lights VOLKSWAGEN ID.4 2020 Owner´s Manual

Limits of Front Assist
Please refer to at the start of the chap-
ter on page 159.
F
ront Assist is not available or its
functions are restricted immediately
after the vehicle is started. The indi-
cator lamp lights up in the instrument
cluster display during this time.
Front Assist has physical and system-related
limitations. You should therefore always be
prepared to take full control of the vehicle if
necessary.
Delayed response
If the camera or radar sensor is exposed to
environmental conditions that impair func-
tioning, the system may detect this only after
a certain delay. For this reason, any restric-
tions to functions may be displayed only after
a delay at the start of the journey and when
driving

Troubleshooting
Please refer to at the start of the chap-
ter on page 159. Front Assist is starting up.
The indicator lamp lights up.

Emergency Assist not available
The indicator lamp lights up yellow. A mes-
sage will also appear on the instrument clus-
ter display.

wise cause accidents or injuries. The sys-
tem is not a substitute f
or the full concen-
tration of the driver.
x Adapt your speed and distance from the
vehicles ahead to suit visibility, weather,
road and traffic conditions.
x Your hands should always be on the
steering wheel so that you can steer at
any time.
x Observe the displays in the exterior mir-
ror housings and on the instrument clus-
ter display and act in accordance with
the requests.
x Always pay attention to what is happen-
ing around the vehicle.
x Never use the lane change system if the
radar sensors are dirty, covered or dam-
aged. These circumstances can impair
the proper functioning of the system.
x It may be hard to see the display in the
wing mirror in direct sunlight. The radar sensors calibrate themselves
once in the first f
ew kilometres after
vehicle delivery and if the sensors are re-
paired. The sensor range may be limited dur-
ing the calibration phase. Driving with the lane change
system
Please refer to at the start of the chap-
ter on page 172. Fig. 113
In the e
xterior mirror housing: visual
displays of the lane change system.
Switching on and off
You can switch the lane change system on
and off in the Assist systems menu of the In-
fotainment system. When the lane change
system is switched on, the yellow indicator
lamp in the exterior mirror housing lights
up once briefly.
This most recent system setting is retained
e

ven after the ignition has been switched off
and on.
Function
When switched on, the lane change system is
active from a speed of around 15 km/h
(9 mph). The lane change system is deactiva-
ted at a vehicle speed below 10 km/h
(6 mph).
In the following driving situations, the yellow
indicator lamp lights up in the housing of
the respectiv

e exterior mirror:

The yellow indicator lamp flashes if a pos-
sible critical situation is detected when you
indicate in the direction of the detected v
ehi-
cle.
The faster another vehicle approaches, the
earlier there is a corresponding display in the
exterior mirror.
Lane change system “Side Assist Plus”
If the vehicle is equipped with a lane keeping
system (Lane Assist) and the system is
switched on, the driver is warned by a correc-
tive steering intervention when changing
lanes during a possible critical situation (in-
formation level, warning level). The steering
intervention also occurs when the turn signal
is activated for the corresponding direction. If
the steering intervention is overridden by the
driver, the steering wheel vibrates to give an
additional warning. For this, steering wheel
vibration must be activated in the Assist sys-
tems menu in the Infotainment system.
Automatic deactivation
The lane change system will switch off auto-
matically if the radar sensors are permanent-
ly covered. This can be caused by a layer of
ice or snow in front of the radar sensor, for
example.
A text message will be shown on the instru-
ment cluster display.
If you use the factory-fitted trailer towing
coupling and have set up the necessary elec-
trical connection, the lane change system
switches off automatically. After you have
disconnected the electrical connection, the
lane change system is switched back on au-
tomatically.
If the trailer towing coupling is not factory-
fitted, you must manually switch off the lane
change system and then switch it back on
again.
Brightness
The brightness of the visual display will
change automatically depending on the am-
bient light levels. You can adjust the basic brightness of the
display in the Assist systems menu in the In-
f
otainment system. The lane change system
is not active during the setting procedure. Troubleshooting
Please refer to at the start of the chap-
ter on page 172. Lane change system fault.
The indicator lamp lights up yellow. The yel-
low central warning lamp also lights up.

Parking and manoeu-
vring
P
arking
Parking the vehicle WARNING
If the vehicle is not parked properly it can
roll away e
ven on a slight gradient. This can
cause accidents and serious injuries.
x When parking, observe the specified or-
der.
x Before leaving the vehicle, make sure
that the electronic parking brake is
switched on and that the indicator
lamp next to the driving mode selec-
tor lights up red. 1. Depress and hold the brake pedal.
2.

Switch on the electronic parking brake

ESC or TCS is performing control inter-
v
ention
Indicator lamp flashes yellow. TCS switched off manually
Indicator lamp lights up yellow. ESP Sport switched on
Indicator lamp lights up yellow. ESC fault
Indicator lamp lights up yellow. ESC has been
switched off

.
There is a fault or a malfunction.

Only use towing brackets which have
been appro
ved by Volkswagen for your
vehicle type. Troubleshooting
Please refer to , and at the start
of the chapter on page 264. Ball head of the towing bracket is not
locked
The indicator lamp lights up yellow.

There is a fault in range calculation. Go to
a qualified workshop.
Charging not possible or aborted
The charging process display on the charging
socket lights up red.
Bef
ore you visit a qualified workshop, you
can perform the following troubleshooting
measures:

x
Do not use fuel, nail v arnish remover, paint
thinner or similar products to clean the
windows. Wax deposits on the windscreen and
rear window could cause the wiper
blades to rub. Remo

ve wax residue using
a special cleaning product or cleaning cloths. Exterior lighting
Introduction to the topic
Bef

ore changing a bulb, check whether a bulb
or LED light unit has failed. You can normally
change bulbs yourself. If the exterior lighting
is realised using LED technology, depending
on model and vehicle equipment, it is not
possible for you to change the LED light units
or individual LEDs yourself. If individual LEDs
fail, this may be an indication that more LEDs
are on the point of failure. In this case, have
the LED light units checked and renewed if
necessary at a qualified workshop.
It may be illegal to drive with faulty exterior
lights.
Additional bulb specifications
Some bulbs might have factory specifications
that differ from standard bulbs. The designa-
tion is inscribed on the bulb, either on the
glass part or on the base. WARNING
Changing bulbs incorrectly can cause acci-
dents and serious injuries.
x When working in the bonnet space, al-
ways read and observ

e the safety warn-
ings