height AUDI A3 CABRIOLET 2015 User Guide

....,
N
r--. > co
rl I.O
"' rl
"' rl
-To help prevent injury to yourself and
your passengers:
- Do not raise the vehicle until you are
sure the jack is secu rely engaged.
- Passengers must not remain in the ve­
h icle when it is jacked up.
- Make sure that passengers wait in a
safe place away from the vehicle and
well away from the road and t raffic.
- M ake sure jack position is correct, ad­
just as necessary and then conti nue to
ra ise the jack .
- Changes i n temperature or load can af­
fect the height of the ve hicl e.
CD Note
Do not lift the vehicle by the sill. Pos ition
the vehicle jack only at the des ignated lift­
ing points o n the sill. Othe rwise, your vehi­
cle will be damaged.
Taking the wheel off/installing the spare
Follow these instructions step-by-step for
changing the wheel.
Fi g. 188 Changing a wheel: using the screwdriver han ­
dle (with th e blade re moved} to turn the bolts
F ig . 189 Changing a wheel: alignment pin inside th e
top hole
What do I d o now ? 267
After you have loosened all wheel bo lts and
raised the vehicle off the grou nd, remove and
replace the wheel as follows:
Removing the wheel
.,. Use the hexag onal socket in the scr ewdriv ­
er handle
to completely remove the top ­
most wheel bolt and set it aside on a
clean
surface c:> fig. 188.
.,. Screw the threaded end of the alignment
pin
from the tool kit hand-tight into the
empty bolt hole
c:> fig. 189.
.,. Then remove the other wheel bolts as de­
scribed above.
.,. Tak e off the whee l leaving the a lignment pin
in the bo lt ho le
c:> (D .
Putting on the compact spare wheel
.,. Lift the spare wheel and carefully s lide it
over the alignment pin to guide it in place
c:>(D .
.,. Use the hexagona l socket in the screwdriver
handle to screw in and tig hten all whee l
bolts
slightly.
.,. Remove the a lignment pin and inse rt and
tighten the rema ining whee l bolt slightly
Like the rest .
.,. Turn the jack hand le counter-clockwise to
lower the vehicle until the jack is fully re­
leased .
.,. Use the wheel bo lt wrench to tighten all
wheel bo lts f irmly
c:> page 265 . Tighten
them
crosswise, from o ne bolt to the (ap­
proxima tely) oppo site one, to keep the
wheel cente red.
CD Note
When remov ing or i nsta lling the whee l,
the r im cou ld hit the b rake roto r and dam­
age the ro tor. Wor k carefu lly and have a
second pe rson help you.
(D Tips
Neve r use the hexagonal socket in the han­
d le of the screwdriver to loosen or tighten
the wheel bo lts .
llll-