odometer YAMAHA TZR50 2012 Owners Manual

EAU11446
Coolant temperature warning light
“”
This warning light comes on if the
engine overheats. If this occurs, stop
the engine immediately and allow the
engine to cool.
The electrical circuit of the warning
light can be checked by turning the
key to “ ”. The warning light should
come on for a few seconds, and then
go off.
If the warning light does not come
on initially when the key is turned to
“ ”, or if the warning light remains
on, have a Yamaha dealer check the
electrical circuit.
ECA10021
Do not continue to operate the
engine if it is overheating.
TIP
For radiator-fan-equipped vehi-
cles, the radiator fan(s) automati-
cally switch on or off according to
the coolant temperature in the
radiator.
If the engine overheats, see page
6-39 for further instructions.
EAUS1540
Engine trouble warning light “ ”
This warning light flashes if a problem
is detected in the electrical circuit
monitoring the engine. If this occurs,
have a Yamaha dealer check the self-
diagnosis system.
The electrical circuit of the warning
light can be checked by turning the
key to “ ”. If the warning light does
not come on for a few seconds, then
go off, have a Yamaha dealer check
the electrical circuit.
EAU11621
Speedometer unit
1. Speedometer
2. Odometer
UK ONLY
1. Speedometer
2. Odometer
NOTICE
INSTRUMENT AND CONTROL FUNCTIONS
3-3
3
1HD-F819D-E0 7/3/11 20:27 Página 18
2AS-F819D-E0.indd 1831/07/12 10:09

The speedometer unit is equipped
with a speedometer and an odometer.
The speedometer shows riding spe-
ed. The odometer shows the total dis-
tance traveled.EAU11851
Tachometer
1. Tachometer
2. Tachometer red zone
The electric tachometer allows the
rider to monitor the engine speed and
keep it within the ideal power range.
ECA10031
Do not operate the engine in the
tachometer red zone.
Red zone: 10000 r/min and above
EAU12348
Handlebar switches
Left
1. Pass switch “PASS”
2. Dimmer switch “ / ”
3. Turn signal switch “ / ”
4. Horn switch “ ”
Right
1. Start switch “ ”
2. Engine stop switch “ / ”
NOTICE
INSTRUMENT AND CONTROL FUNCTIONS
3-4
3
1HD-F8199-E0 13/5/11 07:11 Página 19
2AS-F819D-E0.indd 1931/07/12 10:09

EAU46871
TIP
The annual checks must be performed every year, except if a kilometer-based maintenance, or for the UK,
a mileage-based maintenance, is performed instead.
From 30000 km (17500 mi), repeat the maintenance intervals starting from 6000 km (3500 mi).
Items marked with an asterisk should be performed by a Yamaha dealer as they require special tools, data and
technical skills.
EAU46920
Periodic maintenance chart for the emission control system
PERIODIC MAINTENANCE AND ADJUSTMENT
6-3
6
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
1* Fuel line • Check fuel hoses for cracks
or damage. √ √√ √ √
2
Spark plug • Replace. √ √√ √ √
3* Carburetor • Check starter (choke) operation.
• Adjust engine idling speed. √√ √ √ √ √
• Check the air cut-off valve, reed
4* Air induction system valve, and hose for damage.
√ √√ √ √
• Replace any damaged parts
if necessary.
1HD-F819D-E0 7/3/11 20:27 Página 40
2AS-F819D-E0.indd 4031/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-4
6
EAU17717
General maintenance and lubrication chart
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
1*
Air filter element • Clean.
√√• Replace. √√
2 Clutch • Check operation.
• Adjust. √√ √ √ √
• Check operation, fluid level and
3* Front brake vehicle for fluid leakage. √√ √ √ √ √
• Replace brake pads.
Whenever worn to the limit
• Check operation, fluid level and
4* Rear brake vehicle for fluid leakage. √√ √ √ √ √
• Replace brake pads.
Whenever worn to the limit
• Check for cracks or damage.
5* Brake hose • Check for correct routing and
√ √√ √ √
clamping.
• Replace. Every 4 years
6*Wheels • Check runout and for damage. √ √√ √
• Check tread depth and for damage.
7* Tires • Replace if necessary. √ √√ √ √
• Check air pressure.
• Correct if necessary.
8* Wheel bearings • Check bearing for looseness or
damage. √ √√ √
1HD-F819D-E0 7/3/11 20:27 Página 41
2AS-F819D-E0.indd 4131/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-5
6
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
• Check operation and for
9* Swingarm excessive play. √ √√ √
• Lubricate with lithium-soap-
based grease. Every 24000 km (14000 mi)
• Check chain slack, alignment and condition. Every 500 km (300 mi) and after washing
10 Drive chain • Adjust and lubricate chain with
the motorcycle, riding in the rain or riding in wet areas
a special O-ring chain lubricant
thoroughly.
• Check bearing play and steering
11 * Steering bearings for roughness. √√ √ √ √
• Lubricate with lithium-soap-
based grease. Every 50000 km (30000 mi)
12 * Chassis fasteners • Make sure that all nuts, bolts and
screws are properly tightened. √ √√ √ √
13 Brake lever pivot
shaft • Lubricate with silicone grease.
√ √√ √ √
14 Brake pedal pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
15 Clutch lever pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
16 Shift pedal pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
• Check operation.
17 Sidestand • Lubricate with lithium-soap- √ √√ √ √
based grease.
18 * Sidestand switch • Check operation. √√ √ √ √ √
1HD-F819D-E0 7/3/11 20:27 Página 42
2AS-F819D-E0.indd 4231/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-6
6
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
19 * Front fork • Check operation and for oil
leakage. √ √√ √
Rear suspension
• Check operation.
√ √√ √
20 * relay arm and
• Lubricate with lithium-soap-
connecting arm
pivoting points based grease.
√√
21 * Autolube pump • Check operation.
• Bleed if necessary. √
√ √√
22Transmission oil • Check oil level.
√√ √ √ √ √• Change.√√ √
23 * Front and rear brake
switches • Check operation.
√√ √ √ √ √
24 Moving parts and
cables • Lubricate.
√ √√ √ √
• Check operation.
25 * Throttle grip • Check throttle grip free play, and
√ √√ √ √
adjust if necessary.
• Lubricate cable and grip housing.
26 * Lights, signals and
• Check operation.
switches • Adjust headlight beam. √√ √ √ √ √
1HD-F819D-E0 7/3/11 20:27 Página 43
2AS-F819D-E0.indd 4331/07/12 10:09