bulb VOLKSWAGEN UP! 2021 Owner´s Manual

Changing bulbs in the side turn signals
Fig. 169 Removing the side turn signal bulb
Fig. 170 Side turn signal: changing the bulb
First read and observe the introductoryinformation and safety warnings⇒
Introduction
The actions should only be carried out in the specified order:
1.Observe and follow the instructions on the checklist ⇒ Information on changing bulbs.
2.With one hand, push the side turn signal to the front ⇒ Fig. 169â‘ .
3.Manually lever the side turn signal out of the vehicle body â‘¡.
4.Pull the bulb and bulb holder out in the direction of the arrow ⇒ Fig. 170â‘ .
5.Pull the bulb straight out of the bulb holder.
6.Replace the defective bulb with a new bulb of the same type.
7.Replace the bulb holder.
8.Insert the side turn signal into the body, with the side facing the rear of the vehicle first.
Push it in until the spring on the other side of the side turn signal engages.
Starting the engine with jump leads
 Introduction
This chapter contains information on the followingsubjects:
⇒ How to start the engine using jump leads
If the engine fails to start because the vehicle battery is flat, the flat battery can be connected to the
battery of another vehicle to start the engine. Before using jump leads, check the window on the
vehicle battery ⇒ Vehicle battery.
Jump leads must comply with DIN 72553 (see manufacturer's documentation). On petrol engine
vehicles, the conductor must have a cross-section of at least 25 mm.
Additional information and warnings:
•Pull-away assist systems ⇒ Pull-away assist systems
•Preparation for working in the engine compartment ⇒ Preparation for working in the engine
compartment
•Battery ⇒ Vehicle battery
Before inserting the screwdriver, slide a piece of paper (or similar) in between the screwdriver
and the bumper in order to prevent any damage to the paintwork on the bumper.
NOTICE
2