service YAMAHA YD110 2007 Repair Manual

Page 147 of 158

SERVICE RECORD
11
16500-17000
18500-19000
20500-21000
S.
NO.SERVICED AT
KMS / ONDATESERVICING DLR'S
NAME & ADDRESS JOB DETAILS/
CARD NO VALIDITY*
KMS DATE9
10
22500-23000
24500-25000
26500-27000
S.
NO.SERVICED AT
KMS / ON DATESERVICING DLR'S
NAME & ADDRESS JOB DETAILS/
CARD NO VALIDITY*
KMS DATE12
1314
28500-29000
BONUS FREE
SERVICE RECORDPAID SERVICE RECORD
*Service to be availed within specified kms from date of Purchase or 60 days after
previous service.15
10-41
SERVICE2.pmd10/15/2006, 8:54 AM 11

Page 148 of 158

SERVICE RECORD
10-42
(i) Cost of Oil for the Free Services will be Chargeable at actuals and to be borne by
the Customer.
(ii)Please ensure that the Servicing Dealer Column is duly Stamped & signed by the
Servicing Dealer.
(iii)For the validity of "Warranty" benefits, It is mandatory that all Services, Bonus
Free Services and Paid Services are availed by the customer as per the
recommended Schedule, as given in the Owner's Manual.
(iv)Please ensure that each service is availed within 60 days from date of previous
service or as per the recomended service schedule whichever is earlier.
I
M
P
O
R
T
A
N
T
SERVICE2.pmd10/15/2006, 8:54 AM 12

Page 152 of 158

3.6 KEEP OUR ENVIRONMENT CLEAN.
Please follow simple steps
DO’S ()

1Always use genuine ‘spare parts’ purchased from YMIS Authorised Dealers.

2Always use only genuine oils
• 4T - 20W/40 SG grade - YAMALUBE 4T

3 Always keep your engine well turned. Save environment and also improve Fuel Efficiency

4 • ALWAYS GET YOUR MOTORCYCLE REPAIRED AND MAINTAINED ONLY AT YMIS AUTHORISED
DEALER.
• YMIS serves you through a wide network of Authorised Dealers.

5.Check the Following at every scheduled service:-
a) Spark Plug : Check/Reset Gap/Replace as per the recommendations
in this Owner’s Manual (page no 6-7)
b) Carburetor :Cleaning/Adjustment Every 4500 kmsc) Air Filter : Clean every 2000 kms as per the environment conditions.
d) Piston/Rings/Cylinder : Check / Clean / Replace if necessary
e) Exhaust System : Check / Replace if necessary
f) Valve Timing : Check / Adjust every 4500 kms
g) Compression pressure : Check / Diagnose.
DO’S AND DON’TS FOR THE MOTORCYCLE
2
greenbook.pmd10/15/2006, 8:51 AM 4

Page 154 of 158

4. PROCEDURE FOR MEASUREMENT OF “CO” EMISSION LEVEL
4.1IMPORTANT : “CO” Measurement Equipment must be duty calibrated.
4.2 Check for “NO LEAKAGE” from Exhaust System.
4.3 Starter Lever should be in OFF position.
4.4 All Electricals should be in OFF position.
4.5 Set the Idle speed of the Engine in warmed up condition of Motorcycle as specified.
4.6 Insert the Sampling probe of the Exhaust Gas Analyser inside the Exhaust Muffler of the
Motorcycle.
4.7 • If the reading is within specified limits then it is acceptable.
• If the reading exceeds the norm of 3.5% (by volume) have it adjusted by YMI Authorised
Dealer.
4.8 YMI serve you through an extensive network of
• Authorised Dealers
• Authorised Service Points.
• Trained Private Workshop (Garage) Owner’s.‘CO’ EMISSION LEVEL MEASUREMENT
4
MODELIDLE R.P.M.
1300 - 1500 RPM
CRUX
greenbook.pmd10/15/2006, 8:51 AM 6

Page 156 of 158

Customer Name : Date of Purchase :
Address : Vehicle Reg. No. :
Selling Dealer :SL.
No.Date KM
ReadingJob Card
No.Service
(Free/Paid)Parts Replaced Oil Fill Qty.
4T, Gear BoxCO Level
Date/Value)Serv. DealerLOG SHEET (To be Filled in by Owner/User)
6
greenbook.pmd10/15/2006, 8:51 AM 8

Page:   < prev 1-10 ... 21-30 31-40 41-50 51-60 61-70