seats ASTON MARTIN DB AR1 Q 2003 Owners Guide

A - Before Driving
1-A-15 Pull upwards on the diagonal belt to ensure secure latching and to remove
all slack from the belt. Finally, double check that the lap belt is fitted snugly,
low down across the hips, and that there are no twists.
If it is necessary for an occupant to adjust their seat or seating position during
a journey, the belt tension might be disturbed. The occupant should
therefore (as soon as it is safe to do so) gently pull down the shoulder run of
the seat belt to create some slack and then immediately release it to re-
tension the belt for the new seating position.
Seat Belt Pretensioner
The seat belt pretensioner system is designed to hold vehicle occupants
against the seat back when a frontal collision occurs.
The seat belt pretensioner system works in conjunction with the airbag
system. In a serious frontal impact, as the airbags are triggered, the
pretensioners will also be triggered. These apply additional tension to the
front seat belts to hold the front seat occupants back in their seats.
Automatic Locking Retractors (ALR)
All vehicles are fitted with an ALR seat belt in the front passenger seat.
This system is designed to securely hold child seats. The ALR system
temporarily locks the belt securing the child seat.
Securing a Child Seat (ALR System)
Fit the child seat following the manufacturers instructions. Gently pull out
the relevant inertia reel seat belt until fully extended. The ALR system will
only engage at the maximum extension point of the seat belt.

A - Before Driving
1-A-18
USE OF CHILD SEATS IN THE EUROPEAN COMMUNITY
WARNING
Child Restraints
Aston Martin has not tested any child restraint systems for this vehicle, and does
not recommend any specific child restraint system.
The following table is supplied under EC Directive 77/541.
Mass Group Seating Position
as indicated on the Front Passenger Second Row *
child safety seat packaging Outboard
0 = Up to 10kg (0-9 months) X X
0+ = Up to 13kg (0-18 months) X X
1 = 9 to 18kg (9 months to 4 years X X
11 & 111 = 15 to 36kg (4 to 12 years) X X
U = Suitable for "universal" category restraints approved for this mass group.
X = Seat position not suitable for children in the mass group.
* = Unsuitable for use with many child restraints due to limited space.
Please consult with local manufacturers of smaller forward facing restraint and
booster cushions. These manufacturers can supply you with advice on the safety
of their particular child restraints, the position that they recommend, and also
advice on fitting instructions.
Do not seat a child aged 12 or younger, or weighing 36 kg or less in the car without
an appropriate child seat or booster cushion. Please confirm that any child seat
or booster cushion you may fit in the vehicle has been designed for use in this
model, and that it conforms to local market requirements.

A - Before Driving
1-A-19
SPECIAL WARNINGS ON USE OF SAFETY RESTRAINTS FOR CHILDREN:
A child, regardless of age, should always be restrained when travelling in a
vehicle. The following precautions are strongly recommended.
Do not allow children to travel in the vehicle without restraint. Approved child
seats or harnesses should always be used.
Each seat belt assembly must be used by only one occupant. It is dangerous to put
a seat belt around a child being carried on the occupants lap.
Child restraint anchorages are designed to withstand only those loads imposed
by correctly fitted child restraints. Under no circumstances are they to be used
for adult seat belts, harnesses or for attaching other items or equipment to the
vehicle
CHILDREN AND THE USE OF CHILD SAFETY SEATS
An infant or child that is not properly restrained can be seriously injured or killed
in a crash. Seat belts are designed for adults and larger children; infants and
smaller children must be restrained in an approved child safety seat.
All child restraint systems are designed to be secured by lap belts, or the lap belt
portion of a lap-shoulder belt. Children could be endangered in a crash if their
child restraints are not properly secured in the vehicle. If you choose to use a
child safety seat, follow the manufacturers instructions. Never hold a baby or
child on your lap while riding in the car.
For use in USA, the child safety seat must be in conformity with Federal Motor
Vehicle Safety Standard 213. Look for the statement on the box and seat.
Check the seat manufacturers instructions for proper use and installation - use
the correct size seat and properly secure the seat in the car in accordance with
the manufacturers instructions. Be sure to read and follow the 'Installation and
Use Instructions' provided with the child seat.
Remember that children who have outgrown child restraints should wear the
vehicle's seat belt.

A - Before Driving
1-A-20
12
SECS
CHILD SEATS AND PASSENGER AIRBAGS
DO NOT install a rearward facing child seat in the front passenger seat position.
If a front seat position must be employed, use only a forward facing child seat
with the passenger seat set as far rearwards as practical.
Airbags
In order to provide optimum occupant protection the DB AR1 is equipped
with a driver airbag mounted in the centre of the steering wheel and front
passenger airbag located in the fascia panel immediately in front of the
passenger seat. The airbags are supplementary to the seat belts.
Note: There are important airbag safety labels on the sun visors (illustrated
below).

A - Before Driving
1-A-21
Some models may have additional safety labels elsewhere, easily visible to the
vehicle occupants. Ensure that you have read and complied with the instructions
on these labels prior to driving the vehicle.
Do not change or modify or tamper with the steering wheel, passenger side
fascia or any other part of the airbag system. Such actions could disable the
system or cause inadvertent inflation.
The airbags are designed to deploy only in a serious frontal collision. Their
purpose is to provide additional protection for the front seat occupants if
thrown forwards in an accident. The system is designed so that it will not
deploy in the event of trivial frontal impacts such as minor contacts when
parking. The airbag system is not designed to protect against side or rear
impacts.
WARNINGS:
No objects whatsoever should be attached to the centre cover of the steering
wheel or the passenger fascia panel. Such objects could cause harm if the vehicle
is in a crash severe enough to cause the airbags to deploy.
All occupants, including the driver, should always wear seat belts, whether or not
an airbag is provided , to decrease the risk of injury or death in the event of a crash
CHILD SEATS AND PASSENGER AIRBAGS
DO NOT install a rearward facing child seat in the front passenger seat position.
If a front seat position must be employed, use only a forward facing child seat
with the passenger seat set as far rearwards as practical.
Any work on the airbag system must only be done by an Aston Martin Dealer.

