 , 2 , or 3 ) and the
hand-held transmitter button, as shown ⇒ fig. 42. Do not re-
lease the buttons until the HomeLink indicator light flash-
es slowly and then rapidly. When the indicator light flashes
rapidly, release both buttons. The rapid flashing indicates suc-
cessful programming.
4.
Press and hold the programmed HomeLink button and watch
the indicator light.
If the indicator light comes on and does not flash, programming
is complete and your garage door opener or other device
should activate when the HomeLink button is pressed and re-
leased.
If the indicator light blinks rapidly for 2 seconds and then stays
on, proceed with the following programming instructions for a
rolling code device. A second person may make the following
steps quicker and easier. Please use a ladder or other device.
Do not stand on your vehicle to perform the next steps ⇒  in
Operating the HomeLink® Universal Transmitter

Please carry out each step only in the order specified:
5.
At the garage door opener receiver (overhead unit) in the gar-
age, locate the “learn” or “training” button. The name and color
of the button may vary by manufacturer. This button is usually
located near the hanging antenna wire attachment point on the
unit. If you cannot locate the “training” button, refer to the gar-
age door opener’s user manual.
6. Press and release the “training” button.
Once the button is pressed, you have 30 seconds to initi-
ate the next step.
7. Return to the vehicle. Firmly press and hold the programmed
HomeLink button for 2 seconds and release.
8. Repeat the “press/hold/release” sequence up to 3 times to
complete the programming process for that button.

Repeat the steps to program the other buttons for the HomeLink®
Universal Transmitter on the sun visor keypad to control other devic-
es.
Deleting programming for all buttons
Be sure to delete programming on all buttons on the sun visor keypad
before selling the vehicle or turning it over to people you do not know.
Complete the programming preparation steps described above.
Press and hold buttons 1 and 3 at the same time, for about 20
seconds.
When the indicator light above button 2 begins to flash, immediate-
ly release buttons 1 and 3 . This step deletes all old settings.
After programming
Test the garage door opener
Operating the HomeLink® Universal Transmitter

WARNING
Always adjust seat, safety belts, and head restraints properly
before driving and make sure that all passengers are properly
restrained.
Push the passenger seat as far back as possible. Always be
sure that there are at least 10 inches (25 cm) between the front
passenger's breastbone and the instrument panel.
Always adjust the driver's seat and the steering wheel so that
there are at least 10 inches (25 cm) between your breastbone
and the steering wheel.
Adjust the driver's seat so that you can easily push the ped-
als all the way to the floor while keeping your knee(s) slightly
bent. The distance to the instrument panel in the knee area
must be at least 4 inches (10 cm).
If these requirements cannot be met for physical reasons,
contact an authorized Volkswagen dealer or an authorized
Volkswagen Service Facility to see whether adaptive equipment
is available.
Always hold the steering wheel on the outside of the steering
wheel rim with your hands at the 9 o'clock and 3 o'clock posi-
tions to help reduce the risk of personal injury if the driver's
airbag inflates.
Never hold the steering wheel at the 12 o'clock position or
with your hands at other places inside the steering wheel rim or
on the steering wheel hub. Holding the steering wheel the
wrong way can cause serious injuries to the hands, arms, and
head if the driver's airbag inflates.
Pointing the steering wheel toward your face decreases the
ability of the driver's airbag to help protect you in a collision.
Never drive with backrests reclined or tilted back farther than
necessary to drive comfortably. The farther back the backrests
are tilted, the greater the risk of injury caused by incorrect posi-
tioning of the safety belts and improper seating position.
Never drive with the front seat passenger backrest tilted for-
ward. If the front airbag deploys, the front backrest can be
forced backward and injure passengers on the rear seat.
Sit as far back as possible from the steering wheel and the
instrument panel.

Always sit upright with your back against the backrest with
the front seats properly adjusted. Never lean against or place
any part of your body too close to the area where the airbags
are located.
Rear seat passengers who are not properly seated and re-
strained are more likely to be seriously injured in a crash.
WARNING
Improper adjustment of the seats can cause accidents and se-
vere injuries.
Never adjust the seats while the vehicle is moving. Your seat
may move unexpectedly and you could lose control of the vehi-
cle. In addition, you will not be in the correct seating position
while adjusting the seats.
Adjust the front seat height, angle and longitudinal direction
only if the seat adjustment area is clear.
The adjustment of the front seats must not be restricted by
things in the footwell in front or behind the seats.
WARNING
Some kinds of cigarette lighters can be lit unintentionally, or
crushed causing a fire that can result in serious burns and ve-
hicle damage.
Always make sure that there are no lighters in the seat tracks
or near other moving parts before adjusting the seats.
Before closing a storage compartment, always make sure
that no cigarette lighter can be activated, crushed, or otherwise
damaged.
Never leave a cigarette lighter in a storage compartment, on
the instrument panel, or in other places in the vehicle. Heat
buildup in the passenger and luggage compartment of a parked
vehicle can result in temperatures in the vehicle that are much
higher than the outside temperatures, particularly in summer.
High temperatures could cause the cigarette lighter to catch
fire.

Never hold the steering wheel at the 12 o'clock position or with your
hands at other places inside the steering wheel rim or on the steering
wheel hub. Holding the steering wheel the wrong way can cause seri-
ous injuries to the hands, arms, and head if the driver's airbag in-
flates.
Adjust the steering wheel so that the steering wheel cover points at
your chest and not at your face. Pointing the steering wheel toward
your face decreases the ability of the driver's airbag to help protect
you in a collision.
Adjust the driver's seat so that you can easily push the pedals all
the way to the floor while keeping your knee(s) slightly bent.
Adjust the seat height so that the top point of the steering wheel
can be reached.
Always keep both feet in the footwell so that you are in control of
the vehicle at all times.
Passenger - front seat adjustment:
Push the passenger seat as far back as possible in order to ensure
optimum protection if the airbag is deployed.
Manual controls on the driver and front passenger seats

Fig. 45 Controls on the left front seat.

Push the button (1) again to turn seat ventilation off. The indicator
light in the front seat (3) goes out.
Seat heating must be switched on again if needed each time the igni-
tion is switched on.
Setting the ventilation level
Move the fan switch (2) all the way down toward the – symbol to
set the ventilation level to low.
Move the fan switch (2) to the middle position to set the ventilation
level to medium.
Move the fan switch (2) all the way up toward the + symbol to set
the ventilation level to high.
If the indicator light in the front seat (3) flashes, there is a malfunction
in the system. Have the system inspected by your authorized
Volkswagen dealer or authorized Volkswagen Service Facility.
You may hear the sound of the seat ventilation when the feature
is switched on. The sound is part of normal operation and not a cause
for concern.
Memory seats

Fig. 57 On the outer side of the driver and front passenger seats:
Memory buttons.

Warning light

Fig. 59 Warning light in the instrument cluster.