buttons AUDI A3 1998 8L / 1.G ATW Engine On Board Diagnostic Workshop Manual

01-12
Depending on desired function Table
"Selectable functions", Page 01
-15
:

- Switch ignition on.
or

- Start engine.

- Press -Print- button to turn on Scan Tool (ST)
printer. Indicator lamp in button must light up.

- Press button 1 to select "Rapid data transfer"
operating mode 1. Rapid data transfer
HELP
Enter address word XX

When indicated on display
Note:
The address word 00 initiates the automatic test sequence, i.e. it results in
a DTC check on all OBD capable systems in the vehicle via rapid data
transfer.
- Press buttons -0- and -1- to select "engine electronics" and press -Q-
button to confirm input.
4B0906018Q
1.8 L R4/5VT
G 0008
Codin
g 07551
WSC 12345

VAG1551 Scan Tool (ST) display indicates control module identification,
e.g.
Pa
ge 14 of 19 On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.1

01-14

Note:

It will be possible to display the control module
identification again after pressing buttons -0-
and -1- to select "Check Control Module
Versions" and confirming with the -Q- button.
Rapid data transfer
HELP
Control module not respondin
g!

- Perform troubleshooting procedure after "troubleshooting procedure leak
test":
Electrical Wiring Diagrams, Troubleshooting & Component Locations
When indicated on display
Rapid data transfer
HELP
K-wire does not switch to Ground

Rapid data transfer
HELP
K-wire does not switch to B+

Rapid data transfer
HELP
Malfunction in communication set-up

Pa
ge 17 of 19 On Board Dia
gnostic
(OBD
)
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.1