A - Before Driving
1-A-22
Interior Storage
Door Storage
Open storage pockets are provided below the arm rests in both doors.
Front Armrest Storage
The front armrest lid is lockable.
The boot release switch and the
accessory socket are fitted in the
front armrest storage box.
Rear Storage
A rear storage area is provided
behind the driver and passenger
seats. Tie down straps enable
items to be secured.

F - Owner Maintenance
1-F-24
5. Using the handwheel (A) on the jack screwshaft, raise the jack until the
jack top plate (B) fits to the jacking point stud under the sill at the affected
wheel. Ensure that the jack baseplate is squarely seated on solid ground.
Note: In the following step, the jack handle extension (D) must be used to prevent
damage to the vehicle paintwork as the jack handle (C) is rotated.
6. Ensure the safety of any persons in the vicinity and the security of the
wheel chock. Raise the vehicle as necessary using the jack ratchet handle
(C) and extension (D) to lift the deflated wheel clear of the ground.
Remove the wheel nuts and remove the deflated wheel.
7. Mount the spare wheel on the hub. Reverse the jack ratchet handle on
the extension and partially tighten the wheel nuts.
8. Lower the vehicle to the ground. Tighten the wheel nuts alternately.
Remove the wheel chock.
9. Repack the tools into their location in the boot. Place the defective wheel
into the bag provided and place on the rear seats.
10. When the spare wheel is correctly fitted and secured, drive conservatively
(80 km/h (50 mph) maximum) and have the wheel nuts torque tightened
to 88-102 Nm (65-75 lbs/ft) at the earliest opportunity.
WARNINGS:
Follow the wheel label warnings. Failure to comply can be dangerous. Drive
cautiously and refit a serviceable standard wheel and tyre as soon as possible.
Never fit more than one temporary spare wheel at a time.
Check that the temporary spare tyre is inflated to the specified pressure.
Never exceed 80 km/h (50 mph) when the spare wheel is fitted.

F - Owner Maintenance
1-F-56
Upholstery, Carpets and Seats
The seats and soft trimmed components of DB AR1 are covered in Natural
Leather Hide and Alcantara. The Natural Leather Hide is supplied by Bridge
of Weir, Scotland.
In general, this natural leather upholstery requires little attention. The seats
should be brushed with a soft brush from time to time and may be cleaned
occasionally with a cloth damped in soap and water. DO NOT use
detergents, quick cleansers or furniture polishes.
Several times a year, a leather conditioner or preservative should be used.
Appropriate care materials are contained in the 'Bridge of Weir Leather Care
Kit', obtainable from your Aston Martin Dealer.
Alcantara trim and seat panels may be brushed with a soft brush. Stains from
water based substances such as coffee, tea or soft drinks should be cleaned
as soon as possible with mild soap and water. Please consult your dealer for
instructions on the removal of more difficult stains such as oil, grease or
ballpoint Ink.
Carpets should be cleaned regularly with a vacuum cleaner. Any stains or
grease marks should be removed with a good quality solvent suitable for use
on carpets.
WARNING: Fumes from cleaning solvents may be dangerous in confined spaces.
Make sure that the car is well ventilated and follow the manufacturer's printed
instructions when using these products.

G - Specifications
1-G-7
Exterior Features
Laminated front windscreen with heating element
Heated and electrically operated powerfold rear view door mirrors
Electrically operated door windows
Interior Features
Hand-crafted leather trim
Optional interior trim details: Oak, Elm, Walnut, Maple, Carbon Fibre and
body colour painted
Electrically operated front seats
Air-conditioning
Six speaker stereo radio cassette
CD autochanger
Megamos alarm system interacting with the central locking system
PATs security immobiliser system

Index
5-A-1
Index
A
ABS Warning Light 1-C-22
Adjustments Before Driving 1-A-7
Air Conditioning System 1-D-2
Defrost 1-D-6
Door Mounted Vents 1-D-4
Face Level Vents 1-D-3
Fan Speed Control 1-D-5
Heating/Cooling 1-D-2
Internal Air Flow 1-D-3
Mode Switch 1-D-6
Temperature Control 1-D-5
Temperature Differential Control 1-D-9
Ventilation 1-D-3
Airbags
Child Seats - Passenger Airbags 1-A-20
Alarm
Key Fob 1-A-3
Locking the DB AR1 1-A-4
The Security System 1-A-3
Turning off the Alarm 1-A-4
Turning on the Alarm 1-A-4
Unlocking the DB AR1 1-A-4
Anti-Lock Braking System (ABS) 1-C-21
Ashtray 1-B-22
Automatic Locking Retractors 1-A-15
B
Battery
Battery Conditioner 1-F-33
Battery Disconnect Switch 1-F-32
Electrical Start from Another Vehicle 1-F-36
Quiescent Battery Drain 1-F-31
The Battery Reconnect Switch 1-F-35
Boot (Trunk) Lock Control 1-E-6
Brake System Warning Light 1-C-22
Brake Warning Indications During Driving 1-C-21
Braking Systems 1-C-19
Bulb and Fuse Replacement 1-F-42