fuse diagram VOLKSWAGEN JETTA 1998 Service Manual

Downloaded from www.Manualslib.com manuals search engine 01-22



Test requirements

The tires installed to all wheels must be of
the same (approved) size; tires inflated to
prescribed pressure.

Mechanical/hydraulic parts of the brake
system including brake light switch and
brake lights OK.

Hydraulic lines and connections not leaking
(visual check of hydraulic unit, brake
calipers, wheel cylinders, tandem master
brake cylinder).

Wheel bearings and wheel bearing play
OK.

ABS control module (w/EDL) -J104- is
correctly bolted to hydraulic unit -N55-.

Connector on ABS control module (w/EDL)
-J104- correctly plugged-in (retainer is
engaged).

Check contacts of ABS components for
damage and correct seating.

All fuses OK according to wiring diagram
(remove fuse from fuse holder to check).

Supply voltage OK (at least 10.0 V).
Стр. 2из 81 ABS ITT Mk 20 IE On Board Diagnostic (OBD) program

Downloaded from www.Manualslib.com manuals search engine 01-127


Continuation of test step 19
Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for deviations
from specification
19

Set to
measuring
range 20 M

- Remove fuse S9

- Check wiring for
short circuit to
positive or earth




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 26из 31 ABS, ABS/EDL and ABS/EDL/ASR ITT Mark 20 IE, electrical check

Downloaded from www.Manualslib.com manuals search engine 01-129


Continuation of test step 20
Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for deviations
from specification


Set to
measuring
range 20 M

- Remove fuse S9

- Check wiring for
short circuit to
positive or Ground




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 28из 31 ABS, ABS/EDL and ABS/EDL/ASR ITT Mark 20 IE, electrical check

Downloaded from www.Manualslib.com manuals search engine 01-159


On Board Diagnostic (OBD),
performing
Test prerequisites for OBD

The tires installed to all wheels must be of
the same (approved) size; tires inflated to
prescribed pressure.

Mechanical/hydraulic parts of the brake
system including brake light switch and
brake lights OK.

Hydraulic lines and connections not leaking
(visual check of hydraulic unit, brake
calipers, wheel cylinders, tandem master
brake cylinder).

ABS Control Module (w/EDL) -J104- is
correctly bolted to ABS Hydraulic Unit -
N55-.

Connector on ABS Control Module (w/EDL)
-J104- correctly plugged-in (retainer is
engaged).

Check contacts of ABS components for
damage and correct seating.

All fuses according to wiring diagram OK
(remove fuse from fuse holder to check).

Supply voltage OK (at least 10.0 V).
Стр. 1из 129 On Board Diagnostic (OBD), performing

Downloaded from www.Manualslib.com manuals search engine 01-215


V.A.G 1551 print-out
Possible cause
Repair
01276
ABS hydraulic pump -
V64-
Electrical malfunction in
current circuit
1)
Battery positive fuse faulty- Check fuses


Open circuit, short to positive
or ground in the wiring - Check wiring and
connections using wiring
diagram
- Perform electrical check
Page 01
-288

Hydraulic pump -V64- faulty
Repair Manual, Brake
System, Repair Group 45
Replace ABS hydraulic unit
-N55-
1) This DTC is only recognized above 20 km/h (13 mph) (carry out test drive).
Стр. 57из 129 On Board Diagnostic (OBD), performing

Downloaded from www.Manualslib.com manuals search engine 01-290



Test prerequisites

Switch ignition and electrical
consumers off before commencing the
check (headlights, lighting, fans ...).

Fuses must be OK (remove fuses from
fuse holder to check).
Electrical Wiring Diagrams,
Troubleshooting & Component
Locationsbinder

- Pull fuse holder out of cable channel.
- Release ABS Control Module (w/EDL) -
J104- connector -arrow 1- and pull off -
arrow 2-.
Стр. 3из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-316


Continuation of test step 17a
Test
step V.A.G
1598
sockets Item
tested
Test
conditions
- Additional
operations Specification
Measures for
deviations from
specification
17a Wiring for
steering
angle
sensor -
G85- - Set measuring
range to 20 M
- Remove fuse S9

- Check wiring for
short circuit to
positive or
Ground




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 29из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-318


Continuation of test step 18
Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for deviations
from specification

- Set measuring
range to 20 M
- Remove fuse S9

- Check wiring for
short circuit to
positive or Ground




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 31из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-320


Continuation of test step 19
Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for deviations
from specification

- Set measuring
range to 20 M
- Remove fuse S9

- Check wiring for
short circuit to
positive or Ground




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 33из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-322


Continuation of test step 20

Test
step V.A.G
1598
sockets Item
tested
Test conditions
- Additional
operations Specification
Measures for deviations
from specification

- Set measuring
range to 20 M
- Remove fuse S9

- Check wiring for
short circuit to
positive or Ground




Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder - Check wiring using
wiring diagram
Стр. 35из 38 Electrical check of Mark 60